Flow injection system for hydrolysable tannin determination

A flow injection system was proposed to evaluate the transient product of a colorimetric reaction between hydrolysable tannin and potassium iodate (KIO₃) solution. The system optimization was accomplished by using statistical methods based on experimental design. Flow rate of KIO₃ solution, sample volume, carrier flow rate, and reaction coil were the selected factors for evaluation. On screening step, complete factorial 2⁴ was used and two levels for each selected factor were studied. For the optimization phase, a centered face composite design 2² + star was employed to evaluate sample volume and flow rate of KIO₃ solution, which were the factors identified in the screening phase as having more influence on the absorbance signal. After optimization, the proposed system was compared with batch determination. Some characteristics, such as analytical frequency, reagent consumption and chemical residues generation presented better results by the use of the proposed system if compared with batch method. The system presented good repeatability with standard deviation lower than 3%, for n = 10, linearity (R² = 0.9974) for tannic acid standard, analytical frequency of 15 injections h^− 1 and limit of quantification of 24 mg L^− 1 of tannic acid. Good results were obtained when the proposed system was applied to hydrolysable tannin determination in Stryphnodendron barbatimão, Eucalyptus citriodora and Phyllanthus niruri, samples of plants commonly used in popular medicine.     

纳米MnO2超级电容器的研究

用固相合成法制备纳米MnO2，作为超级电容器材料，通过循环伏安、交流阻抗与恒电流充放电等测试手段对MnO2电极进行分析.结果表明,以1 mol•L－1 KOH为电解液， MnO2电极在－0.1～0.6 V(vs. Hg/HgO)的电压范围内具有良好的法拉第电容性能.在不同电流密度下，电极比容量达240.25到325.21 F•g－1.恒电流充放电5000次后，电极容量衰减不超过10％.     

NMR spectroscopy techniques for screening and identifying ligand binding to protein receptors

Binding events of ligands to receptors are the key for an understanding of biological processes. Gaining insight into protein-protein and protein-ligand interactions in solution has recently become possible on an atomic level by new NMR spectroscopic techniques. These experiments identify binding events either by looking at the resonance signals of the ligand or the protein. Ideally, both techniques together deliver a complete picture of ligand binding to a receptor. The approaches discussed in this review allow screening of compound libraries as well as a detailed identification of the groups involved in the binding events. Also, characterization of the binding strength and kinetics is possible, competitive binding as well as allosteric effects can be identified, and it has even been possible to identify ligand binding to intact viruses and membrane-bound proteins.     

Synthesis and Characterization of Fluoro- and Chloro- bimetallic Alkoxides as Precursors for Luminescent Metal Oxide Materials via Sol-Gel Technique

Heterobimetallic alkoxides are broadly recognized as versatile precursors for luminescence materials, and efforts are being made to develop novel routes by applying the concept of geometrical molecular design, for their synthesis and to design a single source precursor suited to photoluminescent materials. Novel and new series of bimetallic alkoxides has been prepared by metathesis route. They exhibit a lower sensitivity towards hydrolysis and so they are easier to handle as compared to other alkoxides. All the compounds were characterized by elemental analysis, FT-IR and multinuclear NMR spectroscopies. FT-IR revealed that the molecular structure of these metal alkoxides was retained to a large extent in 4 ： 1 halogenated alcohol-benzene solution. The heteronuclear NMR spectroscopy provided useful information about chemical shifts for better understanding the likely structure based on interactions with their coordinate metals. The mass spectra show similar types of fragmentation pattern. SEM-EDS analyses showed consistency with the formulation. XRD patterns show an enhanced homogeneity at high temperature. TGA measurements show that thermal decomposition occured in steps that depended entirely on the chemical compositions and the synthesis routes. SEM observation reveals that the morphology and particle size strongly depend on synthesis routes for their precursors.     

Calculating the knowledge-based similarity of functional groups using crystallographic data

A knowledge-based method for calculating the similarity of functional groups is described and validated. The method is based on experimental information derived from small molecule crystal structures. These data are used in the form of scatterplots that show the likelihood of a non-bonded interaction being formed between functional group A (the `central group') and functional group B (the `contact group' or `probe'). The scatterplots are converted into three-dimensional maps that show the propensity of the probe at different positions around the central group. Here we describe how to calculate the similarity of a pair of central groups based on these maps. The similarity method is validated using bioisosteric functional group pairs identified in the Bioster database and Relibase. The Bioster database is a critical compilation of thousands of bioisosteric molecule pairs, including drugs, enzyme inhibitors and agrochemicals. Relibase is an object-oriented database containing structural data about protein-ligand interactions. The distributions of the similarities of the bioisosteric functional group pairs are compared with similarities for all the possible pairs in IsoStar, and are found to be significantly different. Enrichment factors are also calculated showing the similarity method is statistically significantly better than random in predicting bioisosteric functional group pairs.     

