Liquid–liquid microextraction and spectrophotometric determination of anionic surfactants using Astra Phloxine FF

A novel and simple procedure for determination of anionic surfactants has been developed. The method is based on the reaction of sodium dodecyl sulphate (SDS) with Astra Phloxine FF reagent at pH 3–8, followed by liquid–liquid microextraction of the formed ion associate into an organic phase containing a mixture of carbon tetrachloride and dichloroethane (4:1, v/v) and subsequent UV-Vis detection at 555 nm. The calibration plot was linear in the range 0.006–0.29 mg L^?1 of SDS. The limit of detection (LOD), calculated based on 3s, is 0.002 mg L^?1. The method was applied to the determination of anionic surfactants in real wastewater samples.     

Deep eutectic solvent based magnetic nanofluid in the development of stir bar sorptive dispersive microextraction: An efficient hyphenated sample preparation for ultra‐trace nitroaromatic explosives extraction in wastewater

A deep eutectic solvent based magnetic nanofluid was coupled with stir bar sorptive dispersive microextraction as a hyphenated sample preparation technique. The neodymium core magnetic stir bar was coated physically with nanofluid of magnetic carbon nanotube nanocomposites and deep eutectic solvents. The prepared nanofluid has magnetic and strong sorbing properties and is compatible with gas chromatography. In this nanofluid, the deep eutectic solvent acts simultaneously as both carrier and stabilizer for magnetic nanotubes. The predominant experimental variables affecting the extraction efficiency of nitroaromatic compounds were evaluated. Under the optimized conditions, the limit of detection and enrichment factor were in the range of 0.2–4.9 ng/L and 852–1480, respectively. The relative standard deviations were between 5.6 and 10.2% (n  = 6). Method validation was performed by both spiking–recovery method and comparison of results with other methods. Finally, the proposed method was successfully applied for the extraction and pre‐concentration of nitroaromatic explosives in water samples, followed by determination by gas chromatography with micro‐electron capture detection.     

Ru0.7Si0.3O2/Ti电极电催化氧化处理硝基苯废水

制备了Ru0.7Si0.3O2/Ti电极,并以该电极作为氧化阳极,不锈钢为阴极,电催化氧化降解废水中硝基苯。 实验结果表明,当硝基苯初始质量浓度为220 mg/L时,最佳条件为：电流密度25×10-3 A/cm2;Na2SO4作为电解质时加入量为8 g/L;溶液初始pH=2。 在此最佳条件下,硝基苯去除率大于85%,TOC去除率大于50%,表明Ru0.7Si0.3O2/Ti阳极能有效去除废水中有机污染物;对中间产物的检测结果表明,硝基苯的降解是阴阳两极协同作用的结果。     

丙烯腈废水中有机物的高压放电法降解机理

利用气相色谱-质谱探讨了丙烯腈废水中有机物的高压放电法降解机理.结果表明:丙烯腈的氰基首先被破坏生成丙烯酸,丙烯酸进一步被氧化生成乙酸,乙酸降解为甲酸,最后生成CO2.丁二腈首先降解为丁二酸,丁二酸再生成丙酸,并逐步降解为乙酸、甲酸,最后生成CO2.二氰乙基胺在降解过程中依次生成丙腈、丙酸、乙酸和甲酸,最后生成CO2....     

催化湿式氧化中铜基催化剂的流失与控制

 制备了催化湿式氧化处理有机废水用铜基催化剂，并用XRD，XRF和TG－DTG等手段对催化剂进行了表征，对催化剂及其前驱体的组成和结构进行了分析鉴定．结果表明，由类水滑石结构的前驱体焙烧得到的催化剂Cu－Al－Zn－O，其活性组分铜的流失得到了控制；在氧化降解苯酚、十二烷基苯磺酸钠和磺基水杨酸时，在初始氧分压0．5MPa和160～220℃的反应条件下，催化剂活性组分铜的流失量小于0．3mg／L．对催化剂活性组分不易流失的原因进行了理论解释和计算．     

