Development of an Amperometric Sensor Highly Selective For Dopamine and Analogous Compounds Determination Using Bis(2,2′‐Bipyridil) Copper(II) Chloride Complex

The use of [Cu(bipy)₂]Cl₂?6H₂O as a biomimetic catalyst in the construction of an amperometric sensor for dopamine determination is reported. The sensor was prepared modifying a glassy carbon electrode with a Nafion membrane doped with [Cu(bipy)₂]Cl₂?6H₂O complex. The sensor presented a higher response in 0.25 mol L^?1 phosphate buffer solution (pH 7.0), with an applied potential of ?50 mV (vs. SCE). In the optimized operational conditions, a linear response range between 35 and 240 μmol L^?1, with a sensitivity of 2.02±0.07 nA l μmoL^?1 cm^?2 and detection limit of 8.0 μmol L^?1 were typically observed for the sensor. The response time presented for this sensor was 0.5 s, presenting the same response for at least 40 successive measurements, with good repeatability (3.0%) expressed as relative standard deviation for n=6. The difference of the response between four sensor preparations was 4%. A detailed investigation about the sensor response for other sixteen phenolic compounds and interfering species were carried out. The sensor was applied in the determination of dopamine in pharmaceutical preparation with success.     

The structure of fullerene films and their metallocene doping

Hexagonal close-packed (HCP) C₆₀ and C₇₀ films have been prepared by the Langmuir method and examined by electron microscopy and electron-diffraction analysis. It has been shown that the vacuum deposition of a C₆₀+C₇₀ mixture results in the formation of a film with small sized grains and a distorted C₆₀-HCP structure. The simultaneous deposition of C₆₀ and ferrocene results in the formation of a film with a changed morphology and an electron-diffraction pattern that contains a variable amount of ferrocene depending on the experimental conditions. The electron-diffraction pattern corresponds to the presence of the known molecular complex C₆₀[(C₅H₅)₂Fe]₂. The analogous simultaneous deposition of fullerene C₆₀ and cobaltocene results in the formation of a C₆₀ film stable in air and water, which contains carbon and cobalt (from the data of X-ray fluorescence, electron microscopy and microdiffraction). It has a different morphology and different diffraction patterns than pure C₆₀ films and, depending on the cobaltocene content (relative to that of fullerene), appears to be a fullerite film doped with various amounts of cobaltocenium fullende, which is an ionic compound.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1379–1383, August, 1994.The work was financially supported by the Russian Foundation for Basic Research (Projects 93-03-4676 and 93-03-18368).     

Resistance to Surfactant and Protein Fouling Effects at Conducting Diamond Electrodes

Boron‐doped diamond thin‐film electrodes display negligible fouling effects in the presence of high levels of surface‐active materials, including proteins. Dramatic improvements in the stability of the analyte response (compared to common glassy carbon and carbon paste electrodes) are illustrated using bovine serum albumin (BSA), gelatin, and Triton X‐100 in connection with repetitive square‐wave voltammetric (SWV) measurements. The voltammetric response of ascorbic acid at the diamond electrode exhibits negligible shifts in peak potentials and minimal depressions of current signals over a wide range of surfactant concentrations (0–750 ppm). For example, the diamond electrode exhibited 70, 50 and 60 mV potential shifts for 10 repetitive voltammetric scans in the presence of 100 ppm BSA, gelatin and Triton X‐100, respectively, compared to 120, 190, and 280 mV shifts observed at the glassy carbon electrode. Furthermore, only 4.3 and 6.2% of the initial current decays were observed in the presence of 100 ppm Triton X‐100 and gelatin, respectively (compared to 45.2 and 34.4% diminutions at the glassy carbon electrode). Such improved performance was also confirmed from the SWV measurements of uric acid, dihydroxyphenylacetic acid, and catechol. The greatly improved resistance to surfactant interference reflects the fact that the as‐grown diamond thin film, composed of oxide‐free and hydrogen‐terminated surface, has a relatively lower surface energy and minimal electrostatic attributes, either specific or general, so that little adsorption of surface‐active agents occurs. The topographic AFM images of the diamond electrode surface confirm a negligible BSA fouling effect after repetitive SWV measurements. Such enhanced antifouling features make diamond electrodes very attractive for numerous real‐life electroanalytical applications.     

