HL—1装置中心热区电子热传导初步分析

在电流及温度分布满足“不变性”原理的基础上,本文分析了等离子体中心热区的能量平衡,求出了电子热传导系数,根据实验数据拟合出HL-1装置电子热传导系数的定标关系为X_e=6.8(n_(eq1))~(-1.2)。此关系与其他托卡马克装置的结果类似。     

Design of high-capacity,reversible polymeric adsorbents for acidic gases

Polyethyleneimine (PEIM) samples crosslinked by a commercial epoxy resin (Epon 828) were prepared, and their adsorption capacity for acidic gases was studied. The swelling and deswelling characteristics of the crosslinked samples were also examined as part of this program. Reactivation of these adsorbents could be carried out by heat, or by a combination of heat and treatment in dilute alkalies.     

ESR方法研究高TC氧化物的超导电性

用电子顺磁共振方法研究了一些高温超导氧化物样品的零场非共振吸收信号和正常的ＥＳＲ共振信号。认为这种方法可以作为鉴别样品进入超导态的实验判据之一。利用零场非共振吸收实验给出的下临界磁场Ｈｃ１（Ｔ）很好地遵多Ｈｃ１（Ｔ）＝Ｈｃ１（０）（１－Ｔ＆＾２／Ｔｃ＾２）。     

光辅助超高真空CVD系统制备SiGe异质结双极晶体管研究

介绍了采用紫外光化学汽相淀积(UVCVD)、超高真空化学汽相淀积(UHVCVD)和超低压化学汽相淀积(ULPCVD)技术研制的化学汽相淀积(CVD)工艺系统,简称U³CVD系统.应用该系统,在450℃低温和10^-7Pa超高真空环境下研制出了硅锗(SiGe)材料和硅锗异质结双极晶体管(SiGe HBT)材料.实验表明,该系统制备的SiGe HBT材料性能良好.     

Characterization of ceramic PVD thin films on AZ31 magnesium alloys

Ceramic thin films have been widely used to protect the metal substrate as coatings in the past years. In order to improve the poor corrosion resistance of AZ31 magnesium alloy, the study in this paper used the electron beam evaporation method to prepare ceramic PVD films on its surface with TiO₂ and Al₂O₃ as donors, respectively. Atomic force microscopy (AFM), scanning electron microscope (SEM), energy dispersive X-ray spectrometer (EDS), Auger electron spectroscopy (AES) and X-ray diffraction (XRD) were used to investigate the surface morphology, composition and microstructure of the thin films. Both films deposited on AZ31 took on compact top surface morphologies and grew as amorphous structures on substrate. AES test not only showed that films compositions deviated the standard stoichiometric ratios, but also found that element Mg diffused into films and existed as magnesium oxide in the TiO_x film as well as the AlO_x film. In the electrochemical corrosion test, the AlO_x coating on AZ31 exhibited the largest electrochemical impedance in a 3.5% NaCl solution. But it did not show better corrosion resistance than others for the poorer adhesion. Even if its thickness was small, the TiO_x coating on AZ31 exhibited the best corrosion resistance in this study. According to the observation and analysis, the damage of these films on AZ31 in aggressive solutions was mainly due to the existence of pores, microcracks, vacancies and poor adhesion between coating and substrate.     

Comparison of detection efficiencies of negatively charged gold-alkanethiolate-, gold-sulfur- and gold-clusters in ToF-SIMS

In order to improve quantification of high mass ions, the influence of cluster composition on detection efficiencies has been studied using a TOF-SIMS IV with the extended capability of postaccelerating ions up to 20 keV. In this experimental study, we focus on the comparison of detection efficiencies for three types of negatively charged secondary cluster ions: gold-alkanethiolate-clusters (Au_xM_y), gold-sulfur-clusters (Au_xS_y) and gold-clusters (Au_x). The clusters were sputtered from self-assembled monolayers of hexadecanethiols on gold substrates using 10 keV Ar⁺ primary ions. The detection efficiencies were derived on the basis of a function for the secondary electron yield and a fourth-order approximated Poisson probability distribution for electron propagation and amplification within the microchannel plate.In addition to the well-known dependence of detection efficiencies on ion mass and energy, which has already been studied for positively charged ions, we were able to show a similar behaviour for the investigated negatively charged secondary ions. We have observed major variations among the three types of clusters at similar mass and energy as predicted in a theoretical approach. The observed differences are due to the different composition of the investigated clusters which has a major influence on the kinetic ion induced electron emission within the microchannel plate. For the first time it was possible to experimentally verify these predictions for detection efficiencies.     

