磷脂液相二次离子质谱分析中的分子离子簇

对3种极性头不同的磷脂DMPG、DMPC、DMPE的液相二次离子质谱分析中出现 的分子离子簇现象进行了系统的研究。结果表明，虽然分子离子簇的形成与许多因素有关， 如PH值、离子强度等，但起决定作用的是样品在底物中的浓度，浓度增大有利于分子离子簇 的形成。研究还发现，由不同种类磷脂分子形成的分子离子簇峰明显高于由同种磷脂分子所 形成的分子离子簇峰，指出异种磷脂分子间的簇离子形成能力高于同种磷脂分子。此外还讨 论了磷脂分子在离子源条件下的稳定性、裂解规律及相互作用等。结果表明，本实验所选用 的磷脂分子在LSIMS条件下是稳定的，均能得到较强的分子离子峰，其主要碎片峰是磷酰键断裂而产生的碎片离子峰。     

Facile synthesis of 9-（N-amino-4-fluoromethyl-3-pyrrolidinyl）-2- fluoro-6-aminopurine from trans-4-hydroxy-L-proline

A novel and simple procedure for synthesis of azanucleoside by Mitsunobu reaction between N-(p-nitrobenzyloxycarbonyl)- trans-4-hydroxy-D-proline methyl ester obtained from trans-4-hydroxy-L-proline after six-step reaction and 2-fluoro-6-azidopurine is described,and azanucleoside is fluorinated by new fluridizer 2,2-difluoro-1,3-dimethylimidazolidine (DFI).All reactions could be carded out under mild condition.     

基于MCM-41分子筛表面的镱离子印迹聚合物的制备及其性能

运用离子印迹技术,以3-氯丙基三乙氧基硅烷为锚定剂,将功能单体直链聚乙烯亚胺(PEI)接枝在MCM-41分子筛表面,选择镱离子作为模板离子,以环氧氯丙烷交联制备出基于MCM-41表面的镱离子印迹聚合物Yb(Ⅲ)-IIP-PEI/MCM-41,并以同样的方法制备非离子印迹聚合物(NIP-PEI/MCM-41)。 利用傅里叶变换红外光谱仪和扫描电子显微镜等技术手段对Yb³⁺印迹聚合物进行表征,采用静态吸附法确定了Yb(Ⅲ)-IIP-PEI/MCM-41对Yb³⁺的最佳吸附条件及选择性吸附性能。 结果表明,Yb(Ⅲ)-IIP-PEI/MCM-41和NIP-PEI/MCM-41的最大吸附量分别为229.93和99.27 mg/g;印迹材料对Yb³⁺的吸附符合Langmuir模型;吸附平衡在40 min的时候基本可以达到,可以利用准二级动力学模型来描述其吸附过程;Yb(Ⅲ)-IIP-PEI/MCM-41对Yb³⁺具有较强的选择性,同时也具有很好的重复使用性能。 成功地将MCM-41和离子印迹聚合物的优点结合起来,制备出一种对稀土Yb离子既有高吸附量又有高选择性的吸附材料,为进一步将其应用在处理实际废水,分离回收低浓度稀土废水中的稀土元素等方面打下了基础。     

Effect of Ba and Bi doping on the synthesis and sintering of Ge-based apatite phases

Recently, high oxide ion conduction has been observed in the apatite-type systems La_9.33+x(Si/Ge)₆O_26+x/2, with conductivities approaching and even exceeding that of yttria-stabilized zirconia. The Ge-based phases have been reported to suffer from Ge loss and undergo irreversible structural changes on sintering at the high temperatures required to obtain dense pellets. In this paper we discuss doping studies (Ba, Bi for La) aimed at stabilizing the hexagonal apatite lattice to high temperature, and/or lowering the synthesis and sintering temperatures. The results show that doping with Ba helps to stabilize the hexagonal lattice at high temperatures, although Ge loss appears to still be a problem. Conductivity data show that, as previously reported for the Si-based systems, non-stoichiometry in the form of cation vacancies and/or oxygen excess is required to achieve high oxide ion conduction in these Ge-based systems. Neutron diffraction structural data for the fully stoichiometric phase La₈Ba₂Ge₆O₂₆ shows that the channel oxygen atoms show little anisotropy in their thermal displacement parameters, consistent with the low oxide ion conductivity of this phase. Bi doping is shown to lower the synthesis and sintering temperatures, although the presence of Bi means that these samples are not stable at high temperatures under reducing conditions.Presented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, April 10–12, 2003     

铜离子交换改性的沸石催化剂上甲烷的非氧芳构化

已有研究表明，ＭｏＯ３／ＨＺＳＭ５是甲烷非氧芳构化的优良催化剂，在９７３Ｋ下甲烷转化率达６％～８％，苯选择性高于８０％，这为非氧气氛下甲烷的芳构化反应展示了非常诱人的前景［１～１２］．但是，该催化剂的活性和稳定性尚有待进一步提高，目前已有使用Ｐｔ，...     

