Comparison of ultrasound and microwave assisted extraction of diosgenin from Trigonella foenum graceum seed

From the recent market trend, there is a huge demand for the bioactive compounds from various food matrices that could be capable enough to combat the emerging health effects in day-to-day life. Fenugreek is a well-known spice from ancient times for its medicinal and health benefits. In the present study, two methods of green extraction microwave (MAE) and ultrasound (UAE) assisted were studied in regard of extraction of fenugreek diosgenin. In this study, solvent type (acetone, ethanol, hexane and petroleum ether), solvent concentration (40, 60, 80 and 100%) and treatment time (1.5, 3.0, 4.5 and 6.0 min and 30, 40, 50 and 60 min for MAE and UAE method respectively) was varied to observe the effect of these parameters over extract yield and diosgenin content. The results of this study revealed that treatment time, type of solvent and its concentration and method adopted for extraction of diosgenin has significant effect. In relation with better yield extract and diosgenin content, the yield of fenugreek seed extract was 7.83% with MAE and 21.48% with UAE of fenugreek seed powder at 80% ethanol concentration at 6 and 60 min respectively. The content of diosgenin was observed in fenugreek seed powder extract was 35.50 mg/100 g in MAE and 40.37 mg/100 g in UAE with 80% ethanol concentration at 6 and 60 min respectively. The overall range of yield of fenugreek extract was varied from 1.04% to 32.48% and diosgenin content was 15.82 mg/100 g to 40.37 mg/100 g of fenugreek seed powder including both extraction methods. This study revealed that UAE would impose better ways for preparing fenugreek extract and observing diosgenin content from fenugreek seeds.     

Influence of ultrasound-assisted tumbling on NaCl transport and the quality of pork

The present study aimed to investigate the impact of ultrasound-assisted tumbling (UAT; 20 kHz, 100, 300, 500 and 700 W) with different treatment time (30, 60, 90 and 120 min) on the diffusion and distribution of NaCl as well as the change of pork texture properties during curing. Results showed that in comparison with the single tumbling (ST), the NaCl content and the NaCl diffusion coefficient were increased along with UAT treatment (P < 0.05). The scanning electron microscopy and the energy dispersive X-ray analysis showed that UAT treatment changed the microstructure of pork which may facilitate the NaCl dispersion homogeneously. In addition, the moderate UAT treatment of 300 W with 60 min could significantly improve the tumbling yield, water-holding capacity and textural properties of pork compared with the ST treatment (P < 0.05). Meanwhile, in comparison with the ST group, protein extraction was considerably increased after UAT (300 and 500 W) treated for 120 min (P < 0.05). Our study demonstrated that UAT treatment could effectively promote the penetration and distribution of NaCl and improve pork meat quality via facilitating the extraction of meat protein.     

Analysis of natural frequency for imaging interface in liquid lens

Transmission beam can be modulated at the liquid–liquid interface inside an electrowetting liquid lens. The fluctuation characteristics of the interface has a decisive effect on the beam modulation. A closed cylinder in capillary constant scale is analyzed and the natural frequencies of a flat interface are obtained using capillary wave hydrodynamics. Results in modes0 and 1 are in good agreement with previous experiments in the literature. The influences of the radius, the height ratio and the height-to-diameter ratio of a liquid lens on the interface eigenfrequencies are analyzed.     

基于多域特征提取和深度学习的声源被动测距*

由于实际海洋环境中存在大量的非高斯噪声,一些基于高斯假设的传统去噪方法在实际海洋环境中性能下降甚至失效。针对非高斯噪声,如α稳定分布噪声、非平稳行船噪声下的脉冲信号的去噪与重构,该文提出一种基于深度学习的方法。去噪模型首先通过学习带噪信号短时傅里叶变换谱与残差谱之间的映射关系以去除环境噪声,之后对去噪信号的时频谱进行逆变换重构脉冲信号。仿真实验结果表明,深度学习模型在非高斯噪声环境下脉冲信号的去噪与重构任务中有着良好的表现,在实测样本上也表现出良好的泛化性,体现了一定的工程应用价值。     

Determination of Chromium (VI) in Airborne Particulate Matter by Electrothermal Atomic Absorption Spectrometry