Annealing and measurement temperature dependence of W2B5-based rectifying contacts to n-GaN

The thermal stability and measurement temperature dependence of Schottky contact characteristics on n-GaN using a W₂B₅/Ti/Au metallization scheme was studied using current-voltage (I-V), scanning electron microscopy (SEM) and Auger electron spectroscopy (AES) measurements. The elemental profile obtained from samples annealed at 350 °C showed some titanium diffusion into the gold layer but little other difference from the as-deposited wafer. Annealing at 700 °C produced significant diffusion of titanium. The Schottky barrier height increased with anneal temperature up to 200 °C, reaching a maximum value of 0.65 eV, but decreased at higher annealing temperatures. The reverse breakdown voltage from diodes fabricated using the W₂B₅-based contacts showed a similar dependence. The reverse current magnitude was larger than predicted by thermionic emission alone. The barrier height showed only minor changes with measurement temperature up to 150 °C.     

High resolution electronic study of ONO, ONO and ONO: A rovibronic survey covering 11 800-14 380 cm

The 11 800-14 380 cm⁻¹ frequency range has been scanned for rotationally resolved rovibronic transitions in the A²B₂-X²A₁ electronic band system of the symmetric (C_2v) ¹⁶O¹⁴N¹⁶O and ¹⁸O¹⁴N¹⁸O isotopologues and in the corresponding electronic band system of the asymmetric (C_s) ¹⁸O¹⁴N¹⁶O isotopologue. The rotational analysis—reflecting minor differences in mass—in combination with symmetry induced spectral differences allows an identification of 68 ¹⁶O¹⁴N¹⁶O vibronic levels, 26 ¹⁸O¹⁴N¹⁸O vibronic levels and 51 ¹⁸O¹⁴N¹⁶O vibronic levels. The bands are recorded using near infrared fluorescence spectroscopy and a piezo valve based pulsed molecular beam expansion of premixed ¹⁸O₂ and ¹⁴N¹⁶O in Ar. The majority of the observed bands is rotationally assigned and can be identified as transitions starting from the vibrational ground state of one of the isotopologues. Numerous hot bands have also been identified. A comparison of the overall spectroscopic features of C_2v vs. C_s symmetric species provides qualitative information on symmetry dependence of vibronic couplings.     

Slow positron beam study of corrosion-related defects in pure iron

Corrosion-related defects of pure iron were investigated by measuring Doppler broadening energy spectra (DBES) of positron annihilation and positron annihilation lifetime (PAL). Defect profiles of the S-parameter from DBES as a function of positron incident energy up to 30 keV (i.e. ∼1 μm depth) were analyzed. The DBES data show that S-parameter increases as a function of positron incident energy (mean depth) after corrosion, and the increase in the S-parameter is larger near the surface than in the bulk due to corrosion. Furthermore, information on defect size from PAL data as a function of positron incident energy up to 10 keV (i.e. ∼0.2 μm depth) was analyzed. In the two-state trapping model, the lifetime τ₂ = 500 ps is ascribed to annihilation of positrons in voids with a size of the order of nanometer. τ₁, which decreases with depth from the surface to the bulk, is ascribed to the annihilation of positrons in dislocations and three-dimensional vacancy clusters. The corroded samples show a significant increase in τ₁ and the intensity I₂, and near the surface the corroded iron introduces both voids and large-size three-dimensional vacancy clusters. The size of vacancy clusters decreases with depth.     

Nd:LuVO_4晶体的拉曼光谱研究

采用不同的几何配置测量了Nd:LuVO4晶体的室温拉曼光谱,根据群论对称性分类计算了该晶体的红外和拉曼活性振动模并与实验结果做了比较,指认了测定的特征谱线。测量并分析了Nd:LuVO4晶体A1g全对称类的高温拉曼光谱,讨论了拉曼频移随温度变化的关系,认为晶体的热膨胀是引起拉曼频移变化的主要原因。