锑化镓的光助微刻蚀及其表面氧化物的研究

用电化学和光电化学方法研究锑化镓表面的腐蚀以及锑化镓表面氧化膜的生成和溶解，锑化镓电极在一定电势下生成的氧化膜，用俄歇能谱证明，其主要成分为难溶的氧化锑，此氧化膜的存在抑制了锑化镓的进一步腐蚀，同时亦使锑化镓的半导体光电化学性能大为减弱，通过激光微刻蚀及电子显微镜的观察，在刻蚀剂中添加酒石酸，柠檬酸和氢氟酸等试剂，可使刻蚀形得改善，实验研究了锑化镓的平带电势的测定。     

MH—Ni电池封口化成及其性能

在硼氢化钾碱性溶液中对金属氢化物（ＭＨ）电极的表面进行化学还原处理，提高了ＭＨ电极的放电容量、活化性能和电催化活性．用其为负极组装的ＡＡ型ＭＨ－Ｎｉ电池进行了封口化成，电池放电容量达到１１５０ｍＡｈ，５Ｃ下电池的放电容量达到０．２Ｃ下容量的８０％以上，电池在１Ｃ１００％ＤＯＤ（放电深度）充放电条件下，循环寿命由原来的１００次左右提高到２００次以上     

血红素LB膜的电化学行为

采用循环伏安法研究了血红素与脑磷脂混合Y型LB（Langmuir-Blodgett）膜在玻碳电极上的电化学行为，结果表明血红素LB膜有良好的电化学活性，在0．1mol/L KCl溶液中有一对氧化还原峰（－0．42V／－0．30V）；将血红素LB膜转移到玻碳电极表面得到的血红素LB膜修饰电极（heme LB-GC）对溶液中溶解氧的电化学还原有良好的催化作用，其催化还原过程具有不可逆电荷传递特性。     

Inorganic—Organic Hybrid 18—Molybdodiphosphate Nanoparticles Bullk—modified Carbon Paste Electrode and Its Electrocatalysis

A kind of inorganic‐organic hybrid 18‐molybdodiphosphate nanoparticles ([(C₄H₉)₄N]₆P₂Mo₁₈Q₆₂·4H₂O) was firstly used as a bulk‐modifier to fabricate a three‐dimensional chemically modified carbon paste electrode (CPE) by direct mixing. The electrochemical behavior of the solid nanoparticles dispersed in the CPE in acidic aqueous solution was characterized by cyclic and square‐wave voltammetry. The hybrid 18‐molybdodiphosphate nanoparticles bulk‐modified CPE (MNP‐CPE) displayed a high electrocatalytic activity towards the reduction of nitrite, bromate and hydrogen peroxide. The remarkable advantages of the MNP‐CPE over the traditional polyoxometalates‐modified electrodes are their excellent reproducibility of surface‐renewal and high stability owing to the insolubility of the hybrid 18‐molybdodiphosphate nanoparticles.     

铁电极上硫脲及衍生物的缓蚀作用研究

用极化曲线方法测定了硫酸溶液中硫脲及其衍生物的浓度变化对铁腐蚀电化学行为的影响，获得了腐蚀电位下缓蚀剂对阴极和阳极过程的作用系数，用ＥＨＭＯ方法对硫脲及其衍生物的结构参数进行了量化计算，分析表明，缓蚀剂对阴极和阳极过程作用系数的大小与这些参量有密切关系。     

Study of Factors Affecting the Performance of Voltammetric Copper Sensors Based on Gly‐Gly‐His Modified Glassy Carbon and Gold Electrodes

This paper reports a study of the factors affecting the analytical performance of gold and glassy carbon electrodes modified with the tripeptide Gly‐Gly‐His for the detection of copper ions. Gly‐Gly‐His is attached to a glassy carbon (GC) surface modified with 4‐carboxyphenyl moieties or a gold surface modified with 3‐mercaptopropionic acid by the reaction of the N‐terminal amine group of the peptide with the carboxylic acid groups of the monolayer via carbodiimide activation. X‐ray photoelectron spectroscopy was used to characterize the steps in the biosensor fabrication. It was found that the analytical performance of a sensor prepared with Gly‐Gly‐His on a GC electrode was similar to that on a gold electrode under the same conditions. The performance was greatly enhanced at higher temperature, no added salt during copper accumulation and longer accumulation time within a pH range of 7–9. Interference studies and investigations of stability of the Gly‐Gly‐His sensor are reported. Analysis of natural water samples show that the sensors measure only copper ions that can complex at the sensor surface. Strongly complexed copper in natural water is not measured. Despite greater stability of diazonium salt derived monolayers on carbon surfaces compared with alkanethiols self‐assembled monolayers on gold, the stability of the sensors was essentially the same regardless of the modification procedure.     

纳米CoHCF修饰电极的制备及其对血红蛋白的电化学测定研究

A cobalt hexacyanoferrate （CoHCF） nanoparticle （size ca. 60 nm） chemically modified electrode （CME） was fabricated and the electrochemical behavior of hemoglobin （Hb） at this nanosized CoHCF CME was studied. In comparison with a bare glassy carbon electrode （GCE） and a general CoHCF CME electrodeposited in a traditional manner, the present nanosized CoHCF CME performed efficiently electrocatalytic reduction for Hb with relatively high sensitivity, stability, and longlife, Combined with liquid chromatography （LC）, the nanosized CoHCF CME was used as the electrochemical detector of Hb in the established flow injection analysis-electrochemical determination （FIA-ECD） system. The peak current was a linear function of concentrations in the range from 2.5×10^-8 to 5.0×10^-6mol/L for Hb, with detection limit of 1.4×10^-8 mol/L. The FIA-ECD system has been successfully applied to assess the Hb content of clinic blood samples with advantages of sensitiveness, speediness, easy control and small sample-consumption.     

Determination of dopamine in synthetic cerebrospinal fluid by SWV with a graphite–polyurethane composite electrode

This work describes an electroanalytical investigation of dopamine using cyclic voltammetry (CV) and the graphite–polyurethane composite electrode (GPU). In CV studies, well-defined redox peaks characterize the oxidation process at the GPU electrode, which is indicative of electrocatalytic effects associated with active sites on the GPU electrode surface. A new analytical methodology was developed using the GPU electrode and square wave voltammetry (SWV) in BR buffer solution (0.1 mol L^–1; pH 7.4). Analytical curves were constructed under optimized conditions (f=60s^–1, E_a=50 mV, E_I=2 mV) and detection and quantification limits of 6.4×10^–8 mol L^–1 (12.1 g L^–1) and 5.2×10^–6 mol L^–1 (0.9 mg L^–1), respectively, were achieved. The precision of the method was checked by performing ten successive measurements for a 9.9×10^–6 mol L^–1 dopamine solution. For intra-assay and inter-assay precisions, the relative standard deviations were 1.9 and 2.3%, respectively. In order to evaluate the developed methodology, the determination of dopamine was performed with good sensitivity and selectivity, without the interference of ascorbic acid in synthetic cerebrospinal fluid, which indicates that the new methodology enables reliable analysis of dopamine.     

碱性溶液中金电极上氧还原中间物研究

应用改进了的旋转全电极上的电势阶跃计时库仑法,分别测定了不同电极电势下氧还原过程中电极吸附中间物和溶解中间物氧化所需的电量,实验证明,在此过程中电极上确有吸附中间物存在,而且是电极电势的函数,但其分子属性尚需进一步鉴别。