Interface Engineering of MoS2/Ni3S2 Heterostructures for Highly Enhanced Electrochemical Overall‐Water‐Splitting Activity

To achieve sustainable production of H₂ fuel through water splitting, low‐cost electrocatalysts for the hydrogen‐evolution reaction (HER) and the oxygen‐evolution reaction (OER) are required to replace Pt and IrO₂ catalysts. Herein, for the first time, we present the interface engineering of novel MoS₂/Ni₃S₂ heterostructures, in which abundant interfaces are formed. For OER, such MoS₂/Ni₃S₂ heterostructures show an extremely low overpotential of ca. 218 mV at 10 mA cm^?2, which is superior to that of the state‐of‐the‐art OER electrocatalysts. Using MoS₂/Ni₃S₂ heterostructures as bifunctional electrocatalysts, an alkali electrolyzer delivers a current density of 10 mA cm^?2 at a very low cell voltage of ca. 1.56 V. In combination with DFT calculations, this study demonstrates that the constructed interfaces synergistically favor the chemisorption of hydrogen and oxygen‐containing intermediates, thus accelerating the overall electrochemical water splitting.     

Two‐Dimensional Core‐Shelled Porous Hybrids as Highly Efficient Catalysts for the Oxygen Reduction Reaction

Two‐dimensional (2D) transition‐metal dichalcogenides (TMDs) have drawn much attention due to their unique physical and chemical properties. Using TMDs as templates for the generation of 2D sandwich‐like materials with remarkable properties still remains a great challenge due to their poor solvent processability. Herein, MoS₂‐coupled sandwich‐like conjugated microporous polymers (M‐CMPs) with high specific surface area were successfully developed by using functionalized MoS₂ nanosheets as template. As‐prepared M‐CMPs were further used as precursors for preparation of MoS₂‐embedded nitrogen‐doped porous carbon nanosheets, which were revealed as novel electrocatalysts for oxygen reduction reaction with mainly four‐electron transfer mechanism and ultralow half‐wave potential in comparison with commercial Pt/C catalyst. Our strategy to core–shelled sandwich‐like hybrids paves a way for a new class of 2D hybrids for energy conversion and storage.     

若丹明B荧光增强二硫化碳高阶受激喇曼散射

 利用若丹明B乙醇溶液的荧光改变了二硫化碳的一至三阶Stokes喇曼谱线的强度分布,选择性地增强了三阶Stokes喇曼谱线。在泵浦功率密度为~560MW^.cm^-2时,对染料摩尔浓度分别为~10^-5、cm^-5散射池和~10^-4、1cm散射池进行实验,观察到二硫化碳的三阶Stokes喇曼谱线与染料激光形成的共振增强现象及、二阶Stokes喇曼谱线的部分或完全耗尽。     

改性活性炭脱除有机硫化物的研究(英文)

考察了在使用改性活性炭脱除有机硫化物的过程中水和温度的影响。研究结果表明,水汽的存在不利于有机胺改性活性炭脱除二硫化碳;Ｋ２ＣＯ３改性活性炭用于脱除碳基硫的实验显示,在３０－６０℃的温度范围内,４０℃最适宜于脱除反应。     

二硫化钼改性热塑性聚酰亚胺复合材料的摩擦磨损性能研究

采用热压成型工艺制备MoS2 填充热塑性聚酰亚胺复合材料,测定了其弯曲强度和压缩强度,采用MPX-2000型摩擦磨损试验机评价MoS2 填充热塑性聚酰亚胺复合材料在干摩擦和水润滑2种工况下的摩擦磨损性能,利用扫描电子显微镜观察和分析材料磨损表面形貌和元素分布.结果表明:与聚酰亚胺树脂相比,加入MoS2后复合材料的弯曲强度和压缩强度有所降低,随着MoS2含量增加,材料的弯曲强度和压缩强度趋于稳定;在干摩擦条件下,MoS2逐步在磨损表面富集,相应的摩擦系数有所降低;MoS2含量为10%时磨损表面仅出现局部熔融,磨损率最低,当MoS2含量为20%时磨损表面出现深度熔融,磨损率较大;在水润滑条件下,MoS2仍起到良好的润滑作用,摩损率较干摩擦条件下降低1个数量级,表现出疲劳磨损特征.     

