利用甲醇氧化烟气中NO的实验研究

对利用甲醇氧化烟气中NO的反应开展了系统的实验研究。研究了反应时间、反应温度、甲醇用量比例、烟气中O2、SO2及夹带的固体颗粒对NO氧化率的影响。结果表明,在一定的条件下,甲醇能够氧化烟气中的NO;NO氧化率受反应时间和反应温度的综合影响,随着反应时间的增加,有效反应温度区域向低温方向移动,最大NO氧化率降低;随着甲醇用量比例的增加, NO氧化率增加;O2浓度增加可促进NO氧化;烟气中的SO2对反应有催化作用,可显著提高NO氧化率;烟气中固体颗粒的存在阻碍了自由基反应的进行,显著降低了NO的氧化率。     

Catalytic partial oxidation of methane using RhSr- and Ni-substituted hexaaluminates

This paper reports the results of experimental and modeling efforts to characterize partial oxidation of methane to produce synthesis gas (H₂ and CO) using metal-substituted hexaaluminate catalysts in short-contact-time reactors. Hexaaluminate catalysts offer excellent high-temperature stability compared to the equivalent metal-based catalysts. The hexaaluminates are synthesized by a metal-exchange process using alumoxane precursors that enable a wide range of metal substitutions. Of all the combinations tested, RhSr-substituted hexaaluminates yielded the best performance. The catalysts are supported on alumina porous-foam structures, which are positioned within a tube furnace to control the operating temperature. Two-stage combinations of RhSr- and Ni-substituted hexaaluminates are shown to improve conversion activity and selectivity compared to a single-catalyst system.     

Influence of pretreatment methods on adsorption and catalytic characteristics of toluene over heterogeneous palladium based catalysts

The adsorption and catalytic characteristics of heterogeneous palladium based catalyst and its modified catalysts with gases (air and hydrogen) and acidic aqueous solution (HCl) were studied for evaluating the influence of pretreatment methods for toluene. The structural and energetic adsorption properties of the parent and pretreated catalysts were analyzed by means of nitrogen adsorption isotherms and gravimetric methods. The light-off curve and the XPS investigation were used for analyzing the catalytic activity and the surface state of palladium. It was clearly shown from the experimental results that hydrogen pretreated catalysts having metallic surface state exhibited the highest adsorption capacity and catalytic activity compared to that of parent and modified catalysts. The adsorption equilibrium data for toluene were obtained at three different temperatures and correlated successfully with the two-site Langmuir molecular isotherm model (L2m). It was also found that the palladium phase has more adsorption affinity for toluene molecules than the alumina support. The isosteric heat of adsorption calculated by using the Clausius-Clapeyron equation significantly changed with the coverage and the lateral interactions between the adsorbate-adsorbate molecules control the system. Furthermore, comparative analysis of the adsorption energy distribution revealed that the parent and its modified catalysts have different types of surface energetic heterogeneities.     

Influence of experimental parameters on physical properties of porous silicon and oxidized porous silicon layers

This paper reports physical properties of porous silicon and oxidized porous silicon, manufactured by anodisation from heavily p-type doped silicon wafers as a function of experimental parameters. The growth rate and refractive index of the layers were studied at different applied current densities and glycerol concentrations in electrolyte. When the current density varied from 5 to 100 mA/cm², the refractive index was between 1.2 and 2.4 which corresponded to a porosity range from 42 to 85%. After oxidation, the porosity decreased and was between 2 and 45% for a refractive index range from 1.22 to 1.46. The thermal processing also induced an increase in thickness which was dependent on the initial porosity. This increase in thickness was more important for the lowest porosities. Lastly, the roughness of the porous layer/silicon substrate interface was studied at different applied current densities and glycerol concentrations in solution. Roughness decreased when the current density or glycerol concentration increased. Moreover, roughness was also reduced by thermal oxidation.     

AFM nanooxidation process - Technology perspective for mesoscopic structures

We study the technology of local anodic oxidation (LAO) by the AFM tip applied to semiconductor heterostructures with two-dimensional electron gas. The aim is to design mesoscopic rings with persistent current and one subband occupied. For this purpose the need is to oxidize narrow lines that represent energy barriers high enough. Using the electrostatic model, we explain the electric field distribution in the system tip-sample just before LAO starts. We study the influence of the conductivity of the cap layer on LAO and explain the origin of the saddle-like profile lines, observed in the experiment. Using Monte Carlo simulation we show that the carrier redistribution in the system with LAO energy barriers effectively lowers the barrier height. In the experimental part we have grown InGaP/AlGaAs/GaAs heterostructures by organometalic vapor phase epitaxy with an active layer only 31 nm below the surface. We have prepared oxide lines on the heterostructures by LAO and characterized them by the temperature-dependent transport measurement.     

