Determination of ultra-trace gold in natural water by graphite furnace atomic absorption spectrophotometry after in situ enrichment with thiol cotton fiber

A simple method of determining ultra-trace Au in natural water was presented by using graphite furnace atomic absorption spectrophotometry (GFAAS) after in situ enrichment with thiol cotton fiber (TCF). The sample solution was adjusted to pH 1.5-2.0 with HCl, then the water sample was passed through a column packed with 0.10-0.20 g TCF and the flow rate was controlled at 20-40 ml min⁻¹. The effects of interferences, such as complexing and oxidizing agents and other elements adsorbed on TCF were overcome by chemical treatments prior to the desorption of Au. The adsorbed Au was adsorbed with 2.0 ml hot acid, then it was extracted with 1.00 ml methyl isobutylketone (MIBK). For a 5 l water sample, the detection limit of Au is 0.02 ng l⁻¹. The relative standard deviation (R.S.D.) for the determination of 1.44 ng l⁻¹ Au was 9.4%.The method was applied to determine ultra-trace Au both in suspended phase and soluble phase in natural water, the concentrations of total Au in natural water samples range from 0.51 to 67.82 ng l⁻¹. The recovery of added 0.50-6.00 ng l⁻¹ Au was 80-95%. The method is useful in prospecting for Au deposits by means of hydrogeochemical methods. The enrichment is carried out in the field, and then the determination of Au is completed later in the laboratory.     

光传送网中结合传输损伤的路由和波长分配

在波长路由光网优化设计的过程中考虑了物理传输损伤造成的限制,提出了一种联合优化思路.将光信号在传输过程中的物理损伤作为问题公式的另一维约束,给出了相应的启发式算法,并按照由粗到细的机制对所提出的思路做了相应的评估,同时对负荷平衡问题作了初步的分析.数值结果表明这种算法可以获得与优化值相近的波长需求解,并且能够保证网络的传输性能,其业务分布随着备选路径的增加而趋向均衡.     

Wavelength dependence in photochemical vapor deposition of aluminum film using dimethylaluminum hydride

In photochemical vapor deposition of aluminum film on silicon using dimethylaluminum hydride, (CH₃)₂AlH, a surface reaction dominated below a (CH₃)₂AlH pressure of 0.3 m Torr at 200°C, which was induced only with the 160 nm band emitted from a deuterium lamp. A gas-phase reaction occurred above 0.3 mTorr at 200°C, which could be induced by both 160 nm and 240 nm emission bands from the lamp. To distinguish between surface ad gas-phase reactions, a thickness profile was used. At 240°C the surface reaction could be induced even by the 240 nm band, while the deposits formed under illumination of the two bands were thinner than those obtained with only the 240 nm band, indicating occurrence of vacuum ultraviolet (VUV)-enhanced desorption. The mechanism responsible for the observed wavelength dependence in unclear. The electrical resistivity of the films deposited at 200°C was 4.5 μΩ cm, which did not change with wavelength.     

苯并噻唑重氮氨基偶氮苯与汞（Ⅱ）的显色反应及其应用

报道了新试剂苯并噻唑重氮氨基偶氮苯的合成及其与汞（Ⅱ）的显色反应，在ＴｒｉｔｏｎＸ－１００存在下弱碱性介质中，试剂与汞形成２：１的橙红色络合物，最大吸收波长位于５２０ｎｍ处，表观摩尔吸光系数为１．５１×１０＾５Ｌ．ｍｏｌ＾－１．ｃｍ＾－１。汞量在０～１．２ｍｇ／Ｌ范围内遵守比尔定律，直接应用于废水中微量汞的测定，结果满意。     

波长检测技术在温度测量中的应用

提出一种波长检测技术实现温度测量的方法,利用FBG传感器对温度等物理量实施监测,具有测试精度高,应用场合不受限制等特点,当环境参数发生变化时,光纤光栅的有效折射率和光栅周期会受到影响,将引起光纤光栅峰值波长的偏移,依据反射光谱结构的变化,可知道其温度的变化趋势。实验测试结果表明,在温度变化0.1°,波长变化1pm,温度和波长具有良好的线性关系。     

分辨率为1pm的波长监测新方法

在亚毫米尺度金属包覆波导研究基础上，提出了一种波长监测的新方法.实验采用自由空间耦合技术，激发了波导中对波长变化十分灵敏的超高阶导模，并以此为探针，实现了1pm波长漂移的监测. 关键词： 波长监测 金属包覆波导 超高阶导模     

催化动力学光度法测定痕量钴(Ⅱ)

本法基于钴 (Ⅱ )对高碘酸钾氧化孔雀绿的催化作用 ,提出一种灵敏地测定痕量钴 (Ⅱ )的新方法。该方法线性范围在 0～ 0 8μg·2 5mL- 1 ,检测限为 2 1× 10 - 1 0 g·mL- 1 。测定出反应表现活化能Ea=37 94kJ·mol- 1 。此法用于茶叶、维生素B1 2 中钴的测定 ,结果满意     

新颖的PPLN电光开关

在分析基于级联二阶非线性效应的准相位匹配周期极化铌酸锂(PPLN)波导全光波长变换器的有关参量容限的基础上,提出PPLN波长变换器的电光调控设想,并给予简要论证,论证结果是可行的,从而可实施电控调谐来自动补偿其失配,进而也可实现光开关的功能 关键词： 准相位匹配 周期极化铌酸锂 波长变换 光开关 电光效应调控     

荧光波长对共焦显微镜成像特性的影响

导出了共焦显微镜中不同荧光波长情况下的荧光功率传输函数、三维脉冲响应函数（3D－PSF）和三维光学传递函数（3D－OTF）。结果表明，不同的荧光波长对共焦显微镜的空间截止频率、分辨率、光学传递函数存在明显的影响。当激发波长与荧光波长的比值下降到一定程度时，可以看到明显的失锥现象。     

饮食中微量元素砷的分布规律与人体健康关系

采用催化动力学光度法测定了六大类(共三十种)样品中的总砷含量，探讨了砷在食品中的分布规律，建立了砷在人体中的安全系效和积累系效的效学评价公式，用于评价砷与人体健康的关系，这对人们选择食物有一定的指导意义。