Optimization of a portable microanalytical system to reduce electrode fouling from proteins associated with biomonitoring of lead (Pb) in saliva

There is a need to develop reliable portable analytical systems for on-site and real-time biomonitoring of lead (Pb) from both occupational and environmental exposures. Saliva is an appealing matrix since it is easily obtainable, and therefore a potential substitute for blood due to existing reasonably good correlation between Pb levels in blood and saliva. The microanalytical system is based on flow-injection/stripping voltammetry with a wall-jet (flow-onto) microelectrochemical cell. Samples that contain as little as 1% saliva can cause electrode fouling, resulting in significantly reduced responsiveness and irreproducible quantitations. In addition, incomplete Pb release from salivary protein can also yield a lower Pb response than expected. This paper evaluates the extent of in vitro Pb-protein binding and the optimal pretreatment for releasing Pb from the saliva samples. Even in 50% by volume of rat saliva, the electrode fouling was not observed, due to the appropriate sample pretreatment and the constant flow of the sample and acidic carrier that prevented passivation by the protein. The system offered a linear response over a low Pb range of 1-10 ppb, low detection limit of 1 ppb, excellent reproducibility, and reliability. It also yielded the same Pb concentrations in unknown samples as did the ICP-MS. These encouraging results suggest that the microanalytical system represents an important analytical advancement for real-time non-invasive biomonitoring of Pb.     

Flow and Sequential Injection Manifolds for the Spectrophotometric Determination of Captopril Based on its Oxidation by Fe(III)

 Two new simple and rapid methods are reported for the accurate and precise spectrophotometric determination of captopril (CPL) using flow (FI) and sequential injection (SI) analysis. The methods are based on the fast oxidation of CPL by Fe(III). The produced Fe(II) reacts with 2,2′-dipyridyl-2-pyridylhydrazone (DPPH) in acidic medium to form a colored complex which is monitored spectrophotometrically at 535 nm. Both methods allow the determination of the analyte up to 1000 mg L⁻¹ at a sampling rate of 120 and 60 injections per hour for FI and SI, respectively. The methods are very precise [s _r=0.8 and 1.2% at 500 mg L⁻¹ CPL (n=12) for FI and SI, respectively] and the 3σ detection limits (c _L=4.0 and 7.0 mg L¹, respectively) are quite satisfactory. Their application to a variety of anti-hypertensive commercial pharmaceutical formulations showed excellent results (relative errors, e _r, < ± 1.6% in all cases compared to an official HPLC method), while common pharmaceutical excipients were found not to interfere. Recovery experiments further verified the accuracy of the developed methods, as the percent recoveries were in the range of 98.1–102.5%. Author for correspondence. E-mail: themelis@chem.auth.gr Received May 9, 2002; accepted January 8, 2003 Published online May 5, 2003     

Analysis of the disaccharides derived from hyaluronic acid and chondroitin sulfate by capillary electrophoresis with sample stacking

CE conditions for monitoring the unsaturated disaccharides of hyaluronic acid (di-HA) and chondroitin sulfate (di-CS) using an alkaline tetraborate buffer, electrokinetic sample injection, and UV absorption detection at 232 nm are reported. Separations were performed in an uncoated fused-silica capillary having reversed polarity and reversed electroosmosis generated with the addition of CTAB to the buffer. The influence of various separation parameters, including the concentration of CTAB, buffer pH, concentration of tetraborate, and applied voltage, on the resolution of the two disaccharides was investigated. Baseline separation was obtained with 25 mM tetraborate at pH 10.0 and having 0.05 mM CTAB. Chloride and phosphate in the sample are beneficial for the stacking of the disaccharides, with di-HA forming a much sharper peak than di-CS. Using samples prepared in 25 mM Tris-HCl (pH 7.5) and electrokinetic injection at the cathode at -10 kV for 40 s, linear relationships between the corrected peak area and the concentration of the disaccharides have been found in the ranges of 1.0-400.0 and 0.1-1.0 microg/mL (0.2-1.0 microg/mL for di-CS), with correlation coefficients being >0.9933 in all cases. The RSDs of detection times and corrected peak areas were between 1.13-1.24 and 1.57-2.13%, respectively. Applied to human serum samples that were prepared by ethanol precipitation and depolymerization of the two polysaccharides with chondroitinase ABC reveals comigration of endogenous compounds with di-HA and a sample-dependent detection time. The di-HA content in the serum sample can be estimated via subtraction of the blank peak that is obtained without enzymatic hydrolysis.     

