NOx在固体电解质电解池上的电化学消除

 综述了近年来利用固体电解质电解池消除NO的研究进展．重点总结了电化学消除NO研究体系、电化学消除NO分解机制、O2－在固体电解质电解池中传导的控速步骤、电极种类和形态对NO分解性能的影响以及直流与交流电作用的差异等几个方面的研究结果．在RuO2—Ag—YSZ—Pd电解池上实现的NO选择性分解是迄今为止的最佳结果，500℃下NO的转化率为31．8％，NO的分解活性是O2的分解活性的13倍．该领域今后研究的主要方向是，进一步提高NO分解相对于共存O2离子化的选择性、降低O2－在阴极界面处的传导阻力和探寻可在更低温度传导O2－的新的固体电解质     

Vanadium Oxide: From Gels to Nanotubes

Vanadium oxide nanotubes (VO _x -NT) have been prepared by mixing hexadecylamine with V₂O₅·nH₂O gels. This procedure was followed by an hydrothermal treatment (150–180°C, 2–7 days) which leads to a large quantity of VO _x -NT. SEM and XRD analysis have been used to optimize the temperature and reaction time required for production of VO _x -Nt and morphology of the nanotubes investigated by TEM.     

Effect of BaBiO3 and Ba0.6K0.4BiO3 additives on the rechargeability of manganese oxide cathodes in alkaline cells

The effect of the incorporation of small amounts (1–5 wt%) of semiconducting BaBiO₃ and metallic Ba_0.6K_0.4BiO₃ additives on the rechargeability of electrolytic manganese dioxide (EMD) cathodes in alkaline cells in the one-electron regime has been investigated. Both the BaBiO₃ and Ba_0.6K_0.4BiO₃ additives lead to better cyclability compared to the previously known binary oxide additive Bi₂O₃. X-ray diffraction patterns recorded before and after 30 cycles as well as cyclic voltammograms recorded after first and 30 cycles reveal that the better cyclability in the presence of BaBiO₃ and Ba_0.6K_0.4BiO₃ additives is due to the suppression of the formation of unwanted, electrochemically inactive birnessite and hausmannite phases and a shifting of the second-electron capacity of Mn to higher potentials.     

甲醇与乙醇一步合成异丁醛用CuO-ZnO/Al2O3催化剂

在ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３催化剂上，甲醇与乙醇在常压和２１０￣３６０℃温度下一步反应合成异丁醛。利用正交设计方法，研究了ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３体系催化剂组成和制备条件等因素对催化剂催化性能的影响。结果表明，催化剂中ＣｕＯ含量对催化剂的催化活性影响最大，而ＺｎＯ含量则主要影响催化剂对异丁醛的选择性。催化剂制备条件，如沉淀温度、陈化时间等，也不同程度也影响催化剂的催化性能。ＸＲＤ和ＢＥＴ表征结果     

1,10-双(1′-苯基-3′-甲基-5′-氧代吡唑-4′-基)癸二酮-[1,10]与三苯基氧化膦对钐(Ⅲ)的协同萃取行为研究

研究了１，１０－双（１′－苯基－３′－甲基－５′－氧代吡唑－４－基）癸二酮－［１，１０］（ＢＰＭＰＤＤ，Ｈ２Ａ）与三苯基氧化膦（ＴＰＰＯ，Ｂ）的氯仿溶液从硝酸介质中对Ｓｍ（Ⅲ）的协同萃取行为，计算了体系的酸性协萃系数ＲＡ和协萃系数Ｒ，用斜率法测得协萃合物的组成为ＳｍＡ·ＨＡ·Ｂ，计算了协萃平衡常数，用萃取法制得了固态协萃合物，并对其组成、ＩＲ及ＴＧ－ＤＴＡ进行了研究     

Ein Beitrag über Oxide vom Typ AMO4 (A = Ti3+, Cr3+; M = Nb5+, Ta5+)

A Contribution on Ternary Oxides of the AMO₄-Type (A = Ti³⁺, Cr³⁺; M = Nb⁵⁺, Ta⁵⁺ ) CrNbO₄, CrTaO₄, TiNbO₄, and TiTaO₄ were prepared by CO₂-laser technique. X-ray single crystal investigations show a random distribution of the metal ions in Rutil type structure, space group D–P4₂/mnm. Calculations of the free energy of reaction between Ti₂O₃ and Nb₂O₅ show higher stability of TiO₂ beside NbO₂. In TiNbO₄ both metals exhibit the oxidation state +4.     

光谱复杂的稀土基体中稀土杂质ICP光谱测定的一些问题

ICP激发光源以其独特的功能使ICP/AES技术在稀土分析中的应用日益广泛,在一定程度上取代了经典的直流电弧光谱法,但应指出,由于常规雾化器的低雾化效率(≤5％)和试样的高倍稀释,ICP/AES技术的实际检测能力的改善并不明显,本文用ICP光谱法测定了     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

碳酸氢铵沉淀法制备氧化钇粉体时反应条件对产物粒度的影响

研究了碳酸氢铵沉淀法的反应条件对氧化钇粒度的影响,探讨了粒度变化规律。发现在沉淀反应中,晶型碳酸钇铵的形成与否是影响氧化钇粒度的关键因素。在较低的反应温度下,当碳酸氢铵和氯化钇的浓度大于0.25mol·L-1,摩尔比大于5,陈化时间大于60min时得到碳酸钇铵沉淀,经煅烧可获得粒度(D50)大于1μm的氧化钇。当反应物浓度较低、摩尔比小,陈化时间较短时得到无定型碳酸钇沉淀,煅烧沉淀可获得粒度(D50)小于0.5μm的氧化钇。实验证明选择适当的沉淀反应条件,可制备D50在0.3～10μm范围内的不同粒度级别的氧化钇粉体。     

Modeling Studies of the Formation and Destruction of NO in Pulsed Barrier Discharges in Nitrogen and Air

This paper presents the results of modeling studies on the formation and destruction of NO in pulsed barrier discharges in nitrogen and air. The goals of this work are to identify the major processes involved in the formation and destruction of NO in air discharges, to distinguish between oxidative and reductive paths for NO destruction, to explore the potential importance of excited state reactions, to evaluate the role of water in such systems, and to identify the final products in the absence of heterogeneous processes. In all cases, the systems were modeled with 100×10^–4% (100 ppm) of added NO, with and without 3% added water. The focus in all of this work is chemistry in the post-pulse regime.