Critical exponent for semilinear damped wave equations in the N-dimensional half space

We generalize a previous result of Ikehata (Math. Methods Appl. Sci., in press), which studies the critical exponent problem of a semilinear damped wave equation in the one-dimensional half space, to the general N-dimensional half space case. That is to say, one can show the small data global existence of solutions of a mixed problem for the equation u_tt−Δu+u_t=|u|^p with the power p satisfying p∗(N)=1+2/(N+1)<p?N/[N−2]+ if we deal with the problem in the N-dimensional half space.     

Stress and heat flux stabilization for viscous compressible medium equations with a nonmonotone state function

We study a system of quasilinear equations describing one-dimensional flow of a viscous compressible heat-conducting medium with a nonmonotone state function and mass force. The large-time behavior of solutions is considered for arbitrarily large initial data. In spite of possible nonuniqueness and discontinuity of the stationary solution, we prove L²-stabilization for the stress and heat flux as t → ∞ along with corresponding global energy estimates for them. The new method of proof utilizes a combination of energy type equalities for the stress and heat flux. Consequently, H¹-stabilization of the velocity and temperature along with global estimates for their derivatives are valid as well.     

Experimental Evaluation of Strain Shielding in Distal Femur in Revision TKA

Theoretical concerns about the use of cemented and press-fit stems in revision total knee arthroplasty (TKA) include stress shielding with adverse effects on prosthesis fixation. Radiological studies have showed distal femoral bone resorption after revision TKA. The revision with use of stems can place abnormal stresses. These stresses can promote the effect of bone stress shielding and may contribute to bone loss. Experimental quantification of strain shielding in the distal synthetic femur following TKA is the main purpose of the present study. Three different constructs of TKA were assessed. The first construct included a stemless femoral component. The other two included a press-fit and a cemented femoral stem. Cortical bone strains were measured experimentally with tri-axial strain gauges in synthetic femurs before and after in-vitro knee surgery. The difference between principal strains of implanted and intact femur was calculated for each strain gauge position. This study indicates that the use of stems in distal femur changes the distribution and magnitude of bone strains. The press-fit stem provoked relevant bone area (stem length) subjected to strain shielding and also originated the highest reduction of strains in the distal region, which can potentially induce bone resorption. The stemless implanted femur produced minor bone strain changes relatively to the intact femur. The use of distal femur stems increases initial stability in the bone, but the observed reduction of strains in this region, relative to the intact femur, provokes strain shielding that can induce bone resorption and may compromise the long term implant stability.     

Effect of Pressure on Fluid Damping in MEMS Torsional Resonators with Flow Ranging from Continuum to Molecular Regime

High quality factor of dynamic structures at micro and nano scale is exploited in various applications of micro electro-mechanical systems (MEMS) and nano electro-mechanical system. The quality factor of such devices can be very high in vacuum. However, when vacuum is not desirable or not possible, the tiny structures must vibrate in air or some other gas at pressure levels that may vary from atmospheric to low vacuum. The interaction of the surrounding fluid with the vibrating structure leads to dissipation, thus bringing down the quality factor. Depending on the ambient fluid pressure or the gap between the vibrating and the fixed structure, the fluid motion can range from continuum flow to molecular flow giving a wide range of dissipation. The relevant fluid flow characteristics are determined by the Knudsen number which is the ratio of the mean free path of the gas molecule to the characteristic flow length of the device. This number is very small for continuum flow and reasonably big for molecular flow. In this paper, we study the effect of fluid pressure on the quality factor by carrying out experiments on a MEMS device that consists of a double gimbaled torsional resonator. Such devices are commonly used in optical cross-connects and switches. We only vary fluid pressure to make the Knudsen number go through the entire range of continuum flow, slip flow, transition flow, and molecular flow. We experimentally determine the quality factor of the torsional resonator at different air pressures ranging from 760 Torr to 0.001 Torr. The variation of this pressure over six orders of magnitude ensures required rarefaction to range over all flow conditions. Finally, we get the variation of quality factor with pressure. The result indicates that the quality factor, Q, follows a power law, Q ∝P ^–r , with different values of the exponent r in different flow regimes. In the second part of the paper, we propose the use of effective viscosity for considering velocity slip conditions in solving Navier–Stokes equation numerically. This concept is validated with analytical results for a simple case and then compared with the experimental results presented in this paper. The study shows that the effective viscosity concept can be used effectively even for the molecular regime if the air-gap to length ratio is sufficiently small (h ₀/L<0.01). As this ratio increases, the range of validity decreases.     

