Low-energy ion-assisted control of interfacial structures in metallic multilayers

A molecular dynamics method has been used to simulate the argon ion-assisted deposition of Cu/Co/Cu multilayers and to explore ion beam assistance strategies that can be used during or after the growth of each layer to control interfacial structures. A low-argon ion energy of 5–10 eV was found to minimize a combination of interfacial roughness and interlayer mixing (alloying) during the ion-assisted deposition of multilayers. However, complete flattening with simultaneous ion assistance could not be achieved without some mixing between the layers when a constant ion energy approach was used. It was found that multilayers with lower interfacial roughness and intermixing could be grown either by modulating the ion energy during the growth of each metal layer or by utilizing ion assistance only after the completion of each layers deposition. In these latter approaches, relatively high-energy ions could be used since the interface is buried and less susceptible to intermixing. The interlayer mixing dependence upon the thickness of the over layer has been determined as a function of ion energy.     

Particle multiplicities in the fission-like reactions of 340 MeV Si on Th

Pre-scission and post-scission multiplicities of neutrons and alpha particles have been simultaneously measured for the fission-like reactions of 340 MeV ²⁸Si on ²³²Th. Dynamical model calculations using HICOL code predict that about 90% of the observed events are of quasi-fission type while the remaining 10% are from compound nucleus fission decay. Moving source fits were carried out to the observed neutron and alpha particle spectra, measured at different angles with respect to the fragment directions. The pre-scission and post-scission neutron multiplicities are deduced to be 8.7±2.0 and 9.4±2.0, respectively. The corresponding multiplicity values for alpha particles are found to be 0.22±0.08 and 0.1±0.03. From the measured post-scission neutron multiplicity, it is inferred that about 65±20 MeV of the initial excitation energy remains at scission. This may be compared to the value of 85±30 MeV estimated from PACE2 statistical model calculations, adjusted to reproduce the measured pre-scission neutron multiplicity. From a comparison of the Statistical Model predictions with the measured pre-scission neutron multiplicity, the fission delay is estimated to be of 5⁺⁷₋₃×10⁻²⁰ s which overlaps with the average duration of fission-like process from the contact to the scission point (2×10⁻²⁰ s) as determined from HICOL-based dynamical calculations. For the delay time deduced as above, the pre-scission alpha particle multiplicity calculated by the PACE2 code is about a factor two larger than the experimental one, demonstrating the difficulties in modelling the alpha particle emission from highly elongated shapes that characterize the fissioning system from the contact point to scission.     

Relativistic Dynamics in Basic Chemistry

This paper revisits the historical sequence in which some of the major developments of 20th-century physics occurred, and explores how theories could have turned out differently, if the sequence of developments had been different. It shows how a delay in founding special relativity theory until after (1) at least one puzzling problem in electromagnetic theory could be acknowledged, and (2) sat least some of the experimental observations pertinent to the development of quantum mechanics had become well known, could have resulted in a larger theory that covers both domains in a manner quite different from that of any of the theories we use today. The revised theory dispenses with a separate postulate introducing Planck’s constant h, identifying instead a physical mechanism that implies the constant. Some important aspects of quantum chemistry then follow. Editor, Galilean Electrodynamics, Proceedings of the Natural Philosophy Alliance; Visiting Industry Professor, Tufts University, retired     

H andH NMR Relaxation in Hydrogen-Bonded Solids Due to a Complex Motion: Classical Jumps over a Barrier and Incoherent Tunneling

Equations for the temperature dependence of proton and deuteron spin–lattice relaxation rates and second moments due to a complex motion consisting of classical jumps over a potential barrier and quantum mechanical tunneling through the barrier have been derived. Asymmetric double and triple potential wells are considered. These equations have been employed to analyze proton spin–lattice relaxation data for solid naphthazarin in the laboratory and rotating frames as a function of temperature. It is shown that tunneling plays an important role in the proton transfer dynamics of this compound.     

