停留—催化反应速差动力学法同时测定Fe,Mo

根据Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）对Ｈ２Ｏ２氧化邻氨基酚的催化反应速率不同，结合流动注射停留技术，建立了同时测定Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）的速差动力学分光光度法．测定铁和钼的线性范围分别为０．１～２．５μｇ／ｍＬ和０．５～１５μｇ／ｍＬ．除Ｗ（Ⅵ）的允许量较小外，其它离子不干扰测定．用本法测定了合成样液中铁和钼含量，结果满意．     

过氧化氢与N—甲基苯胺盐酸盐引发体系的研究

在水介质中,研究了新型的过氧化氢/N-甲基苯胺盐酸盐引发体系对 AM 与 PVA 的接枝共聚。产物经紫外光谱、红外光谱和 ~1H-核磁共振进行表征,并提出了引发机理。     

Volumetric properties of the water + ethylenediamine mixture at atmospheric pressure from 288.15 to 353.15 K

Densities of the water + ethylenediamine binary system were measured at atmospheric pressure over the whole range of compositions at temperatures from 288.15 to 353.15 K using an Anton Paar digital vibrating glass tube densimeter. Density increases with water content. The experimental excess molar volume data have been correlated with the Redlich-Kister equation, and partial molar volumes calculated at infinite dilution for each component.     

氯化血红素催化新型荧光反应测定葡萄糖的研究

本文用流动注射分析了研究了过氧化物模拟酶催化过氧新型荧光底物（Ｎ，Ｎ－二氰甲基邻苯二胺，ＤＣＭＯＰＡ）的最优条件。结果表明，该系统可用于定量测定氧化氢及催化氯化血红素的浓度。     

Sequential injection spectrophotometric determination of phenylephrine hydrochloride in pharmaceutical preparations

A fully automated sequential injection spectrophotometric method for the determination of phenylephrine hydrochloride in pharmaceutical preparations is reported. The method is based on the condensation reaction of the analyte with 4-aminoantipyrine in the presence of potassium ferricyanide. The absorbance of the condensation product was monitored at 503 nm. A linear relationship between the relative peak height and concentration was obtained in the range 0.5-17.5 mg l⁻¹. The detection limit (as 3σ value) was 0.09 mg l⁻¹ and repeatability was 0.8 and 0.6% at 2.5 and 5 mg l⁻¹, respectively. Results obtained by this method agreed very well with those obtained by the AOAC official method.     

Determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder by flow injection analysis with spectrophotometric detection

In this work, a flow injection system with spectrophotometric detection was developed for the determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder. Reaction between Quinizarine (1,4-dihydroxyanthraquinone) and Li(I) ion in alkaline medium containing dimethylsulfoxide (DMSO) was explored for this purpose. The flow system was optimized regarding to its chemical (DMSO, Quinizarine and NaOH concentrations and sample pH) and physical parameters (sample loop volume, carrier flow rate and reactor length) in order to establish better conditions in terms of sensitivity and sampling frequency. The results obtained showed that the concentration of DMSO in the reagent solution presents remarkable influence on the magnitude of analytical signal. Chemical species that could be found in the formulations such as Na(I), K(I), Mg(II), Ca(II), Ti(IV), Cl⁻, CO₃²⁻ e sodium dodecylsulfate were tested as possible interfering ions. Among them, only non-monovalent cations presented noticeable interference on lithium signal. However, they were not found in concentrations high enough to cause interference in the determination of lithium in the samples. Sample preparation was performed by sonicating a slurry prepared by dispersing 100 mg of powdered sample in 15 mL of 0.10 mol L⁻¹ HCl solution. Results obtained by developed methodology were not statistically different from those obtained by flame emission spectrometry. In the optimized conditions the method presented a linear range of 5-40 mg L⁻¹ and a relative standard deviation of 3.6% at 5 mg L⁻¹ Li concentration. Detection and quantification limits were 0.54 and 1.8 mg L⁻¹, respectively. Sampling frequency, calculated as the time interval passed between two consecutive injections, was 60 samples per hour. The methodology was successfully applied in the determination of lithium in three commercial samples.     

A parallel implementation of the COLUMBUS multireference configuration interaction program

Summary In this work a parallel implementation of the COLUMBUS MRSDCI program system is presented. A coarse grain parallelization approach using message passing via the portable toolkit TCGMSG is used. The program is very well portable and runs on shared memory machines like the Cray Y-MP, Alliant FX/2800 or Convex C2 and on distributed memory machines like the iPSC/860. Further implementations on a network of workstations and on the Intel Touchstone Delta are in progress. Overall, results are quite satisfactory considering the complexity and the prodigious requirements, especially the I/O bandwidth, of MRCI programs in general. For our largest test case we obtain a speedup of a factor of 7.2 on an eight processor Cray Y-MP for that section of the program (hamiltonian matrix times trial vector product) which has been parallelized. The speedup for one complete diagonalization iteration amounts to 5.9. An absolute speed close to 1 GFLOPS is found. Results for the iPSC/860 show that ordinary disk I/O is certainly not sufficient in order to guarantee a satisfactory performance. As a solution for that problem, the implementation of a fully asynchronous distributed-memory model for certain data files is in preparation. On leave from: Bereich Informatik, Universität Leipzig, Augustusplatz 10/11, O-7010 Leipzig, Germany     

Anomalies of the partition coefficient and properties of crystals in the region of low concentrations of an isomorphous admixture. 1. Unusual decomposition of solid solutions of the NaCl—CdCl2 system

Solid solutions NaCl—CdCl₂ were studied in an interval of CdCl₂ concentrations of 0.05—3 mol.% by Raman spectroscopy. The molecular form Na₂CdCl₄ decomposes: Na₂CdCl₄ 2Na⁺ + Cd²⁺ + 2Cl₂ ^– + 2e^–; 2Na + 2e^– 2Na⁰. Free sodium atoms form color centers of crystal (F centers) in the region of jumpwise changing the partition coefficient of CdCl₂ in NaCl (K jump).     

Thermodynamique des melanges binaires LiPO3-Pb(PO3)2: Diagramme de phases et étude thermodynamique du liquide

Study of solid-liquid phase diagram of LiPO₃-Pb(PO₃)₂ binary system, in certain calcination conditions, shows the existence of several metastable phasis. When heated at a temperature of 723 K the binary mixtures lead uncompletely to a defined compound Pb₂Li(PO₃). On heating these ternary solid mixtures, three eutectic reactions have been observed: LiPO₃+Pb(PO₃)₂→Liquid at a temperature of 793 K(1) LiPO₃+Pb₂Li(PO₃)₅→Liquid at a temperature of 843 K (2) Pb₂Li(PO₃)₅+Pb(PO₃)₂→Liquid at a temperature of 891 K (3) The metastable liquid phase appears in the system at temperature of 793 K. DTA experiments performed on the binary LiPO₃-Pb(PO₃)₂ mixtures, show a superposition of two diagrams. The first one is metastable and the second represents the stable equilibrium phase diagram. Measurements of liquid enthalpy of binary LiPO₃-Pb(PO₃)₂ system at temperature of 979.65 K were reported. The corresponding values were very small and so the binary system can be considered as athermal. Assuming an ideal behaviour, the liquidus curves in the metastable diagram were calculated and the eutectic reaction (LiPO₃-Pb(PO₃)₂→Liquid) was confirmed at 793 K. This revised version was published online in August 2006 with corrections to the Cover Date.