GaPO4 high temperature crystal microbalance demonstration up to 720°C

Quartz-homeotypic gallium (ortho-) phosphate, GaPO₄, is of special interest for resonator applications asking for temperature compensated cuts with higher electro-mechanical coupling than quartz and operational temperatures up to 970°C. The crystal microbalance technique, well known for quartz (QCM) which can be used only at moderate temperatures, can now be extended to much higher temperatures using GaPO₄ crystals, benefiting from all three advantages mentioned above. Two different experiments were done to demonstrate the advantages of a crystal microbalance based on GaPO₄. First, the GaPO₄ resonator was used for film thickness determination and compared with a commercial QCM. This experiment demonstrated that the measuring range can be extended by using GaPO₄ resonators instead of quartz. The second experiment demonstrates the possibility for thermogravimetric analysis up to 720°C by using a new concept for resonator mounting.This revised version was published online in November 2005 with corrections to the Cover Date.     

离子选择电极—流动注射分析法动力学测定葡萄糖存在下的果糖

本文将离子电极与流动注射分析相结合，利用３０℃下，在强碱性介质中，果糖和葡萄糖与２，４－二硝基酚钠反应速度明显差异，动力学测定了葡萄糖存在下果糖的含量。自制了２，４－二硝基酚电极作为动力学电位测定用的工作电极。本法测定果糖的范围为０．０２～１．００ｍｏｌ／Ｌ，其ＲＳＤ为４．０％～４．９％，ＲＥ为１．０～５．０％；当Ｃ葡／Ｃ果≤３倍时，葡萄糖的干扰不超过５％；本法也曾成功地用于果葡萄浆测定，其ＲＳＤ     

Optical sensor for carbon dioxide combining colorimetric change of a pH indicator and a reference luminescent dye

A new optical CO₂ sensor based on the luminescence intensity change of the europium(III) complex tris(thenoyltrifluoroacetonato) europium(III) dihydrate ([Eu(tta)₃]) caused by the absorption change of various pH indicators—thymol blue, phenol red, or cresol red—with CO₂ was developed and its CO₂ sensing properties were investigated. For all the CO₂ sensors using pH indicators the observed luminescence intensity from [Eu(tta)₃] at 613 nm increased with increasing CO₂ concentration. The linear calibration method based on the plot of (I₁₀₀–I₀)/(I–I₀) versus the inverse of CO₂ concentration was suggested, where I₀ and I₁₀₀ were luminescence intensities at 613 nm of the CO₂ sensor film in 100% nitrogen and 100% gaseous CO₂. In all cases the plots showed good linearity and the correlation factors of the plots, r², were 0.991 for thymol blue, 0.990 for phenol red, and 0.998 for cresol red. The slopes of the plots (A/B) for thymol blue, phenol red, and cresol red were 2.2, 5.2, and 9.0%, respectively. The response times of the CO₂ sensor film were 4.0 s for thymol blue, 4.4 s for phenol red, and 8.8 s for cresol red for switching from nitrogen to CO₂, and the recovery times of films were 36 s for thymol blue, 39.2 s for phenol red, and 56.6 s for cresol red for switching from CO₂ to nitrogen. The signal changes were fully reversible and hysteresis was not observed during the measurements. The highly sensitive CO₂ sensor was developed using thymol blue as an indicator for the CO₂-sensing probe.     

Bienzymatic analytical microreactors for glucose, lactate, ethanol, galactose and l-amino acid monitoring in cell culture media

A new alternative method for bioprocess monitoring based on bienzymatic analytical microreactors integrated in a flow injection analysis (FIA) system is described. Glucose-, alcohol-, lactate-, galactose- and l-amino acid oxidases (GO, AO, LacO, GalO and LAAO) and horseradish peroxidase (HRP) are immobilized on controlled pore glass (CPG) and used for the development of glucose, ethanol, lactate, galactose and amino acid sensors. The analytical methodology is based on HRP catalysed reaction of hydrogen peroxide produced by oxidases with phenol-4-sulfonic acid and 4-aminoantipyrine. The immobilized enzymes are characterized and used for preparation of the packed bed analytical microreactors. Shelf life and operational stability of the microeactors are determined. GO/HRP, AO/HRP and LAAO/HRP microreactors showed excellent shelf life, they could be stored and reused for more than 6 months with no or very little activity loss, while GalO/HRP and LacO/HRP could be stored for shorter periods of time (10-20 days). Operational stability of GO and LacO microreactors was very good: an equivalent to 16,900 FIA injections of 25 μl to a LacO microreactor resulted in loss of half of its activity, immobilized GO was so stable that it was impossible to evaluate enzyme halflife. Immobilized GalO and LAAO lose their operational activity much faster: approximately 1400 and 8000 FIA injections of the respective substrate solution in a FIA set-up resulted in 50% activity loss. The methods with all the described microreactors were successfully validated using off-line samples from S. cerevisiae, E. coli and mesenchymal stem cell cultures with HPLC as the reference method.     