Application of the stabilization method to interacting resonances

The stabilization method is applied to the case of interacting resonances in the photo-dissociation of van der Waals clusters composed by a rare gas atom bound to a dihalogen molecule. The study of an illustrative two-dimensional model consisting in a T-shaped NeI₂ molecule shows the adequacy of the method whenever the projection of the stabilization wave functions on the assumed prepared initial state is accounted for. The agreement of the fragmentation cross-sections with some previous results using the effective resolvent method and accurate close-coupling calculations is excellent. The method reveals its utility as a complementary tool since allows, through the analysis of the stabilization wave function in terms of zero-order levels, a precise characterization of the resonant states involved. Received 5 April 2002 / Received in final form 24 May 2002 Published online 19 July 2002     

A tentative approach to the direct simulation of drag reduction by polymers

An efficient technique for drag reduction uses dilute solutions of a few p.p.m. of polymers. A possible reduction in drag of up to 80% is achieved. Several experimental observations have been made which tend to indicate that the polymers modify the turbulence structures within the buffer layer. Flow visualisations have shown that the changes consist of a weakening of the strength of the streamwise vortices. Existing literature reveals no attempts of numerical simulation of this phenomenon. In this paper an approach is pursued by using a constitutive equation which relates the elongation viscosity to the local properties of the flow. According to this model this viscosity is large in zones where the amount of strain rate is greater than the amount of vorticity, and is zero when the vorticity exceeds the strain rate. Simulations have been performed in a “minimal channel” to give good resolution with a limited number of grid points. The accuracy of the method is tested by comparison with the results of other techniques. For simulations with polymers, quantitative comparisons cannot be made, but the results reproduce the qualitative outputs of the experiments. The mean streamwise velocity is modified in the buffer layer; the peak of the streamwise turbulent intensity, in wall units, increases and its maximum moves far from the wall; and the vertical turbulent intensity is largely reduced in the wall region. An interesting outcome from both the simulation and the experiments is that the strength of the longitudinal vortices is reduced when the polymers are present.     

Dipole approximation in three-vortex dynamics

We solve the problem of the relative motion of two nearby vortices (a dipole pair) and a third vortex for different current functions. __________ Translated from Teoreticheskaya i Matematicheskaya Fizika, Vol. 150, No. 3, pp. 409–416, March, 2007.     

Charge density effects in salt‐free polyelectrolyte solution rheology

Solution rheology of 2‐vinyl pyridine and N‐methyl‐2‐vinyl pyridinium chloride random copolymers in ethylene glycol was studied over wide ranges of concentration and effective charge. The fraction of quaternized monomers α and the fraction of monomers bearing an effective charge f of these copolymers were measured using counterion titration and dielectric spectroscopy, respectively. Ethylene glycol is a good solvent for neutral poly(2‐vinyl pyridine), with very few ionic impurities. The viscosity η and relaxation time τ of dilute and semidilute unentangled solutions exhibit the scaling with concentration and effective charge expected by the Dobrynin model. Reduced viscosity data are independent of concentration in dilute solution, giving an intrinsic viscosity that depends on effective charge, and the experimental data obey the Fuoss law in the semidilute unentangled regime. Scaling concentration with the overlap concentration (c/c*) reduces these data to common curves, and c* ～ f ^?12/7 as predicted by the Dobrynin model, where f is the fraction of monomers bearing an effective charge. While the overlap concentration depends strongly on effective charge until counterion condensation occurs, the entanglement concentration c_e is surprisingly insensitive to effective charge, indicating that entanglement effects are not understood using the Dobrynin model. The terminal modulus G = η/τ depends only on the number density of chains G = ckT/N for c* < c < c_e, and G ～ c^3/2 for c > c_e independent of the effective charge. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2001–2013, 2006     

Effect of the environment on the stability of surfactant–polypeptide self‐assembled complexes: Molecular dynamics simulations of stoichiometric complexes formed by N‐dodecyltrimethylammonium and poly(α,L‐glutamate) in chloroform,methanol, and water

A series of molecular dynamics simulations have been performed to study the supramolecular structure of self‐assembled complexes formed by N‐dodecyltrimethylammonium cations and the synthetic polypeptide poly(α,L ‐glutamate). The influence of the type of solvent has been investigated, considering explicit environments of chloroform, water, and methanol on a stoichiometric complex containing 15 residues. In chloroform, the complex stabilizes in a regular structure: the polypeptide adopts an α‐helix conformation that is regularly surrounded by surfactant molecules to form electrostatic interactions through a multiple interaction pattern. However, this structure destabilizes in methanol and water: (a) the α‐helix unfolds in the two solvents and (b) the electrostatic links between the surfactant molecules and the polyanion are disrupted in aqueous solution, although these interactions are still preserved in methanol. The role of the solvent environment in stabilizing or destabilizing the polypeptide secondary structure, the organization of the surfactant molecules, and predominantly the surfactant–polypeptide supramolecular organization is discussed in detail. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1122–1133, 2006