六方相InGaN外延膜的显微Raman散射

用X射线衍射(XRD)技术和显微Raman散射方法对金属有机化学气相沉积(MOCVD)法生长的六方相In_xGa_1-xN薄膜样品进行了研究，观察到了相分离现象和LO声子-等离子耦合模(LPP⁺)，讨论了In_xGa_1-xN的A₁(LO)模被屏蔽的主要物理机制.同时，对Raman谱中E₂和A₁(TO)声子模进行了分析和讨论.在In_xGa_1-xN样品的低温Raman谱中还观察到单电子跃迁产生的Raman散射信号. 关键词： Raman散射 X射线衍射 相分离 应力 LO声子-等离子耦合     

Asymmetric phase diagram and phase separation in Pr0.5−δCa0.2+δSr0.3MnO3 (−0.04δ0.04)

We present electric and magnetic properties of polycrystalline Pr_0.5−δCa_0.2+δSr_0.3MnO₃, for δ between −0.04 and 0.04, where the hole concentration is n=0.5+δ. In this series, we study the effects of moving n away from 0.5 on both, the phase diagram and phase separated state. We found that the low temperature ferromagnetic fraction X_FM continuously decreases when n increases. As a result, the samples with n<0.5 (large X_FM) exhibit metallic resistivity at low T while for n>0.5 the insulating state predominates. We construct a detailed T–n phase diagram showing the asymmetries around half-doping.     

Transport and harvesting of suspended particles using modulated ultrasound

Polystyrene particles of 9 μm diameter were acoustically concentrated along the axis of a water-filled cylindrical waveguide containing a 3 MHz standing wave field. Modulation of the acoustic field enabled transport of the concentrated particles in the axial direction. Four modulations were investigated; 1, a fixed frequency difference introduced between two transducers; 2, ramping the transducer frequency; 3, tone burst, i.e. sound that is pulsed on and off, allowing intermittent sedimentation under gravity; and 4, switching the sound off to allow continuous sedimentation. The most efficient transport (leaving the fewest particles in suspension) of clumps to one end of the container was achieved with method 1 above. In this system the maximum speed of transport of the axial clumps was 24 mm s^-1. A theory developed here for the transport of particles in a pseudo (i.e. slowly moving) standing wave field predicts an upper limit, which increases with particle size, for the speed of an entrained body. For a single 9 μm diameter particle in a field with a spatial peak pressure amplitude of 0.4 MPa this speed would be 0.5 mm s^-1. The higher experimental speeds observed here emphasize the value of acoustically concentrating particles into relatively large clumps prior to initiating transport.     

Two-spin-majority cellular automaton as a model of 2D cluster and interface growth

A new probabilistic cellular automaton model is introduced to simulate cluster and interface growth in two dimensions. The dynamics of this model is an extension to higher dimensions of the compact directed percolation studied by Essam. Numerical results indicate that the two-dimensional cluster coarsening and growth can be described only approximately by the conventional cluster size scaling due to a crossover in the growth mode. The spreading of the initially flat interface follows a purely diffusional,t ^1/2, law.     

Micron-sized particle separation with standing surface acoustic wave—Experimental and numerical approaches

Traditional cell/particle isolation methods are time-consuming and expensive and can lead to morphology disruptions due to high induced shear stress. To address these problems, novel lab-on-a-chip-based purification methods have been employed. Among various methods introduced for the separation and purification of cells and synthetics particles, acoustofluidics has been one of the most effective methods. Unlike traditional separation techniques carried out in clinical laboratories based on chemical properties, the acoustofluidic process relies on the physical properties of the sample. Using acoustofluidics, manipulating cells and particles can be achieved in a label-free, contact-free, and highly biocompatible manner. To optimize the functionality of the platform, the numerical study should be taken into account before conducting experimental tests to save time and reduce fabrication expenses. Most current numerical studies have only considered one-dimensional harmonic standing waves to simulate the acoustic pressure distribution. However, one-dimensional simulations cannot calculate the actual acoustic pressure distribution inside the microchannel due to its limitation in considering longitudinal waves. To address this limitation, a two-dimensional numerical simulation was conducted in this study. Our numerical simulation investigates the effects of the platform geometrical and operational conditions on the separation efficiency. Next, the optimal values are tested in an experimental setting to validate these optimal parameters and conditions. This work provides a guideline for future acoustofluidic chip designs with a high degree of reproducibility and efficiency.     

