Use of a database of plots of pesticide retention (R F) against mobile-phase composition.Part I. Correlation of pesticide retention data in normal- and reversed-phase systems and their use to separate a mixture of ten pesticides by 2D TLC

Summary Ten pesticides have been completely separated by two-dimensional (2D) development on TLC plates coated with coupled layers of octadecyl silica (reversed-phase, RP) and plain silica (normal-phase, NP). The binary mobile phases, aqueous-organic for RP chromatography and nonaqueous for NP chromatography, were chosen from plots ofR _F against mobile-phase composition and graphicalR _F(RP)-R _F(NP) correlations. The different selectivity of the RP and NP systems enabled dispersion of spots over the plate area and good separation.     

Determination of 3-amino-1,2,4-triazole (amitrole) in environmental waters by capillary electrophoresis

3-Amino-1,2,4-triazole (amitrole) is a widely used pesticide, with many difficulties to be analyzed at the regulatory level in drinking water, because its high solubility in water. This paper describes a simple and fast method for the simultaneous determination of amitrole and atrazin-2-hydroxy, principal degradation product of s-triazines, by capillary zone electrophoresis. Separation and determination of these herbicides in water samples was performed in 0.02 mol l⁻¹ phosphate buffer at pH 3.2. The method allows determination of the amitrole and atrazin-2-hydroxy in water samples in concentration lower than 100 μg l⁻¹. The detection limits using a previous preconcentration step of amitrole in Alberche River (Comunidad Autónoma de Madrid, Spain) and drinking water spiked samples was of 4 μg l⁻¹.     

密封罐微波消化法序列ICP-AES测定环境试样中多元素

本文采用密闭罐微波消化方法快速分解生物、土壤、沉积物等环境样品。按样品性质,分别采用HNO3/H_2O_2或HNO_3/H_2O_2/HF在聚四氟乙稀密闭罐中于500W微波功率分解0.1～0.2g样品2～3min,溶液(或在其中加入10ml硼酸饱和溶液)稀释至2.5～5.0ml后,直接用序列ICP-AES法测定。方法准确度经分析6个生物、土壤、沉积物标准参考物质验证,10个元素的均值均与定值吻合。     

Detection of environmental chemicals by SPR assay using branched cyclodextrin as sensor ligand

We obtained the association constants Ka of estrogen (E2) and environmental chemicals by the surface plasmon resonance (SPR) assay using the immobilized mono-6-O-α-maltosyl-β-CD (G₂βCD) compared with the immobilized β-CD and the immobilized estrogen receptor (ER). The association behavior of G₂βCD was shown as a ER model compound. The calibration curve was determined by the initial rate of association depending on the various concentrations, and the minimum detectable concentrations in the order of parts per billion were calculated. The SPR assay has advantages that the pre-treatment of the sample is not necessary and the immobilized ligand is stable and useful for the repeated measurement.     

Routine determination of major anions in atmospheric aerosols by capillary electrophoresis

Capillary electrophoresis (CE) with indirect UV detection utilizing a pyromellitate-based electrolyte was used for the routine analysis of major anions in atmospheric aerosols collected on filters with high-volume (Hi-Vol) samplers. The long-term reliability of the CE system was checked over an 8-month period during which over 2900 samples were analyzed. In addition, approximately 1100 samples were analyzed in parallel by ion chromatography (IC). It has been shown that acceptable analytical performance can be routinely obtained. The agreement between the CE and IC results is good, generally better than 20% at concentrations larger than 1 mg l⁻¹.     

Development and validation of an analytical method for detection of estrogens in water

An analytical procedure enabling routine analysis of four environmental estrogens at concentrations below 1 ng L^–1 in estuarine water samples has been developed and validated. The method includes extraction of water samples using solid-phase extraction discs and detection by gas chromatography (GC) with tandem mass spectrometry (MS–MS) in electron-impact (EI) mode. The targeted estrogens included 17- and 17-estradiol (aE2, bE2), estrone (E1), and 17-ethinylestradiol (EE2), all known environmental endocrine disruptors. Method performance characteristics, for example trueness, recovery, calibration, precision, accuracy, limit of quantification (LOQ), and the stability of the compounds are presented for each of the selected estrogens. Application of the procedure to water samples from the Scheldt estuary (Belgium – The Netherlands), a polluted estuary with reported incidences of environmental endocrine disruption, revealed that E1 was detected most frequently at concentrations up to 7 ng L^–1. aE2 was detected once only and concentrations of bE2 and EE2 were below the LOQ.Presented at the 9th FECS Conference on Chemistry and the Environment, Bordeaux, France, 29 August–1 September 2004     

Gas chromatographic system equipped with a mass detector and a selective nitrogen-phosphorous detector operating simulataneously in the analysis of pesticide residues

The possibility to perform gas chromatographic analysis using both a mass detector and a selective nitrogen-phosphorous detector will enable highly sensitive analytical results and an optimal identification reliability. In this work we describe an easily workable technical solution, which has been accomplished in our laboratory and the application of the above system to analytical procedures for the detection and determination of nitrogenous herbicides in drinking water and phosphorylated pesticides in agricultural products is discussed.     

The impact of LIMS design and functionality on laboratory quality achievements

 A laboratory information management system (LIMS) can make a major contribution to the quality and therefore to the efficiency and competitiveness of a laboratory. Since it can impact all aspects of a laboratory's organization it must be the key if not the principal player of the laboratory's quality system. It should support the laboratory in establishing, maintaining and applying quality procedures thereby enabling the laboratory to achieve its quality goals. As a tool, LIMS permits the laboratory to input and use its own know-how and experience to optimize the total organization (internal and external) and workflow of generated information. However, perceived "quality" in the context of an LIMS, can be viewed as being made up of different facets such as the security, reliability and accessibility of information as well as its turn around time and production cost. This paper reviews the role of a LIMS in the laboratory and the contribution that both system design and functionality can have on "building quality ". Received: 5 October 1998 · Accepted: 20 October 1998     

Ion-exchange method for separation and concentration of platinum and palladium for analysis of environmental samples by inductively coupled plasma atomic emission spectrometry

An ion-exchange procedure is proposed for determination of Pt and Pd in environmental samples, using a Dowex 1-X10 anion-exchange resin. Pt and Pd were separated from the matrix elements in the sample by selective retention on the column as anionic chloro complexes and subsequent elution by circulated thiourea at 60 °C. The eluent, containing Pt and Pd was analyzed by inductively coupled plasma (ICP) atomic emission spectrometry (AES). Average recoveries of 98% and detection limit of 15 ng/g for both metals were achieved. Analysis of Pt and Pd concentrations in road dust, sampled from several sites in Germany was performed. The comparison of the obtained data with the concentrations of Pt and Pd in the same samples, determined by ICP-MS showed a very good agreement.     

Quality assurance in research laboratories

During the last decade, it has become increasingly important that researchers demonstrate that research is conducted to the highest standards. The implementation of quality assurance for research laboratories will enable all fields of research and development to be judged impartially. There are no specific standards for research laboratories but where possible, existing standards can be adapted. This review is structured around two approaches. The first considers research to be a logical extension of testing, and it is assumed that testing standards can be applied methodically to each step in a research project. The second advocates a flexible approach, with research-specific criteria for assessing quality. The important papers published on this topic have been reviewed. The conclusions are that the general quality management approach, encompassed by the ISO 9000 series of standards with the emphasis on customer satisfaction and ‘fitness for purpose’, is suitable for implementing quality assurance in research laboratories.