薄膜荧光传感器研究进展

按薄膜荧光传感器的制备方法, 从物理薄膜、化学薄膜和自组装单层膜等三个方面综述了近年来薄膜荧光传感器的研究进展. 在此基础上, 展望了薄膜荧光传感器的研究前景.     

Purification of a marine bacterial glucose dehydrogenase fromCytophaga marinoflava and its application for measurement of 1,5-anhydro-d-glucitol

A novel glucose dehydrogenase (GDH) from a marine bacteriumCytophaga marinoflava IFO 14170 was isolated from its membrane fraction. This GDH catalyzes the oxidation of a hydroxy group of glucose, but does not react in its C-l position. This enzyme is composed of a single peptide with a mol wt of 67,000. The GDH can react under high salinity. The optimum pH is around 8.0, showing a typical property of marine bacterial enzymes. Using this novel enzyme, an enzymatic determination of 1,5-anhydro-D-glucitol (1,5AG) utilizing 2,6-dichrolophenolindophenol (DCIP) and phenazine methosulfate (PMS) as electron mediators was caried out. A good linear correlation was observed from 0.5 mM to 4 mM of 1,5AG.     

Optical CO(2) sensor of the combination of colorimetric change of alpha-naphtholphthalein in poly(isobutyl methacrylate) and fluorescent porphyrin in polystyrene

An optical CO₂ sensor based on the overlay of the CO₂ induced absorbance change of pH indicator dye α-naphtholphthalein in poly(isobutyl methacrylate) (polyIBM) layer with the fluorescence of tetraphenylporphyrin (TPP) in polystyrene layer is developed. The observed luminescence intensity from TPP at 655 nm increased with increasing the CO₂ concentration. The ratio I₁₀₀/I₀ value of the sensing film consisting of α-naphtholphthalein in polyIBM and TPP in polystyrene layer, where I₀ and I₁₀₀ represent the detected luminescence intensities from a layer exposed to argon and CO₂ saturated conditions, respectively, that the sensitivity of the sensor, is estimated to be 192. The response and recovery times of the sensing film are less than 6.0 s for switching from argon to CO₂, and for switching from CO₂ to argon. The signal changes are fully reversible and no hysterisis is observed during the measurements. The highly sensitive optical CO₂ sensor based on fluorescence intensity changes of TPP due to the absorption change of α-naphtholphthalein in polyIBM layer with CO₂ is achieved.     

四硫富瓦烯为介体的碳纤维束葡萄糖氧化酶微电极的研究

本文研究了一种将电子介体四硫富瓦烯(TTF,Tetrathiafulalene)引入葡萄糖氧化酶微电极的新方法,制成了TTF为介体的碳纤维束葡萄糖氧化酶微电极。该电极制作简单,响应迅速、灵敏,电极寿命可达15天。葡萄糖浓度在1。0×10~(-4)～1.5×10~(-3)mol/L范围内有线性关系。检出限为7×10~(-5)mol/L。用于人体血样中葡萄糖测定获得满意结果。     

High stability amperometric biosensor based on enzyme entrapment in microgels

The preparation and characterization of an amperometric glucose biosensor based on the entrapment of glucose oxidase (GOx) in a polyacrylamide microgel is described. This study proves that polyacrylamide microgels provide an excellent matrix for GOx immobilization that can be used as a biological material in amperometric biosensors. The interference produced by ascorbic and uric acid has been eliminated by including acrylic acid in the polymeric matrix. With this modification, we obtain an adequate device for glucose determination in complex samples such as blood and serum. The study of the temperature effect in the response of biosensors indicates that swelling of the microgels directly influences the enzymatic activity. Thus, the behaviour of the enzyme in the swollen microgels is similar to the enzyme in solution, but the enzyme's activation energy increases when the water content in the microgels decreases. One important property of these biosensors is their remarkable stability. After 4 months of its manufacture, there is no loss in the initial response. Furthermore, the enzymatic activity of freeze-dried microgels containing enzyme remains unaltered for at least 18 months.     

A mini-review on MXenes as versatile substrate for advanced sensors

MXenes have emerged as versatile 2D materials that are already gaining paramount attention in the areas of energy,catalyst,electromagnetic shielding,and sensors.The unique surface chemistry,graphene-like mo rphology,high hydrophilicity,metal-like conductivity with redox capability identifies MXenes,as an ideal material for surface-related applications.This short review summarizes the most recent reports that discuss the potential application of MXenes and their hybrids as a transducer material for advanced sensors.Based on the nature of transducing signals,the discussion is categorized into three sections,which include electrochemical(bio) sensors,gas sensors,and finally,electro-chemiluminescence fluorescent sensors.The review provides a concise summary of all the analytical merits obtained subsequent to the use of MXenes,followed by endeavors that have been made to accentuate the future perspective of MXenes in sensor devices.