Determination of Gossypol in Trace Level by Flow Injection Analysis with Chemiluminescence Detection

Gossypol, [1, 1′, 6, 6′, 7,7′-hexahydroxyl-5,5′-diisopropyl-3,3′-dimethyl-(2,2′-binaphtha- lene)-8,8′-dicarboxaldehyde] is a polyphenolic yellow compound naturally occurring in various parts of cotton plants1. The compound has been associated with     

尿中肌酐的流动注射分析

本文提出了一种简便快速的尿中肌酐的测定方法。采用空气整段间隔试样带的流动注射分析体系,在非化学反应平衡的条件下测定,尿样不经手工稀释可直接用于测定。测样频率每小时为90次,相对标准偏差为1.5%。     

流动注射分光光度法测定微量铜的研究

研究了在ＴｒｉｔｏｎＮ－１０１存在下，２－羟基－３－羧基－５－磺酸基苯重氮氨基偶氮苯（ＨＣＳ－ＤＡＡ）显色流动注射光度测定微量铜的新方法，用ｐＨ０．４～１１．５Ｎａ２Ｂ４Ｏ７－ＮａＯＨ缓冲溶液作载流，ＨＣＳＤＡＡ和ＴｒｉｔｏｎＮ－１０１的混合试剂作试剂流，采双道流路，５３０ｎｍ检测反应生成红色配合物，方法线性范围是０．０２４～０．２０μｇ／ｍＬ，检出限为８ｎｇ／ｍＬ，进样频率为１００样次／ｈ，直接     

铁(Ⅲ)-邻菲啰啉体系流动注射-分光光度法测定药品中的抗坏血酸

本文基于抗坏血酸还原铁(Ⅲ)-邻菲啰啉为红色铁(Ⅱ)-邻菲啰啉,建立了流动注射分光光度法测定药品中抗坏血酸的方法。本法体系简单,操作方便、快速,标准加入试验的回收率为92～103％。     

Homogeneous chemiluminescence system in neutral and near neutral aqueous solution with ClO2 as oxidant and its analytical application

Using ClO₂ as chemiluminescence (CL) oxidant, a novel homogeneous CL system in neutral and near neutral aqueous solution is proposed in this paper. ClO₂ could oxidize sulfite in pH 5.0–8.5 acetate buffer to produce CL emission, and pipemidic acid could sensitize the CL system. The ClO₂–SO₃²⁻–pipemidic acid reaction was used as a model CL system and explored the possibility of highly active and eco-friendly ClO₂ being used as CL oxidant in neutral and near neutral aqueous solution. Combined with flow-injection analysis, the proposed CL system was applied to the automated dissolution testing of pipemidic acid tablet. Compared with the common strong acidic or strong basic CL system, this proposed CL owns its advantages.     

流动注射化学发光法测定甲氨蝶呤

研究了甲醛增强高锰酸钾与甲氨蝶呤的化学发光反应，由此建立了一种测定甲氨蝶呤的流动性注射化学发光分析法，方法的检出限为３．４×１０＾－９ｇ／ｍＬ，相对标准偏差为１．１％（２．０×１０＾－６ｇ／ｍＬ甲氨蝶呤，ｎ＝１１）线性范围为１．０×１０＾－８～１．０×１０＾－５ｇ／ｍＬ。该法已用于甲氨蝶呤针剂及片剂中甲氨蝶呤含量的测定。     

人尿中诺龙和炔诺酮代谢物的气相色谱-质谱分析

本文对合成的19-去甲雄烷醇酮的四个差向异构体混合物进行气相色谱分离,对诺龙和炔诺酮用药后,留取的人尿样通过化学预处理,MSTFA/TMSI衍生化反应,GC/MS分析,确证了尿样中诺龙的两个主要代谢产物为19-去甲雄酮和19-去甲原胆烷醇酮,炔诺酮的两个主要代谢物是四氢炔诺酮(THINE)的两个形式,可能是3α-OH-5α-THINE和3α-OH-5β-THINE,在炔诺酮代谢前期,还发现有诺龙的上述两个代谢物存在。