Spectral Studies on Some Pyrimidine Derivatives in Different Solvents

The electronic absorption spectra of 2-aminopyrimidine (compound I), 2-amino-4-methylpyrimidine (compound II), 2-amino-4,6-dimethylpyrimidine (compound III), 2-amino-4,6-dimethoxypyrimidine (compound IV), 4-amino-2,6-dimethylpyrimidine (compound V), and 4,5-diamopyrimidine (compound VI) have been measured in water and in a series of different organic solvents. The solvent effects on the spectra are discussed and the solvent induced spectral shifts are analyzed in terms of different solute–solvent interaction mechanisms, using the multiple linear regression technique.     

电感耦合等离子体原子发射光谱法测定镍基单晶高温合金中Mo、W、Ta、Re、Ru时元素之间相互干扰的消除与校正的研究

称取镍基单晶高温合金0.100 0g于聚四氟乙烯烧杯中,先令其与盐酸9mL和硝酸1mL加热反应,待反应缓慢时滴加氢氟酸2mL并继续加热使样品完全溶解。加入500g·L^-1酒石酸溶液2mL,冷却至室温,在塑料容量瓶中加水定容至100.0mL。按仪器工作条件采用电感耦合等离子体原子发射光谱法测定其中5种合金元素(Mo、W、Ta、Re、Ru)的含量,选择分析谱线依次为204.598,207.911,240.063,197.312,240.272nm。结果发现:除了Re外,其余4种元素的测定中均受共存元素的光谱干扰,严重影响了测定结果的准确性。为克服其干扰,除了采用基体匹配法消除镍的基体干扰外,试验采用混合校正系数矩阵法对测定结果进行校准。通过一系列试验计算得到混合校准系数矩阵K,并应用于模拟样品的分析。结果表明:经过矩阵K的校准,所测定的5种元素的准确度显著提高,达到了消除共存元素之间光谱干扰的目的。通过精密度试验,测得上述5种元素测定值的相对标准偏差(n=11)均在1.5%以下,并通过标准加入法进行回收试验,测得5种元素的回收率为97.0%~105%。     

高分辨等离子体质谱法直接测定高纯镓中的痕量元素

建立高分辨电感耦合等离子体质谱法(HR-ICP-MS)测定高纯镓样品中Be、Mg、A l、S i、Ti、V、Cr、Mn、Fe、Co、N i、Cu、Zn、Ge、As、Mo、Ag、Cd、In、Sb、Ba、Pb、B i等痕量元素的方法。样品用HNO3 HC l经微波消解后,试液直接进样用HR-ICP-MS法同时测定上述元素,在高分辨质谱测量模式下避免了大量的质谱干扰,详细地研究了HC l和高纯镓所产生的基体效应,以Sc、Rh、Tl作为内标元素校正了基体效应,讨论和确定了实验的最佳测定条件。结果表明,23种痕量元素的检出限在0.001~0.21μg/L之间;回收率在89.8%~111.6%之间,相对标准偏差(RSD)小于3.3%。     

己烯在Ru(1010)表面价带电子特性研究

在200 K以下己烯（C6H12）可以在Ru()表面上以分子状态稳定吸附.偏振角分辨紫外光电子谱（ARUPS）结果表明,己烯分子在垂直于衬底表面并沿衬底表面<>晶向的平面内,己烯分子的轴向沿<>晶向倾斜.随着衬底温度的提高,到200 K以上,己烯分解生成新的碳氢化合物.己烯分解后,πCH分子轨道能级向高结合能方向移动了0.2 eV,同时己烯中C的1s能级向低结合能方向移动了 0.3 eV.     