Sm2O3掺杂CeO2纳米粉体的烧结动力学

对Sm2O3掺杂CeO2纳米粉体的烧结性能进行了研究, 得出等速烧结过程中试样的线收缩率、密度、气孔率随烧结温度的变化规律, 它们随烧结温度的变化均呈"S"型曲线关系, 利用非线性回归了等速烧结过程动力学方程. 结果表明, Sm2O3掺杂CeO2纳米粉体的烧结过程分为3个阶段, 当烧结温度低于1000 ℃时, 线收缩率与密度变化较小, 处于烧结的初期; 在1000～1400 ℃时, 随着烧结温度的升高, 线收缩率与体积密度急剧增大, 材料开始烧结并致密化; 当烧结温度高于1400 ℃时, 线收缩率与体积密度趋于一恒定值, 材料已经致密化. 由归一化速率方程可知, 在T=1225 ℃时, 材料的烧结致密化速率最大.     

Preparation, phase transformation and photocatalytic activities of cerium-doped mesoporous titania nanoparticles

Cerium-doped mesoporous TiO₂ nanoparticles with high surface area and thermal stable anatase wall were synthesized via hydrothermal process in a cetyltrimethylammonium bromide (CTAB)/Ti(SO₄)₂/Ce(NO₃)₄/H₂O system. The obtained materials were characterized by XRD, FESEM, HRTEM, FTIR spectroscopy, nitrogen adsorption and DRS spectra. Experimental results indicated that the doping of cerium not only increased the surface area of mesoporous TiO₂ nanoparticles, but also inhibited the mesopores collapse and the anatase-to-rutile phase transformation. Moreover, the undoped, doped anatase mesoporous nanoparticles exhibit higher photocatalytic activity than commercial photocatalyst (Degussa, P25), but the maximum photodegradation rate corresponds to the undoped mesoporous TiO₂ nanoparticles. The lower photocatalytic activities of cerium-doped samples compared with undoped one may be ascribed to that the doped cerium partially blocks titania's surface sites available for the photodegradation and absorption of Rhodamine B (RB).     

掺铁纳米TiO_2的制备及其光催化性能

以TiC l4为原料,采用微波加热与常规加热2步合成法制备掺铁纳米TiO2。用X射线粉末衍射(XRD)、透射电镜(TEM)、紫外可见吸收光谱(UV-V is)、光电子能谱(XPS)等测试技术对其进行了表征。结果表明,所制得的掺铁纳米TiO2是以锐钛矿为主相的混晶,平均粒径约为10 nm,适量Fe3+的掺杂能促进金红石相变,抑制锐钛矿晶粒的生长,使Ti2p电子结合能升高0.3 eV,并使TiO2吸光能力增强,带边吸收向可见光区移动。在UVA段(320~400 nm)光照下,通过对维生素VB12的光催化降解,发现掺入摩尔分数为0.5%的Fe3+的纳米TiO2能明显提高其光催化活性,使维生素B12的降解速率提高2.3倍。     

Anchored palladium bipyridyl complex in nanosized MCM-41: a recyclable and efficient catalyst for the Kumada-Corriu reaction

A palladium bipyridyl complex anchored onto nanosized mesoporous silica MCM-41 catalyzed the cross-coupling of aryl iodides or bromides with Grignard reagents to provide the corresponding biaryls in high yields. The reaction proceeded smoothly with an equal molar amount of substrate and Grignard reagent in the presence of 0.2-0.02 mol % of catalyst in THF at 50 °C or under refluxing conditions. The catalyst prepared may be used in a very low percentage, recovered after reaction, and re-used.     

