电化学法测定几种稀土贮氢合金的热力学函数

贮氢材料由于能可逆地吸放氢,得到了广泛地应用.特别是以贮氢材料为负极制成的氢镍二次电池,容量为同类型镉镍电池的1.5～2倍,且电压又相近,是镉镍电池的理想换代产品,受到人们普遍的关注。LaNi_(4.5)Mn_(0.5),LaNi_(4.9)Sn_(0.1)和La_(0.8)Nd_(0.2)Ni_(2.5)Co_(2.4)Al_(0.1)是电化学性能较优越的贮氢合金。LaNi_(4.5)Mn_(0.5)的电化学容量高,理论容量可达400mAh.g~(-1).LaNi_(4.9)Sn_(0.1)和La_(0.8) Nd_(0.2)     

Bioelectrochemical Magnetic Immunosensing of Trichloropyridinol: A Potential Insecticide Biomarker

A fast, simple and sensitive bioelectrochemical magnetic immunosensing method is developed to monitor a potential insecticide biomarker, trichloropyridinol (TCP), in environmental sample. A magnet/glassy carbon (MGC) working electrode was used to accumulate immunocomplex associated magnetic beads and separate free and unbound reagents after liquid phase competitive immunoreaction among TCP antibody coated magnetic beads, TCP analyte and horseradish peroxidase (HRP) labeled TCP. The activity of HRP tracers was monitored by square‐wave voltammetry (SWV) by scanning electrocactive enzymatic product in the presence of 3,3′,5,5′‐tetramethylbenzidine dihydrochloride and hydrogen peroxide (TMB‐H₂O₂) substrate solution. The electrochemical signal of enzymatic product was greatly enhanced by dual accumulation events: magnetic accumulation of enzyme tracers bound magnetic beads and constant potential accumulation of enzymatic product. The voltammetric characteristics of substrate and enzymatic product were investigated, and the parameters of SWV analysis and immunoassay were optimized. Under the optimal conditions the immunosensor was used to measure as low as 5 ng L^?1 (ppt) TCP, which is 50‐fold lower than the value indicated by the manufacture of the TCP RaPID Assay kit (0.25 μg/L, colorimetric detection). The performance of the developed immunosensing system was successfully evaluated with river water samples spiked with TCP, indicating this convenient and sensitive technique offers great promise for decentralized environmental application. This technique could be readily used for detection of other environmental contaminants by developing specific antibodies against the contaminants and are expected to open new opportunities for environmental monitoring and public health.     

氰氟草酯及其代谢物在稻田水、土壤和稻株中的残留分析方法

研究并建立了氰氟草酯及其 4种代谢物在稻田水、土壤及稻株中的残留分析方法。在同一色谱分析条件下 ,同时检测 5种化合物 ,样品前处理过程简单 ,方法准确可靠 ,灵敏度和准确度达到了农药残留检测的要求。氰氟草酯及 4种代谢物在上述样品中的最低检知浓度在 0 .0 2～ 0 .0 0 4mg kg之间 ,方法的添加回收率(0 .0 1～ 5mg kg)在 80 .2 %～ 1 0 1 .2 %之间     

Overwhelming electrochemical oxygen reduction reaction of zinc-nitrogen-carbon from biomass resource chitosan via a facile carbon bath method

Developing high efficiency and low cost electrocatalysts is critical for the enhancement of oxygen reduction reaction (ORR), which is the fundamental for the development and commercialization of renewable energy conversion technology. Herein, zinc-nitrogen-carbon (Zn-N-C) was prepared by using biomass resource chitosan via a facile carbon bath method. The obtained Zn-N-C delivered a high specific surface area (794.7 cm²/g) together with pore volume (0.49 cm³/g). During the electrochemical evaluation of oxygen reduction reaction (ORR), Zn-N-C displayed high activity for ORR with an onset potential E₀ = 0.96 V_RHE and a half wave potential E_1/2 = 0.86 V_RHE, which were more positive than those of the commercial 20 wt% Pt/C benchmark catalyst (E₀ = 0.96 V_RHE and E_1/2 = 0.81 V_RHE). In addition, the Zn-N-C catalyst also had a better stability and methanol tolerance than those of the Pt/C catalyst.     