Synthesis of macrocyclic tetraamides derived from α-amino acids and their investigations using ESI-MS technique

Chiral α,ω-diesters react under high-pressure conditions (10 kbar) with α,ω-diamines to give chiral cyclic tetraamides of C₂-symmetry. The complexation properties of tetraamides towards alkali metal cations (Li⁺, Na⁺, K⁺, Rb⁺ and Cs⁺) were estimated on the basis of ESI-MS spectra.     

Influence of channeling effects on ion distribution and damage profiles during high energy ion implantation in Si

Nitrogen implantation has been performed in silicon [001] crystals in carefully controlled alignment conditions. The channeling effects are clearly evident when implanting in [001] and [011] directions at energies ranging from 0.6 to 1.4 MeV. Both ion distribution and damage profiles are strongly influenced by channeling effects during ion implantation. The angular region around the [001] direction has been also investigated by implanting at small angles with respect to the axis. The same kind of study has been performed by implanting at different angles with respect to the planar (011) direction. The ion distributions (investigated by SIMS) show a strong dependence upon the alignment conditions. Moreover in high energy ion implantation, the lattice damage is located deep inside the crystal, leaving the surface layer almost unperturbed. The channeling effects on the damage production have been investigated by double crystal diffraction (DCD) in the low-dose regime and by RBS-channeling experiments (after implantation at doses greater than 1 × 10¹⁵ cm^–2) and for different ion alignment conditions.A big increase in the ion ranges and a strong reduction in the lattice damage is evident when implanting along major crystal axes. No saturatíon of the lattice damage and of the channelled component of the beam has been detected if the implantation is performed parallel to the [011] axis.     

Conductance in homomorphous solvents: Tetrabutylammonium salts and alkali picrates in butyrolactone-sulfolane mixtures

Conductance measurements are reported for LiPi, NaPi, KPi, RbPi, CsPi, Bu₄NPi, Bu₄NBr, Bu₄NClO₄, Bu₄NNO₃, and Bu₄NBBu₄ at 25°C in -butyrolactone-sulfolane mixtures. In these mixtures of solvents that are practically homomorphous, isodielectic and with comparable dipole moments, the ion pair association and ionic mobilities of large ions conform to the expectations of the primitive model. Electrolytes containing lithium or sodium ions show anomalies indicating that other factors besides shape, dipole moment, and polarizability of the solvent molecules are involved in the association and transport processes of these ions.     

Er~(3 ),Ho~(3 )和Tm~(3 )在硫氧化钆中的余辉发光

非放射性长余辉磷光粉作为美化和清洁光源在发光陶瓷、交通安全标志、紧急突发事件的照明设施、工艺美术涂料等众多领域得到越来越广泛的应用,引起人们的重视.到目前为止,文献报道的稀土长余辉磷光体的激活离子主要有铕离子(Eu3+和Eu2+[1-4]、三价铈离子(Ce3+)[5]、三价铽离子(Tb3+)[6]、三价镨离子(Pr3+)[7]、三价钐离子(Sm3+)[8].Ho3+,Er3+,Tm3+等稀土离子作为红外上转换发光材料的激活离子[9～12],而关于它们的长余辉发光的报道极少.最近,雷炳富等在Tm3+离子[13]激活的硫氧化钇体系中发现了长余辉发光.在此,我们通过高温固相法合成了Er3+,Ho3+和Tm3+掺杂的硫氧化钆长余辉磷光粉,观察到该体系中迄今未见文献报道的Er3+,Ho3+和Tm3+离子的长余辉发光.     

层状LiMnO_2正极材料的研究进展

层状LiMnO2 化合物的研究是目前锂离子电池正极材料锂锰氧化物研究工作的新热点 ,本文综述了近年来国内外LiMnO2 化合物的研究进展 ,主要阐述了具有层状和扭曲层状结构的m LiMnO2和o LiMnO2 的结构、电性能、合成和改性方法等方面的研究状况 ,重点介绍了离子交换法合成层状LiMnO2 的原因和机理。探索新的合成方法和掺杂其它金属离子改性以提高循环性能是今后LiMnO2 的研究趋势。