光谱实验室的建设和管理

阐述冶金、铸造等行业用于金属成分分析的直读发射光谱仪实验室的建设和管理。从仪器的调研、选型，实验室选址，基础设施设备的准备，仪器的安装、调试、验收、日常分析，实验室管理等几个方面，分别作了介绍。     

Preparation of apolar glass capillary columns by the barium carbonate procedure

As an extension of previous reports, the barium carbonate procedure has been optimized in detail for the preparation of apolar columns. The aim was to produce optimum overall column characteristics, and to maintain them unchanged under the prolonged influence of the highest possible temperature. The main parameters under optimization were glass variety, leaching of glass surface with aqueous HCl, and amount of barium carbonate deposited, while deactivation and coating were kept constant. The basic column characteristics were adsorption properties and thermostability of deactivation, acid/base behaviour and separation efficiency. They were determined by a new, quantitative testing procedure. Intense leaching was able to eliminate almost totally the differences between glass varieties and to create a well-defined glass surface. While untreated glass, leached glass, and barium carbonate treated glass showed specific weak points in the respective column quality, the combination of leaching and barium carbonate treatment yielded the highest and most stable quality. Some technical modifications of the preparation procedure are described, including deactivation in the gas phase, and use of pentane as a solvent for static coating.     

Non-empirical INDO-MO calculations on some vanadium(IV) halides

ODIN, a non-empirical INDO-MO scheme, has been used to determine the ground state electronic configurations for the tetrahedral molecules, VCl₄ and VBr₄. A ² E ground state was obtained for both molecules. The Photoelectron spectrum and the electronic spectrum have been calculated for VCl₄, and a satisfactory correlation with the corresponding experimental data was made. Also, ODIN was employed to evaluate electronic transition energies and the photoelectron spectrum of VBr₄.     

Surface modification of soft-glass capillaries for gas chromatography by treatment with water vapour

“Leaching” or “etching” by strong mineral acids seems to be a necessary pretreatment step for the most commonly used deactivation procedures of glass capillaries by reaction with either polyethylene glycol or silylation reagents. The acidic sites which are formed on the surface during this acid treatment cannot be completely removed by the subsequent deactivation process. This drawback can be overcome by performing the leaching with water vapour, resulting in an accumulation of cations at the surface and a decrease in the number of silanol groups. Capillaries of this type show excellent properties for the chromatography of strongly basic compounds. After the wash-out of the alkaline surface layer, the acidity of the support is suited for the chromatography of strongly basic as well as strongly acidic compounds. Due to a lack of reactive acidic sites, special deactivation procedures have to be applied to capillaries produced in this way.     

3-苄基-4-氨基-5-芳胺基-1,2,4-三唑的合成与表征

酰氨基硫脲是一类重要的有机合成中间体[1-3]。其最终产物大都有消炎、镇痛、抗菌、杀虫、除草、调节植物生长等生理活性。本文以苯乙酸乙酯与芳胺为基本原料,经多步反应,制得1 苯乙酰基 4 芳基氨基硫脲,研究了它们在水合肼存在下的关环反应,合成了3 苄基 4 氨基 5 芳胺基 1,2,4 三唑,其结构经元素分析、红外光谱、核磁共振氢谱、碳谱表征。1　实验部分1 1　仪器与试剂ＸＴ4Ａ型显微熔点仪(温度计未校正);ＣＥ公司(意大利)Ｆｌａｓｈ1112型自动元素分析仪;Ｂｒｕｋｅｒ公司(德国)Ｅｑｕｉｎｏｘ55型红外分光光度计,ＫＢｒ压片;Ｂｒｕｋ…     

稀土乙酰丙氨酸咪唑配合物的合成及光谱性质

稀土元素由于特殊的外层电子构型,在与不同类型配体配位时,呈现出丰富多彩的配位行为和结构,其配合物,特别是有机配合物,由于具有发光性强、选择性好的特点,在发光、激光材料创制、结构探针、荧光免疫分析及生物传感器等领域的研究和应用引起广泛关注.氨基酸、肽是各种生物大分子的基本组成单元,咪唑存在于组氨酸、羧肽酶、血红蛋白等生物分子中参与配位或"变构效应"成为活性部位结构,唑环有丰富的能级,其作为含N富电子体系可与稀土离子形成既有生物活性,又有优良光学性能的配合物.