Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals in environmental samples

Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals (Co, Cd, Cr, Cu, Mn, Ni, V, Ce, Dy, Eu, La and Yb) in environmental samples was described. Possessing a high adsorption capacity towards the metal ions, mesoporous titanium dioxide has found to be of great potential as an adsorbent for the preconcentration of trace metal ions in samples with complicated matrix. The experimental parameters including pH, sample flow rate, volume, elution and interfering ions on the recovery of the target analytes were investigated, and the optimal experimental conditions were established. Under the optimized operating conditions, a preconcentration time of 90 s and elution time of 18 s with enrichment factor of 10 and sampling frequency of 20 h⁻¹ were obtained. The detection limits of this method for the target elements were between 0.03 and 0.36 μg L⁻¹, and the relative standard deviations (R.S.D.s) were found to be less than 6.0% (n =7, c =5 ng mL⁻¹). The proposed method was validated using a certified reference material, and has been successfully applied for the determination of the afore mentioned trace metals in natural water samples and coal fly ash with satisfactory results.     

Application of amperometric sol-gel biosensor to flow injection determination of glucose

A glucose biosensor with enzyme immobilised by sol–gel technology was constructed and evaluated. The glucose biosensor reported is based on encapsulated GOX within a sol–gel glass, prepared with 3-aminopropyltriethoxy silane, 2-(3,4-epoxycyclohexyl)-ethyltrimetoxy silane and HCl. A flow system incorporating the amperometric biosensor constructed was developed for the determination of glucose in the 1×10⁻⁴–5×10⁻³ mol l⁻¹ range with a precision of 1.5%. The results obtained for the analysis of electrolytic solution for iv administration and human serum samples showed good agreement between the proposed method and the reference procedure, with relative error <5%.     

流动注射在线共沉淀预富集火焰原子吸收法测定痕量铜

研究了以Ｎｉ＾２＋－ＤＤＴＣ为共沉淀载体，流动注射在线共沉淀预富集－火焰原子吸收光谱法测定痕量铜的体系，在０．３ｍｏｌ．Ｌ＾－１的硝酸介质中，铜离子在编织反应器中与Ｎｉ＾２＋－ＤＤＴＣ（产生共沉淀，并被收集在编织器内壁上，用甲基异丁基酮（ＭＩＢＫ）在线洗脱沉积物并引入火争原子化器中测定。当富集时间为４０ｓ时，４０μｇ．Ｌ＾－１的铜１０次测定的相对标准偏差为３．０％，灵敏度提高６０倍，检出限（３σ）     

纳米CoHCF修饰电极的制备及其对血红蛋白的电化学测定研究

A cobalt hexacyanoferrate （CoHCF） nanoparticle （size ca. 60 nm） chemically modified electrode （CME） was fabricated and the electrochemical behavior of hemoglobin （Hb） at this nanosized CoHCF CME was studied. In comparison with a bare glassy carbon electrode （GCE） and a general CoHCF CME electrodeposited in a traditional manner, the present nanosized CoHCF CME performed efficiently electrocatalytic reduction for Hb with relatively high sensitivity, stability, and longlife, Combined with liquid chromatography （LC）, the nanosized CoHCF CME was used as the electrochemical detector of Hb in the established flow injection analysis-electrochemical determination （FIA-ECD） system. The peak current was a linear function of concentrations in the range from 2.5×10^-8 to 5.0×10^-6mol/L for Hb, with detection limit of 1.4×10^-8 mol/L. The FIA-ECD system has been successfully applied to assess the Hb content of clinic blood samples with advantages of sensitiveness, speediness, easy control and small sample-consumption.     

NdOx作为助催化剂对PtRu/C电催化氧化甲醇活性的影响

采用沉积-还原法制备了PtRu-NdOx/C催化剂, 借助TEM、EDS和XRD等测试手段对其进行了微结构和组成的表征. 结果表明, 催化剂中Pt与Ru以合金形式存在, 而Nd的氧化物则以无定形形态存在. 催化剂粒子的平均粒径在2 nm左右, 晶胞参数为0.3896 nm, Nd氧化物的加入对PtRu合金的晶体结构影响不明显. 采用循环伏安法和计时电流法, 比较了PtRu-NdOx/C催化剂和PtRu /C催化剂对甲醇氧化的电催化活性, 结果表明, 加入Nd的氧化物作为助催化剂能明显提高PtRu /C催化剂对甲醇氧化的电催化性能.     

芯片式流通池顺序注射可更新表面反射光谱法用于酶反应检测

将芯片式流通池顺序注射可更新表面反射光谱法用于酶反应检测。HRP催化H2O2氧化BPR底物的反应用于对H2O2的检测。此反应体系与葡萄糖氧化酶联用，用于对血清中葡萄糖的检测。     

电化学检测在流动注射分析中的应用

评述了近几年来电化学检测在流动注射分析中的应用，展望了流动注射电化学分析法的发展动向。     

A direct quantitative analysis method for monitoring biogenic volatile organic compounds released from leaves of Pelargonium hortorum in situ

A direct quantitative method is presented that is based upon the use of multiple headspace solid phase microextraction (HS-SPME) to monitor biogenic volatile organic compounds (BVOCs) released from a living leaf of Pelargonium hortorum in situ. Seventeen BVOCs were detected by GC-MS after a single SPME extraction using a CAR/DVB/PDMS fibre. An internal standard was employed to determine the absolute amounts of seven terpenoid compounds released from a P. hortorum leaf. The quantitative analysis was performed over two days, with extraction preformed for 20 min every 3 h. The amount of volatiles extracted varied with the time of day, with two maxima recorded at 14:00 (day 1) and 17:00 (day 2), corresponding to 236 and 277 ng of the seven terpenoids recorded, respectively. These results indicate that multiple HS-SPME in combination with an internal standard is a simple, quick, and quantitative technique for analysising BVOC emissions from a live plant sample.     

Voltammetric Detector for Liquid Chromatography: Determination of Triclosan in Rabbit Urine and Serum

A flow-electrolytic cell containing a strand of carbon fibers has been designed and characterized for use in a voltammetric detector for high-performance liquid chromatography. The detector was used for determination of triclosan (2,4,4-trichloro-2-hydroxydiphenyl ether) in rabbit serum and urine. Analysis of rabbit serum and urine 1 day and 1 to 5 days, respectively, after ingestion of oral triclosan revealed that the concentration of triclosan was higher than for control serum and urine. The concentration reached maximum levels after 6 h and 34 h or 44 h in serum and urine, respectively. When triclosan was determined in rabbit samples with the method proposed the results obtained were comparable with those obtained by high-performance liquid chromatography with ultraviolet detection.     

直接甲醇燃料电池阴极电催化剂的研究进展

直接甲醇燃料电池(DMFC)功率密度高，燃料甲醇价格低廉、储存和携带方便，特别适合作为电动车和小型电子设备的电源，是目前燃料电池研究领域的一个热点。本文介绍了40年来DMFC阴极电催化剂的发展历史及现状，并针对目前严重影响DMFC性能的“甲醇透过”问题，阐述了研制耐甲醇阴极电催化剂的重要性，讨论了今后DMFC阴极电催化剂的发展趋势。