Characterization of a Novel Dioxomolybdenum Complex by Cyclic Voltammetry

Metalloenzymes that carry a pterin-based molybdenum cofactor in their center catalyze numerous reactions in the human body and play a crucial role in its metabolism. Specifically, these enzymes promote redox reactions and oxygen transport in the body. Their absence may cause many problems leading to disability or even death in early childhood. Therefore, model compounds need to be synthesized and analyzed to investigate the reactivity, redox potential, and geometry of these cofactors. This study focused on electrode processes and determined the redox potentials of the new bis-(4-mercapto-5-(p-tolyl)-3H-1,2-dithiole-3-thione)-dioxomolybdenum complex by cyclic voltammetry. The 4-mercapto-5-(p-tolyl)-3H-1,2-dithiole-3-thione ligand underwent irreversible oxidation and reduction at thiol and thione functional groups. The new dioxomolybdenum complex showed a quasi-reversible two-stage electrode process.     

Electrocatalytic oxidation of hydrazine at cobalt hexacyanoferrate- modified glassy carbon, Pt and Au electrodes

The electrocatalytic oxidation of hydrazine has been studied on glassy carbon, Pt and Au electrodes modified by cobalt hexacyanoferrate (CoHCF) using cyclic voltammetry and rotating disc techniques. It has been shown that the oxidation of hydrazine to nitrogen occurs at the potential coinciding with that of Co(II) to Co(III) transformation in a CoHCF film, where no oxidation signal is observed at a bare glassy carbon electrode. A Tafel plot, derived from RDE voltammograms, exhibits a slope of 150 mV, indicating a one-electron charge transfer process to be the rate-limiting step. The electrocatalytic efficiency of the modified electrode towards hydrazine oxidation depends on solution pH, and the optimum range was found to be located between pH 5 and pH 7. The kinetic behaviour and location of the electrocatalytic process were examined using the W.J. Albery diagnosis table, and it was concluded that the reaction has either a “surface” or a “layer” reaction mechanism. Pt- and Au-CoHCF-modified electrodes show no significant electrocatalytic activity towards hydrazine oxidation. Received: 25 April 1997 / Accepted: 12 August 1997     

高压下C60晶体玻璃化行为的理论研究

通过构造C_(60)分子间的相互作用，研究了在不同压力下C_(60)晶体中的取向有序结构．利用计算出来的两个取向之间的能量差和相隔势驿，研究了热平衡时取向占有几率和玻璃化转变温度的压力相关性．结果与实验符合．     

A Comparison of Electron Transfer Kinetics of Three Common Carbon Electrode Surfaces in Acetonitrile and in Room Temperature Ionic Liquid 1‐Butyl‐3‐Methylimidiazonium Hexafluorophosphate: Correlation to Surface Structure and the Limit of the Diffusion Domain Approximation

We report the comparison of electron transfer kinetic parameters of the ferrocene redox couple in both acetonitrile and in room temperature ionic liquid (RTIL) 1‐butyl‐3‐methylimidiazonium hexafluorophosphate ([C₄mim] [PF₆]), using edge plane pyrolytic graphite (EPPG), basal plane pyrolytic graphite (BPPG) and glassy carbon (GC) electrodes. Each electrode surface was characterized using SEM and AFM and the surface morphology was analyzed in terms of surface heterogeneity including the distribution of edge plane defects. The experimental data were modeled using both one and two dimensional simulations to correlate the electron transfer parameters obtained with the different surface structure of each electrode. Furthermore, we show that the diffusion domain approximation (commonly used to accurately simulate electron transfer kinetics at graphitic surfaces) breaks down when a BPPG electrode is used in RTIL and demonstrate the near impossibility of assigning rate constant to the basal plane surface.     

Voltammetry of Benzo[a]pyrene in Aqueous and Nonaqueous Media: Adsorptive Stripping Voltammetric Determination at Pencil Graphite Electrode

A detailed study of the electrochemical oxidation of Benzo[a]pyrene (BaP) at the glassy carbon and pencil graphite electrodes was carried out in aqueous and nonaqueous media. Using square‐wave stripping mode, the compound yielded a well‐defined voltammetric response at pencil graphite electrode in acetate buffer, pH 4.8 at +1.13 V (vs. Ag/AgCl) (a preconcentration step being carried out at a fixed potential of +0.70 V for 180 s). The process could be used to determine BaP concentrations in the range 0.25–1.25 μM, with a detection limit of 0.027 μM (6.82 μg L^?1). The applicability to assay of spiked human urine samples was also illustrated.     

Polyethylenimine Functionalized with Dopamine: Characterization and Electrocatalytic Properties

We report the chemical modification of polyethylenimine (PEI) by functionalization with dopamine (Do) using glutaraldehyde (Glu) as a linker (PEI‐Glu‐Do). The new polymer was characterized by FT‐IR spectroscopy, by derivative UV‐vis spectroscopy, and Cyclic Voltammetry. The PEI‐Glu‐Do demonstrated to have an important electrocatalytic activity allowing an important decrease in the overvoltages for the oxidation of NADH and a significant increase in its oxidation peaks currents. Different ratios of PEI:Do were assayed and the best response was obtained using PEI : Glu : Do 1 : 2 : 1. The new polymer represents an interesting and promising alternative for the electrochemical quantification of NADH and other analytes of clinical interest, as well as for the development of new electrochemical (bio)sensors.     