Flotation-spectrophotometric method for the determination of mercury using iodide and brilliant green

This paper describes a sensitive spectrophotometric method for the determination of mercury, based on the flotation of a mercury iodide-brilliant green complex with cyclohexane at pH 5 and dissolution of the complex in acetone. The absorbance of the complex is measured at 625 nm. Beer's law is obeyed from 4–500 g/l of mercury. The method is highly sensitive ( = 5.96 × 10⁵ 1 mol^–1 cm^–1) and selective, as it is free from interferences by almost all cations and anions in the presence of EDTA. Furthermore, a two-level orthogonal array design as a chemometric method has been used for optimization of the various parameters involved. The method has been successfully applied to paper industry effluents.     

The effect of low concentrations of a polyatomic gas in argon on erosion on copper cathodes in a magnetically rotated arc

Experimental results are presented for electrode erosion on copper cathodes in magnetically rotated arcs in argon, dry air, nitrogen, ammonia, and carbon monoxide as well mixtures of the above with argon. Water-saturated argon was also used. Erosion rates were determined by weight loss after chemical cleaning, and the runs were sufficiently long (between 5 to 60 min) to represent steady-state operation. Arc currents of 100 A and gas pressures of 1.1 atm. were used. Pure argon gave the highest erosion rates and the lowest arc velocities. Small concentrations of any of the diatomic gases in argon greatly increased the arc velocity and decreased the erosion rates. The results suggest that erosion is primarily a thermal phenomenon but that the surface chemistry can greatly influence erosion rates by modifying arc behavior.     

Electroreduction of some pyridine carboxamides on carbon electrodes in aqueous solutions

The electroreductions of the NAD⁺ model compounds nicotinamide (I), N₁-methyl nicotinamide (II), N′-methyl nicotinamide (III) and isonicotinamide (IV) on carbon electrodes have been studied in aqueous media in the pH range 0–12 by linear-sweep cyclic voltammetry (Scheme 1, I-IV). Logarithmic analyses of the reduction peaks were performed by computing the convolution of the current with time as a function of the potential. On the basis of the experimental results it was concluded that the irreversibility of the electron transfers increased when a glassy carbon electrode was used, and this irreversibility being more marked when a plastic formed carbon electrode was employed. The reduction processes occurred with more difficulty on carbon electrodes than on mercury electrodes. Both the reduction and the reoxidation (when occurred) processes changed with respect to those observed on mercury electrodes, being irreversible electron transfers the rate-determining steps in most cases. Thus, for compounds I, II and III at pH < 2 the reductions occurred by the uptake of two electrons and two H⁺ ions, and the rate determining step was found to be the first one-electron transfer, for I and III, and the irreversible second electron transfer, preceded by the uptake of an H+ ion, for II. At pH>3 the processes consisted of electrodimerization reactions, preceded by the protonation of the heterocyclic nitrogen in cases I and III. The second electron transfer of the electroreduction of IV always appeared irreversible, in contrast with that found for mercury electrodes.     

The computer program LUDI: A new method for the de novo design of enzyme inhibitors

Summary A new computer program is described, which positions small molecules into clefts of protein structures (e.g. an active site of an enzyme) in such a way that hydrogen bonds can be formed with the enzyme and hydrophobic pockets are filled with hydrophobic groups. The program works in three steps. First it calculates interaction sites, which are discrete positions in space suitable to form hydrogen bonds or to fill a hydrophobic pocket. The interaction sites are derived from distributions of nonbonded contacts generated by a search through the Cambridge Structural Database. An alternative route to generate the interaction sites is the use of rules. The second step is the fit of molecular fragments onto the interaction sites. Currently we use a library of 600 fragments for the fitting. The final step in the present program is the connection of some or all of the fitted fragments to a single molecule. This is done by bridge fragments. Applications are presented for the crystal packing of benzoic acid and the enzymes dihydrofolate reductase and trypsin.     

过渡金属配合物催化剂及其分子设计构思的发展与相互作用

讨论了某些不对称合成和α－烯烃定向配位聚合及α－烯烃氢甲酰化的过渡金属配合物向络合催化剂的发展与催化剂分子设计构思的发展及相互促进作用，并藉以说明过渡金属配合物定向络合物催化剂的分子设计已具备向计算机辅助设计发展的科学基础。