高压下某些导电高分子色散关系的研究

利用晶格动力学方法,研究在高压下几种导电高分子具有不同晶格链时的色散关系及其曲线的变化.链间耦合作用的减弱使横波与纵波的ω差值相应增大,且在BZ边界处拉开一个间隙,这是维度作用的结果.     

修饰聚合物液-固亲和萃取体系纯化大豆中的组氨酸

聚乙二醇(PEG)6000经亚氨基二乙酸(IDA)修饰后和CuSO4反应,形成PEG修饰聚合物PEG-(IDA-Cu)2 ,与吐温80、磷酸盐混合,构成液-固亲和萃取体系,直接从大豆蛋白匀浆中提取氨基酸.选定萃取条件为磷酸盐摩尔比n(K2HPO4)∶n(NaH2PO4)为4.8∶1,体系pH值 7.70,总盐浓度为1.60 mol·L-1;吐温80的体积分数为10.5%.结果表明该体系对大豆蛋白匀浆中氨基酸的二次萃取率为66.5%,用离子交换技术后继处理,得纯度较高的组氨酸.     

等厚双层涂层材料受集中力作用的平面问题理论解

界面应力的正确评价是分析薄膜涂层材料力学特性的难题之一。利用镜像点法和Dirichlet等值性原理，本文推导了等厚双层薄膜涂层材料受表面集中力作用的平面问题理论解。该显式理论解是以固定在各镜像点上的局部坐标系下的Goursat应力函数的形式给出的。对应于高阶镜像点的应力函数，可通过递推的方法，从对应于低阶镜像点的应力函数求得，而且也易于计算机编程。随着镜像点阶数的增大，它与界面的距离也越来越大，因而相对应的应力函数对界面应力的影响越来越小。最后的算例表明，只需考虑前面有限个镜像点，便可获得足够精度的解。该理论解可作为格林函数，以求解复杂问题的理论解，也可用作边界元法的基本解，提高数值计算的精度和效率。     

X-ray damage characterization in BaLiF3,KMgF3 and LiCaAlF6 complex fluorides

Two-inch sized KMgF₃,BaLiF₃ and LiCaAlF₆ (LiCAF) single crystals were grown by the Czochralski method under a CF₄ atmosphere. X-ray irradiation was used to carry out a comparative study of induced optical absorption phenomena and colour centre creation in the ultra-violet and visible spectral regions. The integral of the induced absorption spectra is significantly lower in LiCAF with respect to the other studied materials. It is found that the amplitude of the F-absorption band is suppressed more than a factor of 3 by Mg-doping. For Mg-doped crystals, the optimum doping concentration is about 0.2 mol% of Mg²⁺.     

Dispersion Characteristics of Waveguide Arrays in Optical Spectrum Analyzers

Formulas for calculating the spectral characteristics of waveguide arrays, which are incorporated into waveguide spectrum analyzers based on planar waveguides, channel waveguides, and fiber optical waveguides, are derived taking into account the contribution of both the waveguide dispersion and the material dispersion to the dispersion factor. These formulas are used to study the dependence of the dispersion factor on the waveguide-system parameters for specific models of waveguide arrays. It is shown that consideration of contributions of the waveguide dispersion and material dispersion can affect profoundly the spectral characteristics of waveguide arrays.     

Hydrogel‐like elastic membrane consisting of semi‐interpenetrating polymer networks based on a phosphorylcholine polymer and a segmented polyurethane

To obtain a hydrogel‐like elastic membrane, we prepared semi‐interpenetrating polymer networks (IPNs) by the radical polymerization of methacrylates such as 2‐methacryloyloxyethyl phosphorylcholine (MPC), 2‐hydroxyethylmethacrylate, and triethyleneglycol dimethacrylate diffused into segmented polyurethane (SPU) membranes swollen with a monomer mixture. The values of Young's modulus for the hydrated semi‐IPN membranes were less than that for an SPU membrane because of higher hydration, but they were much higher than that for a hydrated MPC polymer gel (non‐SPU). According to a thermal analysis, the MPC polymer influenced the segment association of SPU. The diffusion coefficient of 8‐anilino‐1‐naphthalenesulfonic acid sodium salt from the semi‐IPN membrane could be controlled with different MPC unit concentrations in the membrane, and it was about 7 × 10² times higher than that of the SPU membrane. Fibroblast cell adhesion on the semi‐IPN membrane was effectively reduced by the MPC units. We concluded that semi‐IPNs composed of the MPC polymer and SPU may be novel polymer materials possessing attractive mechanical, diffusive‐release, and nonbiofouling properties. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 68–75, 2003     

