A comparison of measured room acoustics metrics using a spherical microphone array and conventional methods

The traditional microphone configuration used to measure room impulse responses (IRs) according to ISO 3382:2009 is an omnidirectional and figure-8 microphone pair. IRs measurements were taken in a 2500-seat auditorium to determine how the results from a spherical microphone array (an mh acoustics Eigenmike-em32) compare to those from the traditional microphone setup (a Brüel & Kjær Type-4192 omnidirectional microphone and a Sennheiser MKH30 figure-8 microphone). Measurements were obtained at six receiver locations, with three repetitions each in order to first evaluate repeatability. The metrics considered in this study were: reverberation time (T30), early decay time (EDT), clarity index (C80), strength (G), lateral energy fraction (J_LF) and late lateral energy level (L_J). Before calculating these quantities, the IRs were filtered to equalize the frequency response of the microphones and sound source. For the spherical array measurements, the omnidirectional (monopole) and figure-8 (dipole) patterns were extracted using beamforming. In terms of repeatability, the average standard deviation of the three measurements at each receiver location averaged across all metrics, receivers, and octave bands was found to be 0.01 just noticeable differences (JNDs). The analysis comparing the measurements from the two microphone configurations yielded differences which were less than 1 JND for the majority of metrics, with a few exceptions of EDT and C80 slightly above 1 JND. Based on this case study, these results indicate that spherical microphone arrays can be used to obtain valid room IR measurements, which will allow for the development of new metrics utilizing the higher spatial resolution made possible with spherical arrays.     

Study on an optical system with coherent laser array source and phase optimization in turbulent atmosphere

Model of an optical system with coherent laser array source and the piston phase optimized by the stochastic parallel gradient descent algorithm is established. With this model, theory of beam propagation through the optical system in turbulent atmosphere is analyzed, and the analytical formulas of the beam average intensity along the propagation path are derived. Strehl ratio of the received beam induced by intensity disorderly distribution and power efficiency of the received beam are introduced to evaluate performance of the optical system. Under the H-V 5/7 atmospheric turbulent model, performance of an optical system with determinate parameters was calculated, and the influences of the propagation distance and the laser wavelength were numerically analyzed, respectively.     

Influence of aspect ratio and anisotropy distribution in ordered CoNi nanowire arrays

The size effects on magnetic properties of nanowires arrays were studied varying the nanowires diameter and maintaining the same periodicity among them, for two different nominal compositions of Co and Ni in the alloy form. The competition among magnetocrystalline and shape anisotropies changes drastically from smallest to biggest diameters altering the easy axis direction. In the case of 75% of Co in alloy, experimental values of the effective anisotropy constant (K_eff) vary from positive to negative depending on the diameter, which means a reversal of the easy axis direction. For 50% of Co the shape anisotropy dominates over the magnetocrystalline for all studied diameters.     

Microstructure and magnetic characterization of the Sm-CoMn co-substituted SrCaM hexagonal ferrites

A series of Sm-CoMn substituted hexagonal ferrites with chemical composition of Sr_0.85-xCa_0.15Sm_xFe_12-y(Co_0.5Mn_0.5)_yO₁₉ (0.00?≤?x?≤?0.60, (0.00?≤?y?≤?0.50) were synthesized by the solid-state reaction method. Microstructure and magnetic properties of the hexaferrites have been investigated by the X-ray diffraction, field emission scanning electron microscopy and a permanent magnetic measuring system. A single magnetoplumbite phase is exhibited in the hexaferrites with the substitutiom of Sm (0.00?≤?x?≤?0.12) and CoMn (0.00?≤?y?≤?0.10) contents. For the hexaferrites containing Sm (x?≥?0.24) and CoMn (y?≥?0.20), impurity phases are observed in the structure. The FESEM micrographs exhibit that the hexaferrites with different Sm-CoMn contents have formed hexagonal structures and the grain size of the hexaferrites remains unchanged with increasing Sm-CoMn content. The remanence (B_r), H_k/H_cj ratios, and maximum energy product [(BH)_max] decrease with increasing Sm-CoMn content (0.00?≤?x?≤?0.60, (0.00?≤?y?≤?0.50). Instrinsic coercivity (H_cj) and magnetic induction coercivity (H_cb) increase with increasing Sm-CoMn content (0.00?≤?x?≤?0.12, 0.00?≤?y?≤?0.10), and then decrease with increasing Sm-CoMn content (0.12?≤?x?≤?0.36, 0.10?≤?y?≤?0.30), while for the hexaferrites with Sm (x?≥?0.36) and CoMn (y?≥?0.30), with increasing Sm-CoMn content, H_cj increases and H_cb decreases.     

