CuI/Al双层电极的有机场效应晶体管

制备了CuI/Al为源极和漏电极的并五苯基场效应晶体管.相对于纯金属(Al, Au)电极的晶体管,所研制的晶体管的迁移率、阈值电压VT、开关电流比I_on/I_off等参数都有明显改善.研究发现,在Al电极与并五苯半导体之间引入CuI作为空穴注入层,能够明显降低Al电极与并五苯之间的空穴注入势垒.紫外-可见光谱和X射线光电子能谱数据表明,这种空穴注入势垒的降低源自并五苯和Al向CuI的电子转移. 关键词： 有机场效应晶体管 CuI/Al双层源漏电极 电子转移     

反相电极聚合物定向耦合电光开关的优化设计

为了消除单节电极定向耦合电光开关的工艺误差对器件性能的不良影响,应用耦合模理论、电光调制理论、保角变换及镜像法,优化设计了一种两节交替反相电极聚合物定向耦合电光开关.模拟结果表明,该器件具有良好的开关性能:在1 550 nm的工作波长下,器件耦合区的长度为4 753.5 μm,交叉态电压为1.22 V,直通态电压为2.65 V,插入损耗小于2.21 dB,串扰小于-30 dB.通过微调状态电压,可以很容易地消除工艺误差对器件性能产生的不良影响.本文方法的设计结果与光束传播法的仿真结果符合得很好.     

Device for aeration and mixing of cell and organelle suspensions during NMR experiments

A device for aeration and mixing of cell or organelle suspensions in a vertical bore NMR magnet is described. Multiple external sensors (e.g., ion-selective electrodes) may be immersed in the suspension within the bore of the magnet. The sensors are positioned to avoid noise due to contact with gas bubbles and proximity to the probe head. The required sample volume is minimised. The modular design of components permits the use of the device in magnets of various internal dimensions, or with probe heads of different sample tube diameter, by modification of the simpler components of the assembly.     

Electrochemical, morphological and microstructural characterization of carbon film resistor electrodes for application in electrochemical sensors

The electrochemical and microstructural properties of carbon film electrodes made from carbon film electrical resistors of 1.5, 15, 140 Ω and 2.0 kΩ nominal resistance have been investigated before and after electrochemical pre-treatment at +0.9 V vs SCE, in order to assess the potential use of these carbon film electrodes as electrochemical sensors and as substrates for sensors and biosensors. The results obtained are compared with those at electrodes made from previously investigated 2 Ω carbon film resistors. Cyclic voltammetry was performed in acetate buffer and phosphate buffer saline electrolytes and the kinetic parameters of the model redox system Fe(CN)₆^3−/4− obtained. The 1.5 Ω resistor electrodes show the best properties for sensor development with wide potential windows, similar electrochemical behaviour to those of 2 Ω and close-to-reversible kinetic parameters after electrochemical pre-treatment. The 15 and 140 Ω resistor electrodes show wide potential windows although with slower kinetics, whereas the 2.0 kΩ resistor electrodes show poor cyclic voltammetric profiles even after pre-treatment. Electrochemical impedance spectroscopy related these findings to the interfacial properties of the electrodes. Microstructural and morphological studies were carried out using contact mode Atomic Force Microscopy (AFM), Confocal Raman spectroscopy and X-ray diffraction. AFM showed more homogeneity of the films with lower nominal resistances, related to better electrochemical characteristics. X-ray diffraction and Confocal Raman spectroscopy indicate the existence of a graphitic structure in the carbon films.     

衬底加热和电极修饰对提高有机场效应晶体管性能的影响

通过衬底加热和氧化钼(MoO3)修饰源漏极制备了并五苯有机场效应晶体管.研究了衬底温度和电极修饰层厚度对器件性能的影响.实验结果表明:当衬底温度为60℃、MoO3修饰层为10 nm时,器件性能获得了显著增强,场效应迁移率由原来的3.39×10-3 cm2/(V·s)提高到2.25 ×10-1 cm2/(V·s),阈值电压由12 V降低到3V.器件性能的改善归因于:衬底加热可以优化有源层形貌,改善载流子传输;而MoO3修饰层显著降低了电极与有源层之间的接触势垒,提高了载流子的注入.因此,衬底加热与电极修饰对于制备高性能有机场效应晶体管是不可或缺的优化手段.     

Skin-effect analysis of a shielded polymer Y-fed coupler electro-optic modulator over a wide bandwidth of 94 GHz

A novel technique and related formulations are proposed for analyzing the influences of the skin-effect on the performances of a polymer Y-fed coupler electro-optic modulator with shielded push-pull micro-strip electrodes. Using the extended point-matching method, coupled mode theory and electro-optic modulation theory, thorough design and optimization are performed. By introducing the effective applied voltage, formulas of the high-frequency response under skin-effect are deduced, and characteristics under skin-effect are analyzed. Under the central wavelength of 1550 nm, the half-wave voltage is as low as 1.097 V for the device with an active region length about 8.884 mm. Considering the influences of the skin-effect, the 3-dB modulating bandwidth of the microwave signal is up to 94 GHz. A high extinction ratio of more than 20 dB and a low insertion loss of less than 4.18 dB are achieved when the microwave frequency is below 68 GHz under skin-effect. This design technique is proven to be accurate by the comparison with the beam propagation method (BPM).     

Theory of discharge sectionalized along a gas flow

ＴｈｅｏｒｙｏｆｄｉｓｃｈａｒｇｅｓｅｃｔｉｏｎａｌｉｚｅｄａｌｏｎｇａｇａｓｆｌｏｗＣＨＥＮＴａｏ；ＱＩＵＪｕｎｌｉｎ（ＬａｓｅｒＩｎｓｔｉｔｕｔｅｏｆＨｕａｚｈｏｎｇＵｎｉｖｅｒｓｉｔｙｏｆＳｃｉｅｎｃｅ＆Ｔｅｃｈｎｏｌｏｇｙ，ｍａｈａｎ４３００...     

Plasma of Electric Arc Discharge between Melted Electrodes

Plasma of electric arc discharge between melted electrodes was experimentally investigated. Diagnostics of electric arc plasma was carried out. Optical emission and absorption spectroscopy was used to obtain radial profiles of temperature, electron density and neutral atoms concentration. The influence of electrode condition on plasma parameters was evaluated. It was found that the copper vapour in plasma tends to be located at the arc axis.     

合肥光源储存环的离子俘获与直流离子清洗

研究了合肥光源(HLS)电子储存环中离子产生、俘获的过程,离子对束流的影响,直流离子清洗的作用及清洗效果.为光源的高效率的运行提供了理论指导及实验依据.