笼形聚偕胺肟树脂的研究──酸处理树脂吸附H_2PdCl_4

考查了无机酸、羧酸和酚类化合物处理的笼形聚偕胺肟树脂吸附酸性溶液中H_2PdCl_4的能力，其中H_3BO_3/ACAO、HSCH_2CO_2H/ACAO和p－NH_2C_6H_4H/ACAO树脂对H_2PdCl_4的吸附容量分别是2．023、2．368和2．083mmol/g-R或215、252和222mgPd／g－R。优于相同条件下的碱处理树脂（BCAO吸附容量为1．828mmol/g-R）。研究了吸附动力学，讨论了吸附机理。     

Hydrogen Oxidation on a Platinum Microelectrode: Effect of Carbon Monoxide Impurities

The kinetics of the hydrogen oxidation and the CO adsorption on a Pt (ultra)microelectrode is studied in a 0.5 M H₂SO₄ solution saturated with a mixture of gaseous H₂ and CO at partial CO pressures p _CO = 10–500 ppm. The balance between rates of diffusion and adsorption of CO at different adsorption times is studied. Studied is the effect of CO impurities in H₂ on steady-state polarization curves for the hydrogen ionization and nonsteady-state curves of the oxidation current decay with time at 0.02–0.05 V. Conditions under which in a certain time interval and at a certain CO concentration the slope of an I vs. t curve is proportional to p _CO are determined. The obtained dependence may be used when designing a technique for monitoring CO impurities in technical hydrogen.     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

Adsorption Equilibrium and Kinetics of Egg-White Proteins on Immobilized Metal Ion Affinity Gels for Designing Fractionation

Designing an Immobilized Metal ion Affinity (IMA) chromatographic process on large scale demands a thorough understanding to be developed regarding the adsorption behaviour of proteins on metal loaded IMA (IMA-M(II)) gels and the characteristic adsorption parameters to be evaluated. This research investigation illustrates the significance of these aspects for the proposed fractionation of chicken egg-white proteins on these gels. Consequently, a systematic investigation of the adsorption characteristics of three chicken egg-white proteins viz., ovalbumin, conalbumin and lysozyme on Cu(II) and Ni(II) loaded IMA gels, iminodiacetate (IDA) and tris(2-aminoethyl)amine (TREN), has been undertaken. These gels differ in their selectivity towards the proteins of interest under the identical sets of experimental conditions. While TREN-Ni(II) was selective only for lysozyme, IDA-Cu(II), IDA-Ni(II) and TREN-Cu(II) showed varying affinities for all the three proteins. The equilibrium and kinetic data were analysed using various theoretical models and adsorption parameters were quantified. On the basis of these investigations, various strategies have been proposed for the efficient large-scale fractionation of chicken egg-white proteins on these gels.     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…     

磷酸三丁酯增敏极谱法测定铜的研究

在０．００４ｍｏｌ／Ｌ ＨＣｌ－１×１０＾－３ｍｏｌ／Ｌ ＳＣＮ＾－－５×１０＾－５ｍｏｌ／Ｌ磷酸三丁酯（ＴＢＰ）溶液中，Ｃｕ＾２＋可在－０．４２Ｖ（ｖｓ．ＳＣＥ）产生灵敏的极谱波，波高较无ＴＢＰ存在时增加近３倍，二阶导数峰电流与０．００５￣４．０ｍｇ／Ｌ Ｃｕ＾２＋呈线性关系。研究了极谱波性质及增敏机理，表明该极谱波为配合物吸附波，ＴＢＰ起协同吸附作用。本法已用于实际样品分析，结果满意。     

Novel simulated moving-bed adsorber for the fractionation of gas mixtures

The separation of propylene-propane mixture is an energy intensive operation commercially practiced using cryogenic distillation. The separation by pressure swing adsorption has been studied as an alternative. A fixed-bed pressure swing adsorption yields the heavy component as a pure product. The product recovery and the productivity are not high. In a moving-bed process, because of the counter-current solid-gas contact, the separation achieved is similar to that of the fractionation by distillation. Although the moving-bed operation offers the upper limit for the performance of a cyclic adsorptive process, due to mechanical complexities in the handling of solids the 'simulated' moving-bed is preferred. By moving the inlet and outlet ports of streams located along the length of the bed, a moving-bed process can be realized in a fixed bed. We describe here a 'moving-port' system which permits injection or withdrawal of the fluid along the axial direction in a fixed bed. A fixed bed embedded with the moving-port systems emulates a simulated moving-bed adsorber. The proposed adsorber can fractionate a binary gas mixture into two product streams with high purities. It is similar to the Sorbex process of UOP but does not have the eluent as an additional separating agent. A parametric study indicates that high purity products and a higher productivity by an order of magnitude can be achieved with simulated moving-beds compared to the fixed beds.     

Pore size distributions in low‐k dielectric thin films from X‐ray porosimetry

X‐ray reflectivity has been used to determine the mass uptake of probe molecules in porous thin films supported on thick silicon wafers. The adsorption occurs by capillary condensation when the films are exposed to probe vapor at controlled partial vapor pressures. The probe solvent partial pressure was varied by mixing saturated air and dry air at constant temperature or by changing sample temperature at a constant vapor concentration. Pore size distribution in the films can be calculated from the probe uptake with typical porosimetric approaches such as the application of the Kelvin equation to convert partial pressure into pore size. For illustration, the pore size distribution of three different nanoporous thin films, the primary candidate of ultra‐low‐k interlevel dielectrics in the next generation of integrated circuit chips, was determined with this technique. These samples represent different generations of low‐k dielectrics developed by industry. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2170–2177, 2002     

Coupling between polymer adsorption and colloidal particle aggregation

Studies of the adsorption of high molecular weight polymers on colloidal latex and silica particles and their subsequent flocculation were carried out. Neutral polyethylene oxide samples with both a narrow and a broad molecular weight distribution were used together with low charged cationic copolymers. The influence of the particle concentration and polymer dose on the flocculation were systematically investigated under quiescent conditions.Equilibrium bridging only occurred with polyelectrolyte, even in very dilute suspensions, at high particle coverage. In contrast to this, non-equilibrium bridging occurred with both neutral polymer and polyelectrolytes but only for more concentrated suspensions and small amounts of adsorbed polymer. Polymer adsorption in dilute suspensions, which did not show particle aggregation was measured an electrophoretic technique. In more concentrated suspensions, where flocculation takes place, we found that aggregation prevents further polymer adsorption and induces both an excluded volume and a surface effect. The consequences on the shape of the isotherms differ according to the aggregation mechanism.A significant decrease of the amount, , of adsorbed polymer is observed with non-equilibrium bridging. When both mechanisms simultaneously contribute to the aggregation, the value of depends on their relative importance. In the intermediate range of copolymer dose their respective contributions are critically sensitive to the details of the mixing step and stirring, leading to non reproducible experimental results.     

Na2SeO3在Fe电极上还原和吸附机理

采用循环伏安法、恒电势电解法、恒电流阶跃法及交流阻抗法研究Na2SeO3提高锌锰合金电沉积电流效率的作用机理.证明在锌锰合金电沉积的条件下，Na2SeO3 阴极被还原为Se32－并吸附在阴极表面上，从而阻止了氢原子在阴极表面的吸附，因而减少了氢离子的阴极还原.拟定了Na2SeO3的反应和吸附机理，用交流阻抗法进一步证明了所拟机理的正确性.