Microwave-assisted silica-supported aluminum chloride-catalyzed Friedel-Crafts alkylation

Microwave irradiation is a popular method in organic synthesis to achieve high yields in shorter reaction times. This decreases total ‘man-hours’ in a synthetic setting. Another technique used in organic chemistry to decrease manual manipulations, is solid support reagents. The benefits of this approach is that upon completion of a reaction, a simple filtration can be performed which expedites the work-up and also produces less organic waste. Friedel-Crafts alkylation has been explored using microwave chemistry as well as with solid-supported reagents. In comparison with traditional heating, as well as with AlCl₃, superior yields were observed with silica-gel bound aluminum chloride (Si-AlCl_x) when microwave irradiated for only 5 min.     

One-pot Synthesis of 1,8-Dioxo-decahydroacridine Derivatives in Aqueous Media

A new and efficient method for the synthesis of 1,8‐dioxo‐9‐aryl‐decahydroacridine derivatives was developed via a one‐pot three component reaction of dimedone, aromatic aldehydes and ammonium acetate in the presence of ammonium chloride, or Zn(OAc)₂·2H₂O or L‐proline separately in water in the short period of time and high yields.     

Effect of high-voltage pulses on electrochemical properties of a molten magnesium electrolyte

Effects of high-voltage pulses on electrochemical properties of a molten magnesium electrolyte is studied experimentally. It is established that the electroconductivity of the melt subjected to the pulses and the electrolysis current at a constant voltage increase by up to 25%. The relaxation time of nonequilibrium melt reaches a few tens of minutes and under certain conditions its dynamics is oscillatory.     

Titanocene (III) chloride mediated radical induced synthesis of (−)-methylenolactocin and (−)-protolichesterinic acid

Enantioselective synthesis of two anti-tumor antibiotics, (−)-methylenolactocin and (−)-protolichesterinic acid, has been achieved through titanocene(III) chloride mediated radical cyclization reaction starting from commercially available d-mannitol. Titanocene(III) chloride (Cp₂TiCl) was prepared in situ from commercially available titanocene dichloride (Cp₂TiCl₂) and zinc dust in THF.     

New phosphoroamidate compounds: Synthesis,structural characterization and studies on ZnCl2 assisted hydrolysis of the P–N bond

A variety of phosphorodiamidate compounds were synthesized from the corresponding phosphorodichloridate intermediates and phosphorus oxychloride. These were completely characterized using different spectroscopic methods and single crystal X-ray diffraction studies on one of them. Studies revealed that water in the presence of a mild Lewis acid like ZnCl₂ was found to assist the hydrolysis of the P–N linkage. The proof of this concept was effectively realized through the hydrolysis of hexamethylphosphoramide.     

Study on the new fluorescence enhancement system of Tb-1,10-bis(2′-carboxylphenyl)-1,4,7,10-tetraoxadecane in silver chloride collosol and its analytical application

A new salicylic-based open-chain crown ether ligand, 1,10-bis(2′-carboxylphenyl)-1,4,7,10-tetraoxadecane (BCPTD) was synthesized. Solutions of its complex with Tb³⁺ can emit the intrinsic fluorescence of Tb³⁺. The fluorescence intensity of the complex in KCl solution was enhanced by the addition of silver(I), leading to a new fluorescence enhancement phenomenon. The spectrofluorimetric determination of traces of silver(I) based on the above phenomenon was carried out. The excitation and emission wavelengths are 298 and 545 nm, respectively. Under optimal conditions, the differential value of fluorescence intensity in the absence and presence of Ag⁺ was proportional to the concentration of silver(I) in the range 0.5-20 μg ml⁻¹. The method was applied to the determination of silver(I) in a standard ore sample. The analytical performance is investigated in detail by using common aromatic carboxylic acids or synthetic analogues of BCPTD as ligands to replace BCPTD. It was found that Tb-aromatic acid complexes did not result in fluorescence enhancement of Tb³⁺ in AgCl collosol. The phenomenon was only observed in Tb(III) with BCPTD or its open-chain crown ether analogues solutions.In addition, the enhancement of the fluorescence intensity of terbium(III) in these complexes depends on the extent of formation of the AgCl collosol.     

聚氯乙烯结构缺陷和热不稳定性之间关系的研究 2.各种结构缺陷含量和热脱氯化氢速率之间的关系

本工作采用溴加成法、酚解法、FTIR法及臭氧裂解法分别测定了五种不饱和蒸气压下聚合的PVC样品(u-PVC)和五种商品PVC样品(s-PVC)的总双键、总不稳定氯、孤立双键和内部双键的含量.通过研究结构缺陷和PVC的平均分子量及脱HCl速率的相互关系,揭示了不饱和总双键值,总不稳定氯和孤立双键含量彼此的相关性是建立在它们分别与1/M_n的相关性基础之上,从而得出了这三种定量值测得的主要都是端基烯丙基氯结构.根据三者对脱HCl速率的良好线性相关性,首次提出了端基烯丙基氯结构在HCl催化作用下异构化成内部烯丙基氯从而成为脱HCl速率主要原因的机理.     

Transformed steroids

The approaches to the synthesis of various 16,17-disubstituted pregna-4,9-dien-3,20-diones from the corresponding 9-derivatives with labile epoxide, dioxolane, and oxathiolane ringsD have been studied. The transformation has been found to proceed efficiently when the 9-sulfinic esters are used at the intermediate stage and then elimination of sulfinic acid by TsOH/SiO₂ is carried out.For part 193, see ref. 7.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 983–986, May, 1993.     

Enthalpies of Phase Transitions and Heat Capacity of TbCl3 and Compounds Formed in TbCl3–MCl Systems (M=K, Rb, Cs)

The molar enthalpies of the solid–solid and solid–liquid phase transitions were determined by differential scanning calorimetry for pure TbCl₃ and KTb₂Cl₇, RbTb₂Cl₇, CsTb₂Cl₇, K₃TbCl₆, Rb₃TbCl₆ and Cs₃TbCl₆ compounds. Both types of compounds, i.e. M₃TbCl₆ and MTb₂Cl₇ (M=K, Rb, Cs) melt congruently and show additionally a solid–solid phase transition with a corresponding enthalpy Δ_trs H ⁰ of 6.1, 7.6 and 7.0 kJ mol^–1 for potassium, rubidium and caesium M₃TbCl₆ compounds andΔ_trs H ⁰ of 17.1 (rubidium) and of 12.1 and 10.9 kJ mol^–1 (caesium) for MTb₂Cl₇ compounds, respectively. The enthalpies of fusion were measured for all the above compounds with the exception of Rb₃TbCl₆ and Cs₃TbCl₆. The heat capacities of the solid and liquid compounds have been determined by differential scanning calorimetry (DSC) in the temperature range 300–1100 K. The experimental heat capacity strongly increases in the vicinity of a phase transition, but varies smoothly in the temperature ranges excluding these transformations. C _p data were fitted by an equation, which provided a satisfactory representation up to the temperatures of C _p discontinuity. The measured heat capacities were checked for consistency by calculating the enthalpy of formation of the liquid phase, which had been previously measured. The results obtained agreed satisfactorily with these experimental data. This revised version was published online in August 2006 with corrections to the Cover Date.