基于密度泛函理论的DBDS与DBS对铜绕组腐蚀性能对比研究

二苄基二硫醚(DBDS)与二苄基硫醚(DBS)是变压器内部主要腐蚀性硫化物,能腐蚀铜绕组,破坏变压器的安全运行.为从微观层面探究两者腐蚀性能的差异,基于密度泛函理论(DFT)对DBDS与DBS的腐蚀性能进行对比研究.计算了DBDS/Cu(110)吸附模型与DBS/Cu(110)吸附模型的功函变化,发现DBDS/Cu(110)的功函变化ΔΦ_1(-0.388 eV)绝对值要小于DBS/Cu(110)功函变化ΔΦ_2(-1.118 eV)绝对值,说明DBS更易吸附Cu(110)表面;DBDS在Cu(110)表面的吸附能E_(ads1)为8.571 eV,DBS在Cu(110)表面吸附能E_(ads2)为6.077 eV,表明两者都不能自发吸附,需要从外界吸热才能吸附,且DBS从外界获取能量更少,更容易吸附.同时比较了DBDS分子与DBS分子前线轨道分布以及HOMO轨道与LUMO轨道能量差,计算了DBDS分子与DBS分子的电负性,结果表明:DBDS电负性大小为3.132 eV,DBS电负性大小为3.100 eV,两者基本相等.而DBDS前线轨道能量差(2.610 eV)明显小于DBS前线轨道能量差(3.610 eV), DBDS优化前后的S-S键长分别为2.033?和3.057?,说明DBDS更容易与Cu发生反应.以上模拟结果说明,DBS更易吸附于Cu,而DBDS更易与Cu发生反应.     

退火对单层二硫化钼荧光特性的影响

单层二硫化钼是继石墨烯后的一种新型二维材料. 它是一种直接带隙半导体, 具有优异的光电特性, 从而受到人们的广泛关注. 之前的研究报道过单层二硫化钼在氩气中退火后可以提升其A激子峰的荧光强度, 但我们发现, 空气中退火较氩气退火效果更为明显. 本文重点研究了在空气中退火对二硫化钼的荧光特性的影响. 不同条件下制备的单层二硫化钼样品, 经过在空气中退火处理后, 荧光峰位均发生了蓝移, 荧光强度提升了一个数量级. 我们认为, 这是由于空气退火造成二硫化钼缺陷的形成, 大量氧气分子被缺陷束缚并发生电荷转移. 氧气分子充当受主的角色, 起着P型掺杂的作用. 电荷的抽取造成二硫化钼的负电激子减少, 中性激子增多, 提升了其荧光量子效率. 我们在对照实验中发现, NH₃吸附在二硫化钼表面时, 荧光强度下降, 峰位红移, 这是由于NH₃分子充当施主的角色, 造成负电激子增多, 中性激子减少. 本文为提高单层二硫化钼的荧光量子效率提供了一种简单有效的方法.     

扶手椅型缺陷硫化钼纳米带电子性质的第一性原理计算

基于密度泛函理论的第一性原理计算,研究了含空位缺陷的扶手椅型二硫化钼纳米带的电子性质.发现缺陷会导致纳米带结构稳定性降低,单空位钼缺陷和三空位缺陷使得纳米带从半导体变成金属性,而单空位硫缺陷和两种双空位缺陷仅减小纳米带的带隙;电子态密度和能带的本征态表明缺陷纳米带费米能级附近的杂质态主要是缺陷态的贡献.研究了四类半导体性质的纳米带带隙与宽度的关系,对于完整的纳米带,带隙随宽度以3为周期振荡变化;而引入空位缺陷后,纳米带的带隙振荡不再具有周期且振荡幅度变小.同时发现,当缺陷的浓度变小后,缺陷仅使纳米带的带隙减小,不会使其变为金属性.这些结果有望打开其在新型纳电子器件中的应用潜能.     

Design,Synthesis and Antitumor Activity of Novel 6,7-Dimethoxyquinazoline Derivatives Containing Diaryl Urea Moiety

A series of 6,7-dimethoxyquinazoline derivatives connected by diaryl urea scaffolds was designed, synthesized and their in vitro antitumor activities were evaluated. Most of them showed an excellent potency against the four tested cancer cell lines as compared with sorafenib. Particularly, a promising compound 20 was identified, which showed the most potent antitumor activities with IC₅₀ values of 0.08, 0.09, 0.16 and 0.19 μmol/L against H460, HT-29, MKN-45 and MDA-MB-231 cell lines, respectively. The structure-activity relationship(SAR) analysis indicated that compounds with dimethylamino or diethylamino group at the C4 position of 6,7-dimethoxyquinazoline moiety exhibited superior activities than compounds bearing morpholino groups.     

纳米银催化氧化偶联硫醇制二硫化物

采用多元醇为溶剂和还原剂制备了聚乙烯吡咯烷酮(PVP)保护的纳米银,并将其用于催化正十二烷基硫醇氧化偶联反应.质谱、红外光谱、拉曼光谱和核磁共振氢谱表征结果表明所得产物为二硫化物.考察了反应时间、反应温度、催化剂和水的用量等对正十二烷基硫醇氧化偶联反应的影响,从而得出优化的反应条件:0.157mmolPVP保护的纳米银,20μl水,100℃下反应3h.此外,进一步将PVP保护的纳米银用于正丁硫醇和正辛硫醇的氧化偶联反应,也得到了相应的二硫化物.