The interfacial conformation of polypropylene glycols and foam behaviour

The foam behaviour of low molecular weight polypropylene glycols (PPG) was investigated as a function of concentration and molecular weight (190–2000 g mol⁻¹). For each polypropylene glycol, foam stability increases with concentration and passes through a maximum, beyond which foamability is suppressed as the solubility limit of the glycol is exceeded and droplets of glycol form. Light-scattering data as well as static and dynamic surface tension results provide the key information leading to these interpretations. A maximum in foamability was observed for the PPG molecules with increasing molecular weight (caused by a change in molecular conformation at the interface). This suppresses the Marangoni effect and leads to a decrease in foam stability.     

Study on the Superhydrophilicity of the SiO2-TiO2 Thin Films Prepared by Sol-Gel Method at Room Temperature

Nanoscale SiO₂-TiO₂ composite thin films with the thickness of about 100 nm were prepared by sol-gel method at room temperature in air. The chemical states of the elements on the surface and near the surface were measured by XPS. The results showed that the Ti on/near the surface of the thin films existed not only as TiO₂ but also as Ti₂O₃. Part of the TiO₂ was changed to Ti₂O₃ after UV irradiation. The crystalline structure of the TiO₂ in the SiO₂-TiO₂ thin films was anatase with the crystallite size of 14–20 nm. It was found that the thin film prepared at room temperature in air has good superhydrophilic property and has strong adherence to the substrate.     

Electrospinning of ultrafine cellulose acetate fibers: Studies of a new solvent system and deacetylation of ultrafine cellulose acetate fibers

Electrospinning of cellulose acetate (CA) in a new solvent system and the deacetylation of the resulting ultrafine CA fibers were investigated. Ultrafine CA fibers (∼2.3 μm) were successfully prepared via electrospinning of CA in a mixed solvent of acetone/water at water contents of 10–15 wt %, and more ultrafine CA fibers (0.46 μm) were produced under basic pH conditions. Ultrafine cellulose fibers were regenerated from the homogeneous deacetylation of ultrafine CA fibers in KOH/ethanol. It was very rapid and completed within 20 min. The crystal structure, thermal properties, and morphology of ultrafine CA fibers were changed according to the degree of deacetylation, finally to those of pure cellulose, but the nonwoven fibrous mat structure was maintained. The activation energy for the deacetylation of ultrafine CA fibers was 10.3 kcal/mol. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 5–11, 2004     

Statistical thermodynamics evaluation of polymer–polymer miscibility

The Simha and Somcynsky (S–S) statistical thermodynamics theory was used to compute the solubility parameters as a function of temperature and pressure [δ = δ(T, P)], for a series of polymer melts. The characteristic scaling parameters required for this task, P*, T*, and V*, were extracted from the pressure–temperature–volume (PVT) data. To determine the potential polymer–polymer miscibility, the dependence of δ versus T (at ambient pressure) was computed for 17 polymers. Close proximity of the δ versus T curves for four miscible polymer pairs: PPE/PS, PS/PVME, and PC/PMMA signaled the usefulness of this approach. It is noteworthy, that the tabulated solubility parameters (derived from the solution data under ambient conditions) propounded the immiscibility of the PVC/PVAc pair. The computed values of δ also suggested miscibility for polymer pairs of unknown miscibility, namely PPE/PVC, PPE/PVAc, and PET/PSF. In recognizing the limitations of the solubility parameter approach (the omission of several thermodynamic contributions), these preliminary results are auspicious because they indicate a new route for estimating the miscibility of any polymeric material at a given temperature and pressure. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2909–2915, 2004     

聚乙烯基咔唑与Alq3混合薄膜的发光性能与能量传递过程

研究了Alq3与聚乙烯基咔唑(PVK)按不同比例的混合体系制备的薄膜的发光特性.通过对混合薄膜的吸收光谱、激发光谱和发射光谱的分析，研究了PVK与Alq3之间的 能量传递规律.当Alq3与PVK的质量比为1∶7时，能量传递效率最高.用一个由单链模 型扩展到包括杂质的哈密顿量对实验进行模拟，发现该模型能够较好地解释有关的实验结果. 关键词： 吸收光谱 激发光谱 发射光谱 能量传递     

有源光放大器链路中交叉相位调制的不稳定性

利用两种方法研究了有源放大器波分复用系统光纤链路中交叉 相位调制的不稳定性．首先利用非线性薛定谔耦合方程，在小幅度扰动下，研究了正常色散 和反常色散光纤中的交叉相位调制不稳定性. 由于相位噪声涨落，利用分裂步长傅里叶 变换法与Monte-Carlo法，模拟了有源放大器链路中反常色散和正常色散情况下的调制不稳定性. 两种方法得到的结论基本一致. 关键词： 调制不稳定性 交叉相位调制 斯托克斯带 反斯托克斯 带     

Theoretical Study on the Long-lived Complexes for the Na＋I2 Collision System

For the Na I2 collision system, theoretical study is performed on the QCISD(T) level by using ab initio method. The ab initio potential energy surfaces are got and on them the long-lived complexes are found and optimized. These results verify the crossed molecule beam experimental phenomenon and the detailed geometry structures are given for the first time. The role of the complexes in the reaction path is also described in detail.     

Kinetic Parameters of Ion-Exchange Membrane in Amino Acid Solutions

Kinetic parameters of amino acid cations in an MK-40 ion-exchange membrane are calculated from the conductivity data. A theoretical quantum-chemical analysis of experimental activation energies for conduction suggests a mechanism of elementary act of transport of amino acid cations in the membrane.     

A relaxed model and its homogenization for nematic liquid crystals in composite materials

We analyse a model for equilibrium configurations of composite systems of nematic liquid crystal with polymer inclusions, in the presence of an external magnetic field. We assume that the system has a periodic structure, and consider the relaxed problem on the unit length constraint of the nematic director field. The relaxation of the Oseen–Frank energy functional is carried out by including bulk as well as surface energy penalty terms, rendering the problem fully non‐linear. We employ two‐scale convergence methods to obtain effective configurations of the system, as the size of the polymeric inclusions tends to zero. We discuss the minimizers of the effective energies for, both, the constrained as well as the unconstrained models. Copyright © 2004 John Wiley & Sons, Ltd.     

Low‐gain adaptive stabilization of semilinear second‐order hyperbolic systems

In this paper low‐gain adaptive stabilization of undamped semilinear second‐order hyperbolic systems is considered in the case where the input and output operators are collocated. The linearized systems have an infinite number of poles and zeros on the imaginary axis. The adaptive stabilizer is constructed by a low‐gain adaptive velocity feedback. The closed‐loop system is governed by a non‐linear evolution equation. First, the well‐posedness of the closed‐loop system is shown. Next, an energy‐like function and a multiplier function are introduced and the exponential stability of the closed‐loop system is analysed. Some examples are given to illustrate the theory. Copyright © 2004 John Wiley & Sons, Ltd.