Effects of pretreatments and modifiers on electrochemical properties of carbon paste electrodes

The electrochemical properties of carbon paste electrodes (CPEs), including unmodified and modified with protein and polycations, were investigated by impedance spectroscopy (IS) using ferricyanide and ferrocene monocarboxylic acid (FcMA) as redox probes. Various electrochemical pretreatments were applied to the unmodified CPE. The heterogeneous charge transfer rate constant of ferro/ferricyanide couple is enhanced by 2 to 10 times compared with that obtained at untreated electrodes. It was found that for ferricyanide the more suitable pretreatments are successive cyclic voltammetric scans, cathodization and a square wave-like stepping rather than high-potential anodization. However, the pretreatment only exhibits a slight effect on the kinetics of FcMA. At the CPEs containing modifier, the electron transfer rate of the redox couple depends more on the pH of electrolyte solution if ferro/ferricyanide is used. The results can be explained by the differently charged states of the CPEs that were caused by the protonation or deprotonation of the modifiers in various pH solutions and demonstrate the importance of the electrostatic interaction on the kinetics of the highly polar species such as ferricyanide. The different adsorptive behavior of ferricyanide and FcMA is also discussed.     

Trace determination of nitrated polycyclic aromatic hydrocarbons using liquid chromatography with on-line electrochemical reduction and fluorescence detection

An efficient clean-up procedure coupled with a high performance liquid chromatography (HPLC) with on-line electrochemical (EC) reduction and fluorescence detection (FLD) was developed to quantify nitrated polycyclic aromatic hydrocarbons (NPAHs) in the airborne particulate. In this process, NPAHs were extracted ultrasonically followed by analysis by using a reversed phase column with an aqueous eluent containing 70% aqueous acetonitrile and sodium monocholoroacetate as a buffer solution. The extraction efficiencies were above 83% for 1-nitropyrene and 1,3-dinitropyrene (1,3-DNP) 1,6-DNP, and 1,8-DNP, and calibration graphs were linear with very good correlation coefficients (r>0.999) and the detection limits were in the range of 1.0-2.2 pg for dinitropyrenes and nitropyrene. The proposed method provides a relatively simple and convenient procedure for determining the NPAHs samples in airborne particulate.     

Characterization of PEDOT film functionalized with a series of automated synthesis ferrocenyl-containing oligonucleotides

In previous works we have described a fully automated synthesis of new ferrocene labelled oligonucleotides (Fc-ODNs) probes with one or more electroactive markers at different position in the chain. These Fc-ODNs have shown good properties to detect ODN target in solution. Here we describe the post-functionalization of a conducting co-polymer based on ethylenedioxythiophene (EDOT) derivatives by a series of Fc-ODNs. The grafting of the Fc-ODNs probes resulted in the appearance of the ferrocene redox couple which directly confirm the effectiveness of the ODN anchoring compared to traditional approach based on IR spectroscopy and X-ray fluorescence of the films. Moreover, the electrochemical response of the modified electrodes analysed in organic media before and after hybridization with ODN target confirm that properties obtain in solution for Fc-ODNs already exist in the film. The changes in the current intensity were found to be dependant on the structure of the grafted ODN that validate our strategy to synthesize an optimal Fc-ODNs.     

MH—Ni电池封口化成及其性能

在硼氢化钾碱性溶液中对金属氢化物（ＭＨ）电极的表面进行化学还原处理，提高了ＭＨ电极的放电容量、活化性能和电催化活性．用其为负极组装的ＡＡ型ＭＨ－Ｎｉ电池进行了封口化成，电池放电容量达到１１５０ｍＡｈ，５Ｃ下电池的放电容量达到０．２Ｃ下容量的８０％以上，电池在１Ｃ１００％ＤＯＤ（放电深度）充放电条件下，循环寿命由原来的１００次左右提高到２００次以上     

高富勒烯的提取,分离和分析

采用二硫化碳重结晶富勒烯混合物或二硫化碳二次抽提烟灰以提取高富勒烯（ｈｉｇｈｅｒｆｕｌｅｒｅｎｅｓ，Ｃｎ，ｎ＞７０）。产物经高效液相色谱分析，高富勒烯的含量从１％分别提高到４％和６％；经激光飞行时间质谱证明，产物中除含主要成分Ｃ６０和Ｃ７０以外，还含有Ｃ７６、Ｃ７８、Ｃ８２、Ｃ８４以及更高碳原子的富勒烯。     

Determination of Copper at a Glassy Carbon Electrode Modified with Langmuir–Blodgett Film of p‐tert‐Butylthiacalix[4]arene

A new type of voltammetric sensor, Langmuir–Blodgett film of p‐tert‐butylthiacalix[4]arene modified glassy carbon electrode, was advanced and used for determining copper at trace levels by differential pulse stripping voltammetry. Calibration plot was found to be linear in the range of 2×10^?8 M to 5×10^?6 M; the detection limit was 2×10^?9 M. Possible recognition mechanism was also discussed. From determination of Copper in real samples (river, lake and tap water) it can be concluded that the method is rapid, sensitive in determining of copper and can be used in the analysis of natural water samples.