Hexavalent chromium Cr(VI) is a well-established carcinogen associated with lung, nasal, and sinus cancer. Cr(VI) threshold limit values in workroom air have been recently lowered. Consequently, the currently available analytical methods are insufficiently sensitive or high cost. In this paper, a simple, cost-effective, sensitive, and reproducible method using solid-phase extraction with electrothermal atomic absorption spectrometry for determination of hexavalent chromium in airborne samples is reported. The method validation included selectivity, linearity, accuracy, and precision. Interferences from other ions likely to be present in airborne samples, including trivalent chromium, were tested and selectivity was demonstrated. The detection and quantification limits were, respectively, as low as 0.1 and 0.4?µg?L^?1. The linearity ranged from 0.5 to 50.0?µg?L^?1, with a regression coefficients exceeding 0.998. The extraction recovery exceeded 98%. The developed method was successfully compared with a reference spectrophotometric method. The performances achieved were similar to ion chromatography and high-performance liquid chromatography approaches. The novel method was tested on airborne samples collected from the workplace. The method’s performance suggests that it may be an alternative to high-cost techniques for monitoring occupational exposure to hexavalent chromium.     

Magnetic polyethyleneimine functionalized reduced graphene oxide as a novel magnetic solid-phase extraction adsorbent for the determination of polar acidic herbicides in rice

A novel magnetic polyethyleneimine modified reduced graphene oxide (Fe₃O₄@PEI-RGO) had been fabricated based on a self-assemble approach between positive charged magnetic polyethyleneimine (Fe₃O₄@PEI) and negative charged GO sheets via electrostatic interaction followed by chemical reduction of GO to RGO. The as-prepared Fe₃O₄@PEI-RGO was characterized by transmission electron microscopy (TEM), Fourier transform infrared spectrometry (FT-IR), X-ray diffraction (XRD), thermal gravimetric analyzer (TGA), vibrating sample magnetometer (VSM) and zeta potential analysis, and then was successfully applied to determine four phenoxy acid herbicides and dicamba in rice coupled with high performance liquid chromatography (HPLC). As a surface modifier of RGO, PEI not only effectually affected the surface property of RGO (e.g. zeta potential), but also changed the polarity of RGO and offered anion exchange groups to polar acidic herbicides, which would directly influence the type of adsorbed analytes. Compared with Fe₃O₄@PEI, Fe₃O₄/RGO and Fe₃O₄@PEI-GO, the as-prepared Fe₃O₄@PEI-RGO, integrating the superiority of PEI and RGO, showed higher extraction efficiency for polar acidic herbicides. Besides, the adsorption mechanism was investigated as well. It turned out that electrostatic interaction and π-π interaction were considered to be two major driving force for the adsorption process. Response surface methodology (RSM), a multivariate experimental design technique, was used to optimize experimental parameters affecting the extraction efficiency in detail. Under the optimal conditions, a satisfactory performance was obtained. The calibration curves were linear over the concentration ranging from 2 to 300 ng g⁻¹ with correlation coefficients (r) between 0.9985 and 0.9994. The limits of detection (LODs) were in the range of 0.67–2 ng g⁻¹. The recoveries ranged from 87.41% to 102.52% with relative standard deviations (RSDs) less than 8.94%. Taken together, the proposed method was an efficient pretreatment and enrichment procedure and could be successfully applied for selective extraction and determination of polar acidic herbicides in complex matrices.     

The Coordination Structure of the Extracted Cobalt(II) Complex with a Synergistic Mixture Containing Lix63 and Versatic10

In the present work, the cobalt(II ) synergist complex with isobutyric acid (HL^I ) and 5‐hydroxy‐4‐octanone oxime (HB^I ), which were the corresponding short‐chain analogs of active synergistic mixture of Versatic10 (HL ) and Lix63 (5,8‐diethyl‐7‐hydroxy‐6‐dodecanoneoxime, HB ), was prepared and studied by X‐ray single‐crystal diffraction. The crystal structure of the cobalt(II ) synergistic complex showed that the composition of the complex was Co(HB^I )₂(L^I )₂ with a cis‐form octahedron geometry structure. Both intra and intermolecular hydrogen bonding between the uncoordinated carbonyl oxygen atom of the deprotonated monodentate anionic ligand L^I and the hydrogen atom of the α‐hydroxy or the oxime hydroxyl group of HB^I were observed in the crystal lattice. In order to bridge the gap between the solid‐state structure of the cobalt(II ) synergist complex and the solution structure of the extracted cobalt(II ) complex with the actual synergistic mixture containing Versatic10 and Lix63 in the nonpolar organic phase, both the cobalt(II ) synergistic complex and the extracted cobalt(II ) complex were further investigated by Fourier transform infrared spectroscopy (FT‐IR ) and electrospray ionization mass spectrometry (ESI‐MS ). The results indicated that the extracted cobalt(II ) complex in the nonpolar organic phase might possess a similar coordination structure as that of the cobalt(II ) synergist complex.     