Development and validation of a RP-HPLC method for Roflumilast and its degradation products

Roflumilast is a phosphodiesterase type 4 inhibitor that is administered orally as a long-term, in the clinical treatment of chronic obstructive pulmonary disease and asthma. Launched in 2010 for the European market, it currently does not have an official monograph. Here, a reproducible gradient RP-HPLC method was developed and validated for the separation and determination of Roflumilast in the presence of its six major degradation products. Separation was performed on a C₁₈ analytical column (250?×?4.6?mm, 5?µm) with a mobile phase-A of ACN and a phase-B of ammonium acetate buffer (5?mM, pH 4.2) containing triethylamine (0.5% v/v). The most effective RP-HPLC gradient program was determined to be 0/80, 35/10, 36/80, 40/80 (time in minutes/% mobile phase-B). The flow rate was 1.0?ml/min and the column temperature was 25°C. The success of separation of the degradation products with different chemical characteristics was obtained by extending the time of the gradient, changing the proportion of the mobile phases and increasing the velocity of the flow. Two detectors were evaluated for the identification of degradation products and Roflumilast: a diode-arrary detector and a charged aerosol detector. The inability of the charged aerosol detector to dectect one of the six degradation products indicated that the method developed with RP-HPLC and the diode-array detector was more suitable for Roflumilast analysis. The method was validated according to specificity, linearity, LOD, LOQ, accuracy, precision and robustness.     

Ultrathin Mn Doped Ni-MOF Nanosheet Array for Highly Capacitive and Stable Asymmetric Supercapacitor

In this study, we demonstrate that an Mn-doped ultrathin Ni-MOF nanosheet array on nickel foam (Mn_0.1-Ni-MOF/NF) serves as a highly capacitive and stable supercapacitor positive electrode. The Mn_0.1-Ni-MOF/NF shows an areal capacity of 6.48 C cm⁻² (specific capacity C: 1178 C g⁻¹) at 2 mA cm⁻² in 6.0 m KOH, outperforming most reported MOF-based materials. More importantly, it possesses excellent cycle stability to maintain 80.6 % capacity after 5000 cycles. An asymmetric supercapacitor device utilizing Mn_0.1-Ni-MOF/NF as the positive electrode and activated carbon as the negative electrode attains a high energy density of 39.6 Wh kg⁻¹ at 143.8 Wkg⁻¹ power density with a capacitance retention of 83.6 % after 5000 cycles.     

Proposition of a compensated pixelwise calibration for photonic infrared cameras and comparison to classic calibration procedures: Case of thermoelastic stress analysis

In this paper, we propose a compensated pixelwise calibration that integrates the effects of the camera housing temperature. The results of this calibration are compared on black body images to classic two points Non Uniformity Correction based calibrations, compensated or not. It is shown that the proposed approach leads to a significant improvement in the thermal resolution with a reduction in the mean error as well as the standard deviation. The approach is finally challenged on a real case measurement focusing on thermoelasticity. The gain in terms of accuracy measurement is highlighted by comparing the proposed calibration to classic calibrations and the scope of interest of this new calibration is discussed.     

字符串匹配算法在DNA序列比对中的应用

高通量测序技术的飞速发展让生物信息领域迎来了大数据时代。新技术在提供海量生物遗传信息的同时,也给分析这些数据带来了新的挑战。DNA序列比对是信息分析流程中的关键步骤,为后续的变异检测提供序列比对信息。2015“深圳杯”数学建模夏令营B题以DNA序列比对为研究课题,希望参赛学生给出序列快速比对的最佳方案。本文简要点评了各参赛队伍的解答情况,然后介绍了现有DNA序列比对软件中用到的算法和数据结构。     

Higher-order Dirac solitons in binary waveguide arrays

We study optical analogues of higher-order Dirac solitons (HODSs) in binary waveguide arrays. Like higher-order solitons obtained from the well-known nonlinear Schrödinger equation governing the pulse propagation in an optical fiber, these HODSs have amplitude profiles which are numerically shown to be periodic over large propagation distances. At the same time, HODSs possess some unique features. Firstly, the period of a HODS depends on its order parameter. Secondly, the discrete nature in binary waveguide arrays imposes the upper limit on the order parameter of HODSs. Thirdly, the order parameter of HODSs can vary continuously in a certain range.     

Microsensor Chip Integrated with Gold Nanoparticles‐Modified Ultramicroelectrode Array for Improved Electroanalytical Measurement of Copper Ions

This paper presents a microsensor chip integrated with a gold nanoparticles‐modified ultramicroelectrode array (UMEA) as the working electrode for the detection of copper ions in water. The microsensor chip was fabricated with Micro‐Electromechanical System technique. Gold nanoparticles were electrodeposited onto the surface of UMEA at a constant potential of ?0.3 V. The ratio d/R_b of interelectrode spacing (d) over the individual electrode’s radius (R_b) was investigated to improve the electrochemical performance. The UMEA with a d/R_b of 20 showed the best hemispherical diffusion mode, resulted in fast response time and high current response. The gold nanoparticles increased the active surface area of UMEA by not changing the geometries of UMEA, and the current response was increased further. Incorporating the optimized characteristic of UMEA and gold nanoparticles, the microsensor showed a good linear range from 0.5 to 200 µg L^?1 of copper ions in the acetate buffer solutions with the method of square wave stripping voltammetry. Compared with the gold nanoparticles‐modified disk electrode, the gold nanoparticles‐modified UMEA showed higher sensitivity (0.024 µA mm^?2 µg^?1 L) and lower limit of detection (0.2 µg L^?1). Water samples from river water and tap water were analyzed by the microsensor chip with recovery ranging from 100.7 % to 107.8 %.