Electric field assisted oxygen removal from the basal plane of the graphitic material

We provide a novel strategy to eliminate the epoxy group from the basal plane of graphene platelets. Given that the current reduction methods are unsatisfactory to clean the epoxides or sometimes cause undesirable structure deformations, the proposed strategy restores the original hexagonal carbon network without creating other new defects. To the best of our knowledge, the electric field mediated graphene oxide (GO) reduction has not yet been systematically investigated. The capability would permit the improvement of existing GO reduction methods and assist in the fabrication of high‐quality graphitic materials. © 2012 Wiley Periodicals, Inc.     

缓慢炭化部分氧化对制备煤质活性炭的影响

研究了炭化升温速度、炭化低温区引入空气部分氧化对活性炭制备过程中炭化阶段、炭化物结构、活性炭性能等的影响。结果表明，炭化时低温部分氧化可提高炭化物得率，使炭化物微晶的ｄ００２值升高和Ｌｃ值减小；而较慢的炭化升温速度有利于制备优质活性炭。缓慢炭化、部分氧化可以在一定程度上控制炭化路径，使炭化向生成取向性差、难石墨化、各向同性、呒定形炭多的炭化物的方向进行；并讨论了它们控制炭化的作用机理。以此为指导，     

直接酯化法合成PET反应条件对树脂结晶速率的影响

用直接酯化法合成了聚对苯二甲酸乙二酯（ＰＥＴ）。对缩聚反应温度、真空度及稳定剂等合条件对产物结晶速率的影响进行了研究。以ΔＴｃ＝Ｔｃ－Ｔｇ和ΔＴｃｏ＝Ｔｃｏ－Ｔｇ表征样品的结晶速率。结果表明，真空度一定，反应温度高则样品结晶速率慢；温度一定，真空度高样品结晶速率也慢。这两个因素的影响均是不可忽视的。     

Pattern of separatrices and intrinsic reaction coordinates for degenerate thermal rearrangements

A structurally stable model of the standard adiabatic gradient field of the potential energy surface for certain pericyclic reactions is derived.These reactions are not subjected to the principles of orbital isomerism or to the Woodward-Hoffmann rules.Use is made of a principle established by Ariel Fernández and Oktay Sinanolu which precludes direct meta-IRC connections between transition states.It is shown that Jahn-Teller isomers of the singlet biradicals involved in the process are not interconvertible since the biradical configuration is not a transition state but a critical point with Hessian matrix with two negative eigenvalues.The topological features of the PES obtained by combinatorial methods are in full agreement with earlier results obtained from MINDO calculations.     

废塑料-煤共处理液化的研究进展

煤和废塑料共处理液化是一种新的煤直接液化技术,它的主要特点是利用废塑料作为主要的氢来源,本文介绍了目前已取得的一些主要进展,并指出了下一步工作的方向。     

An NMR study of methanol diffusion in polymer electrolyte fuel cell membranes

Methanol diffusion in two polymer electrolyte membranes, Nafion 117 and BPSH 40 (a 40% disulfonated wholly aromatic polyarylene ether sulfone), was measured using a modified pulsed field gradient NMR method. This method allowed for the diffusion coefficient of methanol within the membrane to be determined while immersed in a methanol solution of known concentration. A second set of gradient pulses suppressed the signal from the solvent in solution, thus allowing the methanol within the membrane to be monitored unambiguously. Over a methanol concentration range of 0.5–8 M, methanol diffusion coefficients in Nafion 117 were found to increase from 2.9 × 10⁻⁶ to 4.0 × 10⁻⁶ cm² s⁻¹. For BPSH 40, the diffusion coefficient dropped significantly over the same concentration range, from 7.7 × 10⁻⁶ to 2.5 × 10⁻⁶cm² s⁻¹. The difference in diffusion behavior is largely related to the amount of solvent sorbed by the membranes. Increasing the methanol concentration results in an increase in solvent uptake for Nafion 117, while BPSH 40 actually excludes the solvent at higher concentrations. In contrast, diffusion of methanol measured via permeability measurements (assuming a partition coefficient of 1) was lower (1.3 × 10⁻⁶ and 6.4 × 10⁻⁷ cm² s⁻¹ for Nafion 117 and BPSH 40 respectively) and showed no concentration dependence. The differences observed between the two techniques are related to the length scale over which diffusion is monitored and the partition coefficient, or solubility, of methanol in the membranes as a function of concentration. For the permeability measurements, this length is equal to the thickness of the membrane (178 and 132 μm for Nafion 117 and BPSH 40 respectively) whereas the NMR method observes diffusion over a length of approximately 4–8 μm. Regardless of the measurement technique, BPSH 40 is a greater barrier to methanol permeability at high methanol concentrations.     