Analysis of nine rhubarb anthraquinones and bianthrones by micellar electrokinetic chromatography using experimental design

An efficient micellar electrokinetic chromatography (MEKC) method has been developed for the analysis of nine anthraquinones and bianthrones in rhubarb. A chemometric approach was used to search for the optimum conditions of separation. Those factors which were found to be significant with a screening design were further optimized with a central composite face-centered (CCF) design. Acetonitrile concentration was found to be the most influential, not only in resolution, but also in analysis time and peak asymmetry. With the optimized conditions: 15 mM sodium tetraborate/15 mM sodium dihydrogenphosphate buffer, 30 mM sodium deoxycholate, pH 8.6, 17 vol.% acetonitrile and 28 kV, nine tested analytes were baseline-separated within 14 min. The method was validated to analyze the rhubarb material. Solid-phase extraction (SPE) was manipulated to remove interfering substances. Five anthraquinones and two glycosidic bianthrones were detected and quantificated. The method should be suitable for determining these major active principles in rhubarb crude drugs.     

Baseline studies of radon/thoron concentration levels in and around the Lambapur and Peddagattu areas in Nalgonda district, Andhra Pradesh, India

Studies conducted by Atomic Minerals Directorate of Exploration and Research (AMD) of Hyderabad, India had established the presence of higher concentrations of uranium in Lambapur and Peddagattu areas of Nalgonda district, AP, India and it was estimated that it could be a viable source for commercial extraction. The envisaged extraction process involves dispersion of radioactive particulate matter into atmosphere. Environmental radioactive studies in and around proposed mining areas at this point of time will be extremely useful for establishing base line data before a large scale uranium extraction process comes into existence. To this end, Solid State Nuclear Track Detectors were installed to evaluate indoor radon and thoron concentration levels in the dwellings of the area. The geometric means of radon and thoron concentration levels were found to be (7.1±0.2)×10¹ and (6.7±0.3)×10¹ Bq/m³, respectively. Simultaneously, natural background radiation measurements were also made and these levels are found to vary from 770 to 3995 μGy/y in the spatial distribution.     

无失效数据的Bayes和多层Bayes分析

本文推广了文献[6]的结果，对指数分布无失效数据的失效率，给出了Bayes估计、Bayes置信上限以及多层Bayes估计，从而可以得到无失效数据可靠度的估计，最后，结合实际问题进行了计算。     

Use of dynamic trees in a network simplex algorithm for the maximum flow problem

Goldfarb and Hao (1990) have proposed a pivot rule for the primal network simplex algorithm that will solve a maximum flow problem on ann-vertex,m-arc network in at mostnm pivots and O(n ² m) time. In this paper we describe how to extend the dynamic tree data structure of Sleator and Tarjan (1983, 1985) to reduce the running time of this algorithm to O(nm logn). This bound is less than a logarithmic factor larger than those of the fastest known algorithms for the problem. Our extension of dynamic trees is interesting in its own right and may well have additional applications.Research partially supported by a Presidential Young Investigator Award from the National Science Foundation, Grant No. CCR-8858097, an IBM Faculty Development Award, and AT&T Bell Laboratories.Research partially supported by the Office of Naval Research, Contract No. N00014-87-K-0467.Research partially supported by the National Science Foundation, Grant No. DCR-8605961, and the Office of Naval Research, Contract No. N00014-87-K-0467.     

Extension of multivariate regression trees to interval data. Application to electricity load profiling

Summary  Several data can be presented as interval curves where intervals reflect a within variability. In particular, this representation is well adapted for load profiles, which depict the electricity consumption of a class of customers. Electricity load profiling consists in assigning a daily load curve to a customer based on their characteristics such as energy requirement. Within the load profiling scope, this paper investigates the extension of multivariate regression trees to the case of interval dependent (or response) variables. The tree method aims at setting up simultaneously load profiles and their assignment rules based on independent variables. The extension of multivariate regression trees to interval responses is detailed and a global approach is defined. It consists in a first stage of a dimension reduction of the interval response variables. Thereafter, the extension of the tree method is applied to the first principal interval components. Outputs are the classes of the interval curves where each class is characterized both by an interval load profile (e.g. the class prototype) and an assignment rule based on the independent variables.     

随机删失场合半参数回归模型参数估计的重对数律‘

本文探讨了随机删失场合半参数回归模型的参数估计问题.考虑半参数回归模型Y =X}}3 + g(T)十。，其中(X,T)’为取值于Kp X [0,1〕上的随机向量，月为1'维未知参数向量，8为定义于【0.1]上的未知函数，。为随机误差，Ee = 0 . Eez = az }。未知，且(X ,T)与。独立，).被一个与之独立的随机变量V所截.此时仅能观察到:Z=min(Y,V),o=1(Y簇V)，参数I3,az的估计量禽及公 z可综合非参数的权函数估计法与参数的最小二乘估计方法得到.本文对核函数的情形得到了念及ar z的精确收敛速度即重对数律.