The Possible Coupling of LNG Regasification Process with the TSA Method of Oxygen Separation from Atmospheric Air

Liquefied Natural Gas (LNG) must be vaporized before it is used in the combustion process. In most regasification terminals, energy that was previously expended to liquefy natural gas is dissipated in the environment. The paper proposes the use of the thermal effect of LNG regasification for the atmospheric air separation as a possible solution to the LNG exergy recovery problem. The presented idea is based on the coupling of the LNG regasification unit with an oxygen generator based on the Temperature Swing Adsorption (TSA) process. Theoretical analysis has revealed that it is thermodynamically justified to use the LNG enthalpy of vaporization for cooling of the TSA adsorption bed for increasing its adsorptive capacity. It has been shown that 1 kg of LNG carries enough exergy for separating up to approximately 100 g of oxygen using the TSA method. Although the paper suggests using the enthalpy of LNG vaporization for atmospheric air separation, similar processes for other gas mixture separations using the TSA method can be applied.     

使用稀疏贝叶斯学习的水声多途信道盲估计

提出了一种使用稀疏贝叶斯学习(SBL)的多途信号盲解卷积方法对水声多途信道的信道脉冲响应(CIR)进行盲估计。该方法利用垂直阵和多频SBL获得宽带舰船声源在不同垂直到达角上的复数域多频点信号,取其相位对垂直阵接收信号匹配滤波,得到每条路径上的CIR,将多路径CIR相干叠加得到最终的多途CIR结果。仿真与海试数据处理结果表明,相比于原有的基于交替投影的多途信号盲解卷积方法,所提出方法有以下几个好处:(1)无需准确预估多途信号数目;(2)分离的多途信号的方位更准确且信号相位更可靠;(3)有效获取了舰船与阵列之间的CIR.并且将弱路径CIR的平均时间估计误差从4.7 ms缩小到1.0 ms.显著提高了弱路径CIR的时间估计精度。使用稀疏贝叶斯学习的多途信号盲解卷积方法能够有效提高多途环境下水声信道盲估计的性能。     

Morphology and Pore Size Distribution of Biocompatible Interconnected Porous Poly(L-lactic acid) Foams with Nanofibrous Structure Prepared by Thermally Induced Liquid–Liquid Phase Separation

Biocompatible, highly interconnected microporous poly(L-lactic acid) (PLLA) foams with nanofibrous structure, containing pores with average diameter below 1 μm and fibers with diameters of 10² nm scale, were prepared through the thermally induced liquid–liquid phase separation (TIPS) method consisting of quenching of the PLLA solution, freeze extraction with ethanol, and vacuum drying. Diverse foam morphologies were obtained by systematically changing parameters involved in the TIPS process, such as polymer concentration, solvent composition, and quenching temperatures. The morphology of different foams was examined by scanning electron microscopy to characterize the pore size and the pore size distribution. The results showed that most porous foams had a nanofibrous structure with interconnected open pores. In the case of using tetrahydrofuran (THF) as solvent, the higher the PLLA concentration, the smaller the average pore diameter and the narrower the pore size distribution. In the case of using the mixed solvents of THF/DOX (1,4-dioxane) with higher than 6/4 volume ratio, there appeared a maximum value of average pore diameter and a widest pore size distribution at 0.09 g/mL PLLA concentration. The average pore diameter of the foams increased with increasing DOX content in the mixed solvent and ranged from 0.2 to 0.9 μm depending on the process parameters. When the DOX content reached 60% by volume, the morphology of the foams contained some large closed pores with diameter ranging from 1 to 10 μm. By decreasing the quenching temperature, the average pore diameter of foams decreased and the pore size distribution became narrower. All the pore size distribution fit F-distribution equations.     

Electron spin resonance in pyrolyzed lignin

An investigation has been made into electron spin resonance (ESR) occurring in the ranges of carbons prepared from periodate lignin by vacuum pyrolysis. Line shape, line width, g-factors, saturation effects, and free spin concentration have been measured and the effect of oxygen on these parameters has been examined. A g-shift and lines with inhomogeneous broadening have been observed. In the presence of oxygen the lower-temperature carbons showed an unexpected increase in the detectable free spin concentration. The discussion includes factors affecting the nature of the free spins in the pyrolyzed material.     

Influence of the blend compatibility on the morphology of thin polymer blend films

Thin films of incompatible polymer blends can form a variety of structures on preparation. For the polymer blend system consisting of two poly(styrene-co-para-bromo-styrene)s at different degrees of bromination, PBr_xS/PBr_yS, the compatibility can be tuned through a variation of the difference in the degree of bromination. Within this blend system, two series of samples with different compatibilities were investigated at various blend compositions. The surface morphology of the thin films was investigated by atomic force microscopy (AFM) measurements, while diffuse X-ray scattering provided additional depth sensitivity at a comparable lateral resolution. The results are indicative for phase separation lateral, as well as perpendicular, to the sample surface.