Determination of Polycyclic Aromatic Hydrocarbons in Mosses by Ultrasonic-Assisted Extraction and Gas Chromatography–Tandem Mass Spectrometry

A facile method for the determination of polycyclic aromatic hydrocarbons in mosses is reported using ultrasonic-assisted extraction and gas chromatography–tandem mass spectrometry. The efficiency of ultrasonic-assisted extraction and the reagents was optimized. Tandem mass spectrometry with selective reaction monitoring was used to enhance the selectivity to reduce matrix interferences and simplify the purification protocol. The detection limits were from 0.1 to 2.0?ng/mL. The linear calibration range was two orders of magnitude and the coefficients of linear correlation exceeded 0.9992 for all analytes. The relative standard deviations within 1 day and 3 days were less than 9.0%. Recoveries from 56.8 to 109.0% were obtained in fortified mosses. The rapid, low solvent gas chromatography–tandem mass spectrometry method was used to determine polycyclic aromatic hydrocarbons in mosses.     

Determination of Chlorophenols in Sewage Sludge and Soil by High-Performance Liquid Chromatography–Tandem Mass Spectrometry with Ultrasonic-Assisted and Solid-Phase Extraction

Chlorophenols are a category of toxic pollutants that are ubiquitously present in the environment. This paper presents a reliable and feasible method for the determination of five chlorophenols in sewage sludge and soil using liquid chromatography–tandem mass spectrometry (LC-MS/MS). The pretreatment involved ultrasonic-assisted extraction and solid-phase extraction purification with hydrophilic–lipophilic balance cartridges. LC-MS/MS equipped with an electrospray ionization source operated in negative mode was used for detection, and multitude reaction monitoring mode was applied for data acquisition. The pretreatment and working conditions of LC-MS/MS were optimized to achieve satisfactory results. The intra-batch accuracies were 100.5–113.4% with relative standard deviations?≤?15.6% for the chlorophenols in sewage sludge and 71.3–102.7% with relative standard deviations?≤?14.0% for those in soil. The inter-batch accuracies were 86.1–100.5% (relative standard deviations?≤?33.6%) for sewage sludge samples and 70.5–112.5% (relative standard deviations?≤?28.2%) for soil samples, respectively. This method has been applied to the determination of chlorophenols in sewage sludge of wastewater treatment plants and soil collected from Guangzhou, China. Parachlorophenol, 2,4,6-trichlorophenol, 2,3,4,6-tetrachlorophenol, and pentachlorophenol were detected in some sewage sludge samples, with concentrations from 0.51 to 13.20?ng/g. In addition, parachlorophenol, 2,3,4,6-tetrachlorophenol, and pentachlorophenol were found in all the soil samples with concentrations from 0.33 to 5.21?ng/g. The chromatographic behavior, on-filter adsorption behavior, and the relationship between optimal collision energies and degree of chlorination of the chlorophenols was investigated. This method will be conducive to environmental research focusing on pollution investigation of chlorophenols in the environment.     

Colorimetric determination of Cu2+ in simulated wastewater using naphthalimide-based Schiff base

A new Cu²⁺-selective colorimetric sensor was developed by combining the chromophore 3-hydroxynaphthalimide with diaminomaleonitrile. The sensor showed Cu²⁺-selective colorimetric signaling behavior in dimethylsulfoxide, indicated by a solution color change from yellow to pink, which was readily discernible without any external devices. Practical application of the sensor to the detection of Cu²⁺ in an aqueous solution containing other environmentally relevant metal ions by selective two-phase liquid-liquid extraction with ethyl acetate was possible. Particularly, extractive signaling of Cu²⁺ in simulated semiconductor wastewater with a readily-usable smartphone as a colorimetric data capture and analysis tool was successfully conducted.