Simultaneous determination of hydride (Se) and non-hydride-forming (Ca,Mg, K,P, S and Zn) elements in various beverages (beer,coffee, and milk), with minimum sample preparation,by ICP–AES and use of a dual-mode sample-introduction system

A method has been developed enabling direct analysis (i.e. after dilution only) of beer, instant coffee, milk, and milk powder by ICP–AES. Analysis of the beverages after dilution with a low concentration of HNO₃ was used for accurate determination of essential minor and trace elements (Ca, Mg, K, P, S, and Zn). Selenium, introduced as the hydride, was determined simultaneously with the other non-hydride-forming elements using the commercial multi-mode sample-introduction system (MSIS). To obtain accurate results, however, some simple pre-treatment was needed. Analysis was also performed after microwave-assisted decomposition of the samples. Three different modes of sample-preparation, i.e. dilution only, partial decomposition (aqua regia treatment), and complete decomposition were compared. The results obtained by use of the three different sample-preparation methods were in very good agreement. Results from analysis of certified reference material (SRM 1459 non-fat milk powder) also verified the accuracy of the methods. The limit of detection obtained for Se using dual-mode sample introduction was 0.5 ng mL^–1, which corresponds to approximately 2 ng g^–1 in beer and approximately 4 ng g^–1 in coffee and milk when using the recommended procedure.     

直接甲醇燃料电池用磺化聚醚醚酮膜初探

应用电化学方法研究了SPEEK膜的甲醇渗透性能.SPEEK膜具有比Nafion115膜低的甲醇渗透.以其作质子交换膜电解质组装的直接甲醇燃料电池(DMFCs)开路电压高于Nafion115膜组装的DMFC开路电压,但电池的放电性能尚待改进.本研究可为SPEEK应用于直接甲醇燃料电池提供一定的依据.     

直接甲醇燃料电池催化活性层的优化

本文考察了直接甲醇燃料电池 (DMFC)不同催化剂载量的膜电极性能 .对催化剂层中Nafion含量进行优化 ,研究了Nafion含量对电池的阻抗的影响 .实验发现 :DMFC适宜的阳极Pt_Ru/C载量为Pt 4mg/cm2 、Nafion质量百分含量为 2 1.4 % ;高电流密度下 ,阴极Pt/C载量为Pt4mg/cm2 、Nafion质量百分含量为 2 1.4 %时 ,有较好的放电性能 ,继续增加Nafion含量 ,阴极的欧姆极化和浓差极化增大 ,电池性能下降     

Application of the semilocalized approach to chemical reactivity of butadiene

The semilocalized approach to chemical reactivity (J. Mol. Struct. (Theochem) 588 (2002) 99; Int. J. Quant. Chem. 94 (2003) 302) is applied to study the addition reaction of an electrophile or nucleophile to the butadiene molecule. In accordance with the classical concept of the reaction center and its neighborhood (substituent), only one of the two H₂C=CH-fragments of butadiene is supposed to be under a direct attack of the reagent, whereas the remaining H₂C=CH-group is assumed to play the role of the substituent and thereby to participate in the process indirectly by exerting certain electron-donating or accepting effect upon the former group and/or the reagent. The main aim of the study consists in revealing the role of the H₂C=CH-substituent in the formation of the known higher reactivity of the terminal carbon atom of the attacked C=C-bond (as compared to the internal atom) irrespective of the nature of the reagent. To this end, we seek to obtain an explicit algebraic representation of the interdependence between the direction and the extent of the total influence of the H₂C=CH-substituent, on the one hand, and the nature of the reagent, on the other hand. The expressions for electron density and bond order redistributions among separate fragments of contacting molecules derived previously in the form of power series are shown to yield the above-anticipated representation. On this basis, it is demonstrated that the electron-donating effect of the initially occupied (bonding) orbital of the substituent and the electron-accepting effect of its initially vacant (antibonding) orbital upon the remaining fragments of the whole reacting system may be considered independently whatever the nature of the reagent. However, a strong interdependence is established between the actual relative extents of these two components of the total effect of the H₂C=CH-group and the electron-donating (accepting) properties of the reagent. Moreover, this group of atoms is shown to manifest itself as an electron-donating (accepting) substituent under influence of an electrophilic (nucleophilic) attack. Using this principal result of the paper, the actual reactivity of butadiene with respect to electrophile (nucleophile) is interpreted by invoking a model system of a substituted ethene containing a simple (one-orbital) electron-donating (accepting) substituent, and a terminal addition easily follows for both types of the reagent.