A novel mesogen‐jacketed liquid crystalline electroluminescent polymer with both thiophene and oxadiazole in conjugated side chain

Mesogen‐jacketed liquid crystalline polymers (MJLCPs) with both electron‐transport oxadiazole and hole‐transport thiophene in the side chain were reported for their promising electroluminescent property. Monomers of 2,5‐bis{5‐[(4‐alkoxyphenyl)‐1,3,4‐oxadiazole]thiophen‐2‐yl}styrene (M‐Cm, m is the number of the carbons in the alkoxy groups, m = 8,10) were synthesized and confirmed by ¹H‐NMR, mass spectrometry, and elemental analysis. The corresponding polymers were successfully obtained and characterized by thermal analysis, optical spectroscopy, cyclic voltammetry, electroluminescent analysis, polarized light microscopy (PLM), and wide‐angle X‐ray diffraction (WAXD). The polymers exhibited high decomposition temperatures reaching 382 °C and high T_g's reaching 184 °C. The absorption spectra indicated that both the monomers and polymers had little aggregation in film than that in solution, and the absorption spectra of the polymers showed an obvious blue‐shift compared with those of the monomers. Both the monomers and the polymers had blue‐green emission, and the photoluminescence spectra of the polymers in film suggested the formation of excimer or exciplex. The polymers showed lower HOMO energy levels and LUMO energy levels than those of the MJLCPs containing oxadiazole unit reported before. Electroluminescence study with the device configuration of ITO/PEDOT/PVK/polymer/TPBI/Ca/Ag showed maximum brightness and current efficiency of 541 cd/m² and 0.10 cd/A, which proved that the introduction of directly connected electron‐ and hole‐transport units could greatly improve the EL property of side‐chain conjugated polymers. The phase structures of the polymers were confirmed to be smectic A phase through the results of PLM and WAXD. The annealed samples emitted polarized photoluminescence at room temperature, which indicated potential utility for practical applications in display. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 1502–1515, 2010     

Synthesis and Characterization of Chromium Hexacyanoferrate/Multiwalled Carbon Nanotube Composite and Its Biosensing for L‐Cysteine

This work describes the electrochemical properties of glassy carbon electrodes (GCE) modified with chromium(III) hexacyanoferrate(II) (Crhf) nanoparticles attached multiwalled carbon nanotube (MWNTs). The morphological characterization of Crhf/MWNTs nanocomposites was examined by scanning electron microscopy (SEM), UV‐vis spectroscopy, and Fourier transform infrared spectrometry (FT‐IR). The electrocatalytic activity of these nanocomposites was investigated and showed a good electrocatalytic effect for oxidation of L ‐cysteine (L ‐Cys) in 0.1 M phosphate buffer solution (pH 3.0). Under optimum conditions linear calibration graphs were obtained over the L ‐Cys concentration range 5.0×10^?7 to 6.0×10^?5 M with a correlation coefficient of 0.9998 and a detection limit (signal‐to‐noise ratio was 3) of 1.0×10^?8 M. The proposed method is simple and it also showed excellent sensitivity and stability. The excellent electrocatalytic ability of the modified electrode towards L ‐Cys manifests that the Crhf/MWNTs can provide a new platform for biosensors and other biology.     

Quantification of Quercetin Using Glassy Carbon Electrodes Modified with Multiwalled Carbon Nanotubes Dispersed in Polyethylenimine and Polyacrylic Acid

This work reports the highly sensitive detection of quercetin using glassy carbon electrodes modified with multiwall carbon nanotubes (MWCNT) dispersed in polyethylenimine and poly(acrylic acid). The adsorptive stripping with square wave voltammetric transduction allowed the detection of 7.5 nM quercetin after 1.0 min accumulation at open circuit potential. The amperometric detection at 0.150 V is reported as an easier and simpler alternative to determine quercetin, with detection limits of 0.2 µM. The careful selection of the working conditions also made possible the detection of submicromolar levels of quercetin in the presence of excess of rutin. The proposed methodology was successfully used to quantify quercetin in onion samples.     

Electroanalytical characteristics of antipsychotic drug ziprasidone and its determination in pharmaceuticals and serum samples on solid electrodes

Ziprasidone is a psychotropic agent used for the treatment of schizophrenia. Its oxidation was investigated electrochemically at boron-doped diamond and glassy carbon electrodes using cyclic, differential pulse, and square wave voltammetry. The dependence of the peak current and peak potentials on pH, concentration, nature of the buffer, and scan rate were examined. The process was diffusion and adsorption controlled for boron-doped diamond and glassy carbon electrodes, respectively. The possible mechanism of oxidation was discussed with some model compounds that have indole and piperazine oxidations. A linear response was obtained between 8 × 10⁻⁷ and 8 × 10⁻⁵ M for the first peak in acetate buffer (pH 5.5) and between 2 × 10⁻⁶ and 2 × 10⁻⁴ M for the second peak in 0.1 M H₂SO₄ with boron-doped diamond electrode for differential pulse and square wave voltammetric techniques. The reproducibility and accuracy of the proposed methods were found between 0.31 and 1.20, 99.27 and 100.22, respectively. The recovery studies were also achieved to check selectivity and accuracy of the methods. The proposed methods were applied for the determination of ziprasidone from pharmaceutical dosage forms and human serum samples without any time-consuming extraction, separation, evaporation or adsorption steps prior to drug assay except precipitation of the proteins using acetonitrile. The results were statistically compared with those obtained through an established LC-UV technique, no significant differences were been found between the voltammetric and LC methods.