HPLC法测定阿奇霉素葡萄糖注射液中阿奇霉素的含量

利用高效液相色谱法，以VP-ODS型色谱柱，乙腈-异丙醇-水-氨水（60：25：15：0.1)为流动相，于210nm波长处测定了阿奇霉素葡萄糖注射液中阿奇霉素葡萄糖注射液中阿奇霉素的含量。阿奇霉素的浓度在0.75-1.75mg/mL线性关系良好，线性方程的A=881910.4c-16208.2，相关系数r=0.9999。阿奇霉素的平均回收率为99.59%，测定结果的相对标准偏差为1.31%。     

A tentative approach to the direct simulation of drag reduction by polymers

An efficient technique for drag reduction uses dilute solutions of a few p.p.m. of polymers. A possible reduction in drag of up to 80% is achieved. Several experimental observations have been made which tend to indicate that the polymers modify the turbulence structures within the buffer layer. Flow visualisations have shown that the changes consist of a weakening of the strength of the streamwise vortices. Existing literature reveals no attempts of numerical simulation of this phenomenon. In this paper an approach is pursued by using a constitutive equation which relates the elongation viscosity to the local properties of the flow. According to this model this viscosity is large in zones where the amount of strain rate is greater than the amount of vorticity, and is zero when the vorticity exceeds the strain rate. Simulations have been performed in a “minimal channel” to give good resolution with a limited number of grid points. The accuracy of the method is tested by comparison with the results of other techniques. For simulations with polymers, quantitative comparisons cannot be made, but the results reproduce the qualitative outputs of the experiments. The mean streamwise velocity is modified in the buffer layer; the peak of the streamwise turbulent intensity, in wall units, increases and its maximum moves far from the wall; and the vertical turbulent intensity is largely reduced in the wall region. An interesting outcome from both the simulation and the experiments is that the strength of the longitudinal vortices is reduced when the polymers are present.     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

ECR-SFC轴向注入系统聚束器效率的研究

为了减少目前SFC轴向注入系统中聚束器杂散电场对束流轴向注入效率的影响, 提高新系统中SFC的束流俘获效率, 参考原始设计, 对目前聚束器的电极结构进行了设计改进. 两种情况下的聚束器杂散场对注入效率影响的计算表明, 改进后0B02的聚束效率较目前有较大提高. 同时计算了束流空间电荷效应对聚束效率的影响, 据此对新SFC轴向注入系统中聚束器的位置进行了重新调整.     

Fast Fourier Continuous Cyclic Voltammetry at Gold Ultramicroelectrode in Flowing Solution for Determination of Ultra Trace Amounts of Penicillin G

In this work, for the first time a fast continuous cyclic voltammetry was used as a highly sensitive detection method for Penicillin G in a flow‐injection system. A special computer‐based numerical calculation method (using Fast Fourier Transformation) is introduced here for enhancing the analyte signal and noise reduction. During the measurements, the potential waveform (consists of potential steps for cleaning, stripping and potential ramp) was continuously applied on an Au disk microelectrode (with a radius 12.5 μm in radius). The stripping time was less than 200 ms. Effects of rest potential, sweep rate, and delay time on the sensitivity of the method were investigated. The limit of detection of the method was 1.0 × 10^?11 M. The detection limit of the method is 660 times lower than the most sensitive reported method. The relative standard deviation of the method at 1.0×10^?7 M of Penicillin G was 2.7% for 10 runs.     

一步法合成苯乙烯催化剂表面积炭对活性的影响

应用ＥＳＲ，空气气氛下ＤＴＡ，氢气氛下ＴＰＳＲ，ＩＲ等技术手段，对反应后催化剂的积炭行为进行了研究。结果表明，反应后的催化剂表面不同程度地存在着不同类型和积炭，积炭是催化剂失活的主要原因。     

断续喷洒去溶电热雾化法在电感耦合等离子体原子发射光谱方法中的应用研究

本文所讨论的电热雾化法是采用继续喷洒去溶技术,使试样在石墨炉表面逐步积累的进样方法。文章简要介绍了实验条件的选择和控制以及石墨炉装置的结构,探讨了提高电热雾化法相对检测能力的途径。实验结果表明:谱线黑度值与试样积累时间的对数值之间具有较好的线性关系。     

Measurement of caffeine and five of the major metabolites in urine by high-performance liquid chromatography/tandem mass spectrometry

Analysis of caffeine and its metabolites is of interest with respect to caffeine exposure, for kinetic and metabolism studies and for opportunistic in vivo estimation of drug metabolizing enzyme activity in humans and animals. For the latter, analysis is usually done by high-performance liquid chromatography (HPLC) with UV detection. However, this method is close to the detection limit for certain of the metabolites and requires very long chromatography, 30-60 min. We have developed a fast method for the quantification of caffeine and its metabolites 1-methylxanthine, 1-methyluric acid, 1,7-dimethyluric acid, 5-acetylamino-6-amino-3-methyluracil (AAMU) and 5-acetylamino-6-formylamino-3-methyluracil (AFMU) by HPLC tandem mass spectrometry (MS/MS) in urine that requires only its dilution with buffer and centrifugation before injection into the HPLC/MS/MS system. The chromatography lasts 7 min and is followed by 4.5 min for re-equilibration of the HPLC column, giving a total analysis time of 11.5 min. The method provides a great sensitivity improvement with detection limits for all analytes 相似文献   

流动注射-氢化物发生-原子吸收光谱法测定雪中的微量铅

建立了测定雪中微量铅的流动注射-氢化物发生-原子吸收光谱法。在优化条件下。测定铅的线性范围为0～52．0ng／mL，线性回归方程为A=0．018c 0．016，相关系数r=0．9995，检出限为0．2ng／mL。用于雪中微量铅的测定，加标回收率为94．2％～107．3％，相对标准偏差为1．47％～3．22％。该方法的测定结果与标准加入法基本一致。