水淬渣-累托石颗粒吸附材料的制备及应用

研究了水淬渣-累托石颗粒吸附材料制备工艺条件、再生方法及其去除铜冶炼工业废水中重金属的条件.试验结果表明,累托石与水淬渣的比例为1∶1,另加入10%的添加剂(IS)和50%的水,焙烧温度为400℃时,制成的颗粒吸附材料体积密度为1.06kg/m3,显气孔率为62.29%,吸水率为58.82%,抗压强度为2.22Mpa,吸附效果好,散失率较低.在未调节铜冶炼工业废水pH值的条件下,颗粒吸附材料用量为0.05g/cm3,反应时间为40min,吸附温度为25℃(常温)时,Cu2 、Pb2 、Zn2 、Cd2 、Ni2 的去除率分别为98.2%、96.3%、78.6%、86.2%、64.2%,处理后的水符合国家污水综合排放标准(GB8978-1996)一级标准.颗粒吸附材料对Zn2 、Cu2 有很好的选择性.吸附饱和的颗粒吸附材料用1mol/L氯化钠溶液再生效果好.该颗粒吸附材料具有分离容易、可重复使用、处理效果好、应用前景广阔的优点.     

Macro-Reticular Ion Exchange Resins for Recovery of Direct Dyes from Spent Dyeing and Soaping Liquors

Dyes are a major class of organic pollutants that are well-known for their harmful impact on aquatic life and humans. Several new strategies for removing colours from industrial and residential effluents have recently emerged, with adsorption being the best option. The current study looked at the recovery of direct dyes from aqueous streams for reuse using macro-reticular ion exchange resins (IERs). The investigation includes dyeing single jersey cotton grey textiles with direct dyes from the Isma dye Company in Kafr El Dawar, Egypt. After centrifuging and separating the supernatant liquid, solutions from thirteen different dyes, produced at an average concentration between the wasted and soaping liquor concentrations, were calculated spectrophotometrically from the first dyeing trials. Kinetic data were well fitted with pseudo-second-order rate kinetics. The amounts of dye retained by the anion exchangers increased with a rise in temperature in the case of Strong Base Resin (SBR) and vice versa for Weak Base Resin (WBR). Batch adsorption experiments with SBR and WBR were conducted for each dye, and both Freundlich and Langmuir isotherms were constructed. It was found that adsorption obeyed both isotherms, that monolayer adsorption took place, and that the dye molecular weight, structure, and solubility, as well as the type of anionic resin used, had varying effects on the extent of absorption. The monolayer sorption capacities Q₀ determined from the Langmuir isotherm model for the strongly and weakly basic anion exchangers were found to be 537.6 and 692 mg/g for Direct Yellow RL, respectively. As a result, Yellow RL exhibited the greatest adsorption on both SBR and WBR. Orange GRLL, Blue 3B, and Congo Red, on the other hand, were the poorest colours absorbed by the IERs, whereas Blue RL demonstrated good adsorption by SBR and accelerated adsorption by WBR. Most of the dyes may be recovered and reused in this manner.     

铁炭微电解-亚铁还原氧化法处理花菁废水的研究

研究了微电解-亚铁还原氧化法在处理花菁废水上的应用,结果显示,经过处理,废水色度的去除率>97%,化学需氧量(COD)的去除率>90%.研究了影响处理效果的因素,对于废水中有机物的去除、脱色以及废水可生化性的提高进行了探讨,并通过紫外-可见光谱和色质联用(GC/MS)对处理前后的废水组分进行了分析.     

傅里叶变换近红外光谱仪在酒醅分析中的应用

傅里叶变换近红外光谱分析技术用于酒醅中水分、酸度、淀粉和残糖的分析，方法分析速度快、操作简单，其分析的准确度满足酿酒工业的要求，是值得推广的一种实用技术。     

甲醇生产主精馏塔的模拟计算

对甲醇精馏主塔进行了模拟计算，并以一实际生产装置沿塔身的温度与浓度分布进行了验证。结果表明，水和甲醇的平均偏差为０．９％，微量杂质，不计丁基油，平均偏差为４９ｐｐｍ，温度平均偏差为２．９℃。说明本计算方法及采用的模型参数是可靠的，可用于工程计算。本文进一步指出，为降低废水中醇类含量，较理想的方法是选择合适的精甲醇与丁基油的采出量。