Measurement uncertainty of selenium determination in the reference material Seronorm Trace Elements Serum by hydride generation atomic fluorescence spectrometry

 An analytical result is not considered to be complete without a statement of the measurement uncertainty associated with it. Evaluation of measurement uncertainty is therefore an essential part of every determination. In the present study the measurement uncertainty of the result of determination of selenium in the reference material Seronorm Trace Elements Serum was studied. The combination of a digestion procedure using sulfuric acid, V₂O₅ in H₂SO₄ and hydrogen peroxide and the continuous flow approach of hydride generation atomic fluorescence spectrometry (HG-AFS) detection was used for selenium determination. The total uncertainty budget was calculated with the help of the GUM Workbench program, in which computations follow the rules of the ’ISO guide to the expression of uncertainty in measurement’. The major sources of uncertainty were found to be due to the recovery of the procedure, measurement of peak heights and the purity of Na₂SeO₃. A selenium mass fraction of 77.1±4.8 ng/g (with a coverage factor of 2.1, 95% probability) was determined, which is comparable with the recommended value of 80 ng/g. Received: 13 September 2002 Accepted: 23 December 2002 Acknowledgements We would like to thank Tinkara Buˇcar, B.Sc. for useful discussions and the IAEA Vienna, for financial support of the project 11553/RO. Presented at CERMM-3, Central European Reference Materials and Measurements Conference: The function of reference materials in the measurement process, May 30–June 1, 2002, Rogaška Slatina, Slovenia Correspondence to V. Stibilj     

Crystallographic report: Crystal structure of a one‐dimensional zinc(II) coordination polymer containing 4,4′‐biphenyldicarboxylate hemihydrate

A one‐dimensional zinc(II) coordination polymer has been constructed from zinc(II), 4,4′‐biphenyldicarboxylate and pyridine in which each zinc(II) atom is coordinated by two pyridine ligands and two monodentate 4,4′‐biphenyldicarboxylate ligands that define a distorted tetrahedral geometry. Copyright © 2003 John Wiley & Sons, Ltd.     

超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯复合材料的输运性质

采用热压法获得了具有不同混合比例的超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯导电复合材料,并利用x射线衍射、扫描电子显微镜和标准四引线方法对复合材料的结构和低温电输运性质进行测量.实验结果显示,超导氧化物La1.85Sr0.15CuO4颗粒随机分布在聚合物本体中,相互间没有连接构成网络结构.在正常态下,复合材料的电阻-温度变化曲线给出类半导体行为.但对应于超导氧化物La1.85Sr0.15CuO4的超导转变温度Tc处,复合材料的电阻-温度变化曲线出现了极小值.室温下电阻率ρ随外加电场强度E的变化曲线测量结果表明,ρ-E曲线为一线形关系,随着电场强度E增加,电阻率ρ下降.文中对可能存在的导电机制进行分析,结果表明隧道贯穿模型可以很好地解释复合材料的导电机制.另外,外加电场强度E对复合材料的电输运特性有明显的影响.     

Photo-orientation at liquid crystal—polymer interfaces

It is suggested that liquid crystal—polymer interfaces are coupled systems, in which the components mutually influence the orientational state of each other. The photo-orientation process at liquid crystal-polymer interfaces provides a striking example of such a coupling. Experiments show that the anisotropic structure generated by polarised light at a polymer surface is strongly affected by the phase of the liquid crystal covering the polymer. Photo-orientation is significantly more efficient when the liquid crystal is in the isotropic phase than when it exhibits orientational order. The observations are interpreted by assuming that in the smectic and nematic phases the liquid crystal stabilises to a large extent polymer chain-segments aligned parallel to the director, while it blocks the photo-induced formation of chain-segments in the perpendicular direction. Other situations, in which the coupling between the liquid crystal and the polymer can be important, are also discussed briefly.