The effect of crystallinity on chain mobility and free volume in the amorphous regions of a miscible polycarbonate/polyester blend

Homopolymers and blends of polycarbonate/ThermX have been investigated by differential scanning calorimetry, dynamic mechanical analysis, density measurements, and positron annihilation lifetime spectroscopy. The study focuses on the chain mobility and free volume in the amorphous miscible regions of the blends and how this mobility and free volume are affected by increasing crystallinity. It is proposed that judicious annealing, which results in increasing crystallinity (while avoiding ageing or transesterification), induces a constraint on the amorphous region leading to an increase in T_g and coalescence of free volume sites. © 1994 John Wiley & Sons, Inc.     

Thermal conductivity of poly(vinyl chloride)/polycaprolactone blends

Thermal diffusivity, heat capacity, and density of polyvinyl chloride/polycaprolactone (PVC/PCL) blends were measured by the laser flash method, DSC, and pycnometry, respectively. The thermal conductivity of the PVC/PCL blends was determined from the results. The miscibility of the blend and crystallinity of PCL were determined by DSC. The effect of blend structure on thermal conductivity is discussed. The phase compositions of the PVC/PCL blends are of three types depending on PCL content: i.e., up to 33%, from 33 to 70%, and above 70% PCL by weight. Thermal conductivity, thermal diffusivity, and heat capacity of the PVC/PCL blends are strongly affected by the phase composition of the blend, which changes in a complicated way with PCL content. © 1994 John Wiley & Sons, Inc.     

Photooxidation of aqueous trichloroethylene using a buoyant photocatalyst with reaction progress monitored via micro-headspace GC/MS

Although photooxidation has previously been shown to be successful in removing organic contaminants from water, methods combining the rapid photooxidation of the desired contaminant with easy catalyst manipulation and removal are few and far between. In the absence of an easy means of catalyst removal, the photooxidation process becomes more costly and time consuming, and photocatalysis cannot be employed as an in situ method for the remediation of aqueous organic contaminants. In this study, the photocatalyst was added to an aqueous trichloroethylene (TCE) solution in the form of TiO₂-coated buoyant microspheres. The solution, placed in a flow-cell photoreactor along with the buoyant catalyst, was irradiated with a UV-filtered Xenon light source. Limited sample sizes necessitated the development of a low-cost headspace GC/MS analysis method, utilizing a standard direct-injection autosampler. This analytical technique aptly monitored reaction progress and indicated that aqueous TCE concentration decreases by nearly 90% in the first hour of irradiation. Subsequent solvent extraction GC/MS analysis indicated that the TCE is initially sorbed by the photocatalyst spheres, but as irradiation continued, TCE is removed from the catalyst spheres surfaces. During the course of irradiation, the expected TCE mineralization product hydrochloric acid appeared, as indicated by a decrease in pH and ion chromatography analysis. The microsphere-born catalyst was easily removed from the treated solution by filtration. Thus, it is possible that a method for effective, low-cost in situ photooxidation of aqueous organic contaminants will be realized in the near future.     

鲤鱼体中鱼腥味物质的提取和鉴定

采用同时蒸馏萃取法提取鲤鱼鱼体中的挥发和半挥发性有机物，用GC／MS从提取物中分析鉴定出鱼腥味和疑是鱼腥味物质16种。包括醛、烯醛、酮和呋喃4类化合物。其中己醛、庚醛和2，4-二烯癸醛被确认为鱼腥味的化合物。研究发现，这些物质总量在鲤鱼体的鱼鳞、鱼鳃和鱼肉的分布呈现下降趋势，且其总量与鱼腥味强度之间具有可比较的对应关系。     

示差半微分循环伏安法研究琥珀酰胆碱在水/硝基苯界面的传递行为

研究了油/水界面电解的示差半微分循环伏安行为。在0.01mol/L LiCl(w)-0.01mol/L TBATCIPB(nb)体系“电位窗”比TBATPB(nb)向正方向扩展约50mV,残余电流基本消除,使“电位窗”内的平台向左右拓宽约50mV。算得界面电容约为16μF/cm~2。考察了琥珀酰胆碱离子在w/nb界面的传递伏安特性,结果与一般半微分循环伏安法相似。但峰形改善,检测限降低一个数量级(1×10~(-6)mol/L),相对标准偏差在5％以内,可用于定量测定琥珀酰胆碱。     

Catalytic air oxidation of ambient temperature hydrocarbons

Catalytic air oxidation of the aliphatic hydrocarbons n-decane, hexanes, gasoline and diesel fuel was conducted at ambient temperature with novel iron catalysts. The concentration of n-decane in water was reduced from 1.42 g in 100 ml to 0.07 g in 100 ml in 5 h at room temperature forming carbon monoxide and water by means of intermediate aldehydes. Results of FT–IR and GC–MS analyses demonstrated formation of aldehydes and unsaturated alcohols. Carbon monoxide was detected on catalyst residues and in the vapor phase. The indicated catalytic reaction mechanisms are discussed.     

结构—饱和土壤相互作用的固结有限元分析

讨论了结构与饱和土壤相互作用的固结分析问题.对于结构利用多重子结构分析技术实现向饱和土交界面上的凝聚.从而建立了结构与饱和土壤相互作用的固结控制方程.文中给出了问题求解的一次性算法方案,采取压力主从关系的手段处理边界上的不排水条件.文末给出数值算例.本文工作为大型结构与土体相互作用固结分析研究工作的深入创造了条件.     

Morphology of Nylon-6 blends with styrenic polymers

The morphology of blends of styrenic polymers in a matrix of 75% Nylon-6 prepared in a Brabender Plasti-Corder was examined by scanning electron microscopy. Styrene/acrylonitrile copolymers (SAN) form smaller particles as the AN level increases owing to the corresponding decrease in the SAN–polyamide interfacial tension. Various styrenic polymers containing functional groups, maleic anhydride or oxazoline type, that can react with Nylon-6 during melt processing were added to the SAN phase which also led to a decrease in the particle size owing to the graft copolymer formed in situ. The effects of functional group type, amount of functional groups per chain, amount of functional polymer added, and the miscibility of the styrene/maleic anhydride (SMA) and SAN copolymers on the morphology of the styrenic phase in the Nylon-6 matrix are described. © 1992 John Wiley & Sons, Inc.