Dielectric relaxation in a new double perovskite oxide Ho2MgZrO6

A new double perovskite oxide holmium magnesium zirconate Ho₂MgZrO₆ (HMZ) was prepared by solid state reaction technique. The crystal structure has been determined by powder X-ray diffraction which shows monoclinic phase at room temperature with cell parameters a = 9.3028 ± 0.0030 Å, b = 5.2293 ± 0.0008 Å, c = 4.4009 ± 0.0009 Å, β = 103.3746 ± 0.0166°. An analysis of complex permittivity with frequency was carried out assuming a distribution of relaxation times. The frequency dependent electrical data are analyzed in the framework of conductivity and electric modulus formalisms. At the high temperature range, conductivity data satisfy the variable range hopping (VRH) model. In this regime, the conductivity of sample obeys Mott’s T^1/4 law, characteristic of VRH. High temperature data indicates the formation of thermally activated small polarons. The scaling behaviour of imaginary part of electric modulus suggests that the relaxation describes the same mechanism at various temperatures.     

MgO和Fe2O3的添加对GDCSi体系微观结构及电化学性能的影响

采用溶胶凝胶法制备Gd_0.2Ce_0.8O_3-δ +0.05%（质量分数）SiO₂（GDCSi）电解质。在GDCSi体系中加入Fe₂O₃及MgO可达到降低烧结温度的同时提高晶界电导率,并减小杂质SiO₂对氧离子在晶界处传输的阻碍的目的。将MgO和Fe₂O₃单掺杂或双掺杂在GDCSi体系中并对GDCSi基电解质的微观形貌及电性能进行研究。结果表明,所有样品主要由立方萤石结构相组成;物质的量分数4%MgO单掺杂的GDCSi-M、物质的量分数4%Fe₂O₃单掺杂的GDCSi-F以及物质的量分数2%MgO-物质的量分数2%Fe₂O₃共掺杂的GDCSi-MF均可促进GDCSi体系晶粒增长,降低晶粒间孔隙率,提高电解质的相对密度,降低晶粒电阻R_gi、晶界电阻R_gb及总电阻R_t;GDCSi-MF具有最高晶界电导率和总电导率,在400 ℃时GDCSi-MF的晶界电导率σ_gb和总电导率σ_t分别是GDCSi的10.41和1.82倍。     

赶酸对微波消解-氢化物发生-原子荧光法测定谷物中砷元素的影响

在利用氢化物发生-原子荧光分测定谷物类样品中砷元素时,硫脲-抗坏血酸的还原效果会受到硝酸含量的影响,试液中硝酸含量过高,会与硫脲-抗坏血酸溶液发生氧化还原反应,降低其还原效率。本研究通过对赶酸时间和赶酸温度进行试验,获得最佳的赶酸条件,结合微波消解技术,利用氢化物发生-原子荧光光谱法测定谷物中的微量砷,结果表明,谷物中砷浓度与荧光强度呈线性关系,线性方程为 y=0.0028x-0.1728,线性相关系数R2=0.9993,检出限为1.72ng/g。 通过对9份样品进行检测,其相对标准偏差RSD在4.32-7.59%之间,其准确度相对误差RE均小于±6.50%。经多次检测证实该方法较稳定,可用于谷物类样品中砷元素的快速测定。     

The effect of solute on ultrasonic grain refinement of magnesium alloys

An experimental study has been conducted to assess the structural refinement of magnesium and its alloys by ultrasonic irradiation during solidification. It is shown that (i) ultrasonic irradiation leads to significant refinement only in the presence of adequate solute, which is alloy dependent; (ii) the attendant grain density increases linearly with increase in solute content at a given irradiation level; (iii) increasing the solute content at a low irradiation level above the cavitation threshold is more effective than substantially increasing the irradiation intensity; and (iv) the difference in the grain size between two ultrasonicated magnesium alloys is mainly determined by the solute content rather than the irradiation intensity. In view of these, the effect of ultrasonic irradiation on solute redistribution in a solidifying magnesium alloy seems rather limited even at a substantial intensity level such as 1700 W cm⁻². The implications of these findings are discussed and a mechanism is proposed to account for the experimental observations.     