Chains, ladders and sheets of d metal–organic polymers generated from the flexible bipyridyl ligands

By use of the three-layer diffusion method, reactions of flexible bipyridyl ligands (4,4′-bpp or 3,3′-bpp) with M(II) salts (M = Zn, Cd) and multi-carboxylate ligands resulted in the formation of four interesting d¹⁰ metal–organic coordination polymers: [Zn(μ-4,4′-bpp)Br₂]_n (1), [Zn(μ-4,4′-bpp)(1,2-bdc)]_n · nH₂O (2), [Zn(μ-3,3′-bpp)(1,3-bdc)]_n · nCH₃OH · 2nH₂O (3) and [Cd(μ-3,3′-bpp)(C₄H₂O₄)]_n · 3nH₂O (4) (4,4′-bpp = 2,2′-bis(4-pyridylmethyleneoxy)-1,1′-biphenylene; 3,3′-bpp = 2,2 ′-bis(3-pyridylmethyleneoxy)-1,1′-biphenylene; bdc=benzenedicarboxylate, C₄H₄O₄ = fumaric acid). Complex 1 has a 2D sheet structure consisting of two unusual zigzag Zn(II) chains which are nearly perpendicular to each other. Complex 2 is comprised of two-leg ladders, in which [Zn(4,4′-bpp)] chains serve as the side rails and 1,2-bdc ligands serve as the cross rungs. In complex 3, every two 1,3-bdc ligands connect the neighbouring Zn(II)-3,3′-bpp dimetallic rings in η¹ coordination modes into an interesting chain structure. Complex 4 consists of an anionic macrocycle-containing cadmium dicarboxylate sheets that are separated by 3,3′-bpp. These d¹⁰ metal complexes exhibit high thermal stabilities and strong luminescence efficiencies.     

Selective Detection of Dopamine and Its Metabolite,DOPAC, in the Presence of Ascorbic Acid Using Diamond Electrode Modified by the Polymer Film

The surface of boron‐doped diamond (BDD) electrode is modified by the polymer film for the first time. The cationic polymer film of N,N‐dimethylaniline (DMA) is electrochemically deposited on BDD electrode surface. This polymer (PDMA) film‐coated BDD electrode is used as a sensor which selectively detect dopamine (DA) in the presence of ascorbic acid (AA). This electrode also can detect both DA and its metabolite, 3,4‐dihydroxy phenyl acetic acid (DOPAC) in the presence of AA in the range of the physiological concentrations of these species. Favorable ionic interaction (i.e., electrostatic attraction) between the PDMA film and AA or DOPAC lowers their oxidation potentials and enhances the current response for AA and DOPAC compared to that at the bare electrode. The PDMA film also shows a hydrophobic interaction with DA and DOPAC. In cyclic voltammetric measurements, the PDMA film‐coated electrode can successfully separate the oxidation potentials for AA and DA coexisting in the same solution and the separation is about 200 mV. AA oxidizes at more negative potential than DA. In square‐wave voltammetry, the sensitivity of the PDMA film‐coated BDD electrode for DA in the presence of higher concentration of AA is higher than that of the PDMA film‐coated glassy carbon electrode. The hydrodynamic amperometric experiments confirm that the oxidation of AA is not affected by the oxidized product of DA and vice versa. So, unlike the bare electrode the catalytic oxidation of AA by the oxidized DA is eliminated at the PDMA film‐coated BDD electrode. The sensitivities of the modified electrode for AA, DA and DOPAC, which are present in the same solution with their physiological concentration ratios, are calculated to be 0.070, 0.363 and 0.084 μA μM^?1, respectively. The modified electrode exhibits a stable and sensitive response to DA.     

SrO—Al2O3—SiO2：Eu^3＋,Bi^3＋发光体的溶胶—凝胶法合成

制备无机固体材料大都采用高温固相反应,1971年Dislich报导了用溶胶-凝胶法制备多组份固体材料。近年来,有报导利用此法研制玻璃、玻璃陶瓷和陶瓷。我们在过去工作的基础上,合成了SrO-Al_2O_3-SiO_2:Eu~(3 ),Bi~(3 )发光体,研究了从凝胶至发光晶体的转变过程、Eu~(3 )和Bi~(3 )在SrO-Al_2O_3-SiO_2基质中的发光性质以及Bi~(3 )对 EU~(3 )的能量传递。