SO2 Resisting Pd-doped Pr1-xCexMnO3 Perovskites for Efficient Denitration at Low Temperature

H₂-SCR is served as the promising technology for the controlling of NO_x emission, and the Pd-based derivative catalyst exhibited high NO_x reduction performance. Effectively regulating the electronic configuration of the active component is favorable to the rational optimization of noble Pd. In this work, a series of Pr_1-xCe_xMn_1-yPd_yO₃@Ni were successfully synthesized and exhibited superior NO conversion efficiency at low temperatures. 92.7 % conversion efficiency was achieved at 200 °C over Pr_0.9Ce_0.1Mn_0.9Pd_0.1O₃@Ni in the presence of 4 % O₂ with a GHSV of 32000 h⁻¹. Meanwhile, the outstanding performance was obtained in the resistance to SO₂ (200 ppm) and H₂O (8 %). Deduced from the results of XRD, Raman, XPS, and H₂-TPR, the modification of d orbit states in palladium was confirmed originating from the incorporation in the B site of Pr_0.9Ce_0.1Mn_0.9Pd_0.1O₃. The existence of higher valence (Pd³⁺ and Pd⁴⁺) than the bivalence in Pr_0.9Ce_0.1Mn_0.9Pd_0.1O₃ catalyst was evidenced by XPS analysis. Our research provides a new sight into the H₂-SCR through the higher utilization of Pd.     

The effect of applied negative bias voltage on the structure of Ti-doped a-C:H films deposited by FCVA

Ti-doped hydrogenated diamond-like carbon (DLC) films were deposited on Si(1 0 0) substrates by a filtered cathodic vacuum arc (FCVA) method using Ar and CH₄ as the feedstock. The composition and microstructure of the films were investigated by Raman spectroscopy, X-ray photoelectron spectroscopy and IR spectroscopy. The internal stress was determined by the radius of curvature technique. The influence of the bias voltage on the microstructure of the as-deposited films was investigated. It was found that the graphite-like bonds was dominated in the Ti-doped DLC film deposited at 0 V bias voltage. When bias voltage was increased to −150 V, more diamond-like bond were produced and the sp³ content in film reached the maximum value, after which it decreased and more graphite-like bonds feature produced with further increase of the negative bias voltage. The compressive internal in the Ti-doped DLC films also exhibited a maximum value at −150 V bias voltage. IR results indicated that CH bonded intensity reduced, and H atoms bonded with C atoms were substituted for the Ti atoms as the negative bias voltage increasing. All the composition and microstructure change can be explained by considering the plasma conditions and the effect of negative bias voltage applied to the substrate.     

Selective etching of ZnTe in HF:H2O2:H2O solution: Interpretation of extended defect‐related etch figures

HF:H₂O₂:H₂O solution (40%wt.HF: 30wt.%H₂O₂: H₂O, 3:2:1 by volume) was used to reveal extended defects (line, face and volume defects) in bulk ZnTe crystals grown from Te solution. The etch patterns were analyzed based on their size, shape and distribution. The etch figures, both in the shape of pits and hillocks with high resolution, show forms controlled by the symmetries of the respective faces were produced. Two different sizes of pits were observed, the larger‐size pits correspond to dislocations penetrating the surface, however, the smaller‐size texture pits are produced on the defect‐free region, which serve as standard pits on respect faces. The face defects, such as grain boundaries, sub‐grain boundaries, dislocation walls, twins and stacking faults, can be all displayed clearly. Another essential feature of the etchant is that, it can effectively dissolve Te‐rich phase (Te inclusion/precipitates), which makes it promising to reveal the shape of this volume defect.     

A Doping Technique that Suppresses Undesirable H2 Evolution Derived from Overall Water Splitting in the Highly Selective Photocatalytic Conversion of CO2 in and by Water

Photocatalytic conversion of CO₂ to reduction products, such as CO, HCOOH, HCHO, CH₃OH, and CH₄, is one of the most attractive propositions for producing green energy by artificial photosynthesis. Herein, we found that Ga₂O₃ photocatalysts exhibit high conversion of CO₂. Doping of Zn species into Ga₂O₃ suppresses the H₂ evolution derived from overall water splitting and, consequently, Zn‐doped, Ag‐modified Ga₂O₃ exhibits higher selectivity toward CO evolution than bare, Ag‐modified Ga₂O₃. We observed stoichiometric amounts of evolved O₂ together with CO. Mass spectrometry clarified that the carbon source of the evolved CO is not the residual carbon species on the photocatalyst surface, but the CO₂ introduced in the gas phase. Doping of the photocatalyst with Zn is expected to ease the adsorption of CO₂ on the catalyst surface.     

Exceedingly Fast Copper(II)‐Promoted ortho CH Trifluoromethylation of Arenes using TMSCF3

The direct ortho‐trifluoromethylation of arenes, including heteroarenes, with TMSCF₃ has been accomplished by a copper(II)‐promoted C? H activation reaction which completes within 30 minutes. Mechanistic investigations are consistent with the involvement of C? H activation, rather than a simple electrophilic aromatic substitution (S_EAr), as the key step.     

A Convenient Photocatalytic Fluorination of Unactivated CH Bonds

Fluorination reactions are essential to modern medicinal chemistry, thus providing a means to block site‐selective metabolic degradation of drugs and access radiotracers for positron emission tomography imaging. Despite current sophistication in fluorination reagents and processes, the fluorination of unactivated C? H bonds remains a significant challenge. Reported herein is a convenient and economic process for direct fluorination of unactivated C? H bonds that exploits the hydrogen abstracting ability of a decatungstate photocatalyst in combination with the mild fluorine atom transfer reagent N‐fluorobenzenesulfonimide. This operationally straightforward reaction provides direct access to a wide range of fluorinated organic molecules, including structurally complex natural products, acyl fluorides, and fluorinated amino acid derivatives.     

Catalytic Cleavage of Ether CO Bonds by Pincer Iridium Complexes

The development of efficient catalytic methods to cleave the relatively unreactive C? O bonds of ethers remains an important challenge in catalysis. Building on our group’s recent work, we report the dehydroaryloxylation of aryl alkyl ethers using pincer iridium catalysts. This method represents a rare fully atom‐economical method for ether C? O bond cleavage.     

Nickel‐Catalyzed C?H Alkylations: Direct Secondary Alkylations and Trifluoroethylations of Arenes

A versatile nickel catalyst allowed for C H alkylations of unactivated arenes with challenging secondary alkyl bromides and chlorides. The high catalytic efficacy also set the stage for direct secondary alkylations of indoles as well as C H trifluoroethylations with ample substrate scope.     

Photochemical Transformations with Iodine Azide after Release from an Ion‐Exchange Resin

This report discloses the photochemical homolytic cleavage of iodine azide after its formation following release from polymer‐bound bisazido iodate(I) anions. A series of radical reactions are reported including the 1,2‐functionlization of alkenes and the unprecedented chemoselective oxidation of secondary alcohols in the presence of primary alcohols.