原位氧化Zn3N2制备p型ZnO薄膜的性能研究

采用射频反应溅射法在玻璃衬底上制备Zn₃N₂薄膜，然后向真空室中通入纯氧气进行热氧化制备ZnO薄膜.利用X射线衍射、扫描电子显微镜、霍尔效应测量、透射光谱和光致发光光谱等表征技术，研究了氧化温度和氧化时间对ZnO薄膜的结晶质量、电学性质和光学性能的影响.研究结果显示，450 ℃ 下氧化2 h后的样品中除含有ZnO外，还有Zn₃N₂成分，500 ℃下氧化2 h可以制备出电阻率为0.7 Ωcm，空穴载流子浓度为10^{关键词： p型ZnO薄膜 3N₂薄膜')" href="#">Zn₃N₂薄膜 射频溅射 原位氧化}     

原位漫反射红外光谱表征钛硅分子筛TS-1催化苯乙烯氧化反应

采用高温漫反射红外光谱考察了钛硅分子筛TS-1的稳定性,发现960 cm-1吸收峰在673 K时没有变化,表明所表征的骨架钛具有一定的高温稳定性,而表征分子筛骨架振动的两个吸收峰在673 K下向低波数位移了约13 cm-1。探讨了H₂O₂吸附对TS-1分子筛骨架钛的影响,发现960 cm-1处的吸收峰在吸附H₂O₂后强度减弱,并且向高波数位移了11 cm-1;抽真空或加热,吸收峰又复原,表明骨架钛可能存在TiO结构,H₂O₂与分子筛中的TiO作用,使相应的960 cm-1吸收峰向高波数位移。原位漫反射红外光谱考察了TS-1催化苯乙烯氧化反应,谱图分析表明,苯甲醛是主要产物,TS-1催化氧化的关键是H₂O₂吸附在TS-1的骨架钛上形成活性中心。     

铁卟啉/钒取代杂多酸新型催化剂的合成、表征和性能研究

文章以水溶性碘化四对(4-三甲氨基苯基)铁卟啉和钒取代杂多酸H5PMo10V2O40为原料,采用离子交换方法在水溶液中合成了一种铁卟啉/钒取代杂多酸新型无机-有机复合催化剂,并使用红外和紫外光谱技术对其结构进行了表征,结果表明,这种新型复合催化剂仍然保持着卟啉的大环共轭结构和杂多酸的笼状多电子结构。同时研究了以30%过氧化氢水溶液为绿色氧化剂,初步探讨了这种铁卟啉杂多酸催化剂对苯的羟基化反应的的影响,考察了催化剂的催化活性。催化氧化实验表明,制备的铁卟啉/杂多酸配合物可用作苯直接氧化羟基化成苯酚的催化剂,并且表现出较高的催化活性。     

原位氧化Zn3N2制备P型ZnO薄膜的性能研究

采用射频反应溅射法在玻璃衬底上制备Zn3N2薄膜,然后向真空室中通入纯氧气进行热氧化制备ZnO薄膜.利用X射线衍射、扫描电子显微镜、霍尔效应测量、透射光谱和光致发光光谱等表征技术,研究了氧化温度和氧化时间对ZnO薄膜的结晶质量、电学性质和光学性能的影响.研究结果显示,450℃下氧化2h后的样品中除含有ZnO外,还有Zn3N2成分,500℃下氧化2h可以制备出电阻率为0.7Ωcm,空穴载流子浓度为1017cm-3,空穴迁移率为0.9cm2/Vs的具有c轴择优取向的p型ZnO薄膜.此时的ZnO薄膜具有良好的光学特性,紫外可见光范围内透过率为85%,处于紫外区域的激子复合产生的发光峰很强,且半高宽较窄,而处于可见光部分来自于深能级发射的绿色发光峰很弱.这种工艺制备的ZnO薄膜质量较好,有利于实现在短波长光电器件方面的应用.     

Effect of Li2O and CoO-doping of CuO/Fe2O3 system on its surface and catalytic properties

Physicochemical, surface and catalytic properties of pure and doped CuO/Fe₂O₃ system were investigated using X-ray diffraction (XRD), energy dispersive X-ray analysis (EDX), nitrogen adsorption at −196 °C and CO-oxidation by O₂ at 80-220 °C using a static method. The dopants were Li₂O (2.5 mol%) and CoO (2.5 and 5 mol%). The results revealed that the increase in precalcination temperature from 400 to 600 °C and Li₂O-doping of CuO/Fe₂O₃ system enhanced CuFe₂O₄ formation. However, heating both pure and doped solids at 600 °C did not lead to complete conversion of reacting oxides into CuFe₂O₄. The promotion effect of Li₂O dopant was attributed to dissolution of some of dopant ions in the lattices of CuO and Fe₂O₃ with subsequent increase in the mobility of reacting cations. CoO-doping led also to the formation of mixed ferrite Co_xCu_1−xFe₂O₄. The doping process of the system investigated decreased to a large extent the crystallite size of unreacted portion of Fe₂O₃ in mixed solids calcined at 600 °C. This process led to a significant increase in the S_BET of the treated solids. Doping CuO/Fe₂O₃ system with either Li₂O or CoO, followed by calcination at 400 and 600 °C decreased its catalytic activity in CO-oxidation by O₂. However, the activation energy of the catalyzed reaction was not much affected by doping.