Ce0.8Nd0.2O1.9-La0.95Sr0.05Ga0.9Mg0.1O3-δ固体复合电解质的结构和电性能

采用溶胶-凝胶法分别制备La_0.95Sr_0.05Ga_0.9Mg_0.1O_3-δ (LSGM)和Ce_0.8Nd_0.2O_1.9 (NDC)电解质,并在NDC溶胶中加入0-15% (w,质量分数)的LSGM预烧粉体制得NDC-LSGM复合电解质,研究不同质量比复合电解质的结构和电性能. 采用X射线衍射(XRD)、场发射扫描电子显微镜(FE-SEM)和X能量色散谱仪(EDS)对样品进行结构表征,交流(AC)阻抗谱测试样品导电性能. 结果表明：NDC-LSGM复合体系主要由立方萤石结构相、钙钛矿结构相和杂质相组成;LSGM的添加可促进晶粒的生长,产生大量相界面,清除或降低SiO₂有害影响,明显提高晶界导电性;LSGM质量分数为10%的样品NL10 具有最高晶界电导率和总电导率,400 ℃时NL10 的晶界电导率σ_gb和总电导率σ_t分别为12.15×10^-4和3.49×10^-4 S·cm^-1,与NDC的σ_gb (1.41×10^-4 S·cm^-1)和σ_t (1.20×10^-4 S·cm^-1)相比分别提高了7.62和1.91倍,总电导率的提高主要归因于晶界电导率的影响.     

金属火灾熔痕的显微组织及物相成分的实验研究

利用X-射线衍射(XRD)和3D图像处理软件(Image-pro)研究了四种不同火灾类型金属熔痕的显微组织、平均晶粒度、物相组成及其分布规律。结果表明：金属火灾熔痕主要由立方晶系的Cu₂O和胞、枝状的Cu组成。在四种不同的起火方式下,金属熔痕的显微组织和成分有显著的差别：(1)一次短路的火灾熔痕平均晶粒度为3～5 μm,其Cu₂O含量最低;过载熔痕的平均晶粒度与一次短路的类似,但其Cu₂O含量为30%左右;(2)二次短路熔痕中含有一定数量直径较大的微观空洞,平均晶粒度约为30 μm;其Cu和Cu₂O衍射峰出现展宽和辟裂,烧蚀程度最深;(3)火灾熔痕中粗大的Cu₂O等轴晶衍射峰强度最大,且显微组织中几乎没有微观空洞存在。     

Application of the quartz crystal microbalance for the investigation of nanotribological processes

The electrochemical preparation of copper layers was investigated using a quartz crystal microbalance (QCM) with damping monitoring. The damping increase during the deposition could be separated into two contributions arising from an internal and an external friction process. External friction comes from the coupling of the shear motion of the rough metal surface to the viscous liquid. Internal friction occurred only in the coarse grained layers and can be explained by phonon excitations at the grain boundaries.Presented at the 3rd International Symposium on Electrochemical Processing of Tailored Materials held at the 53rd Annual Meeting of the International Society of Electrochemistry, 15–20 September 2002, Düsseldorf, Germany     

一种新型的卤化银颗粒尺寸和分布测定法-电解还原法及其测定仪

电解还原法是近年来国际上逐步使用的一种新的卤化银颗粒尺寸和分布测定的方法．用此方法,我们研制了我国第一台微机化的测量仪。这台仪器可以测量直径从0.1μm至40μm的所有各种卤化银颗粒,而且全部操作,包括信号的提取、识别、数字化转换以及数据处理都是自动进行。与过去常用的测量方法,如电镜图象分析法、离心沉降法以及激光散射法相比,此方法测量快速,测量精度高并且设备投资少,操作方便．此外,我们还对电解法与电镜法的测试结果作了比较。     

Effect of incorporation of reduced graphene oxide on ZnO-based dye-sensitized solar cells

Here, we demonstrate a facile method to improve the cell performance of ZnO-based dye sensitized solar cell by incorporating different amount of reduced graphene oxide (rGO). Overall photo-to-current conversion-efficiency (PCE) of the device 3 with 0.75 mL rGO exhibits a 1.3 times improvement compared to bare ZnO. The electrochemical impedance spectroscopy (EIS) measurements show that the enhancement could be attributed to the improvement of electron transport/injection and the decrease of the charge recombination in the device, which arise from the formation of rGO-based Schottky junction in ZnO-photoanode.     

Gradient nanoscale polycrystalline elasticity: Intergrain interactions and triple-junction conditions

Using the principle of virtual power, we develop general balance equations, interface conditions, triple-junction conditions, and boundary conditions for second-grade nanocrystalline elastic materials undergoing infinitesimal deformations. We further develop thermodynamically consistent constitutive equations and provide a weak formulation of resulting boundary-value problems that automatically yields internal conditions such those that hold across interfaces and at triple junctions.