A thermal study of Cu(II) compounds formed with piperazine derivatives

The thermal behaviour of some Cu(II) compounds formed with 1,4-disubstituted piperazine derivatives has been studied. The investigations were performed on a MOM 1500 derivatograph. The endothermic effects observed at 170–180°C are associated with the processes of dehydration and dehalogenation of the compounds, with general formula LH₂·CuCl₄·H₂O, whereL is the piperazine derivative. The residue at 600°C remains relatively constant.     

Influence of vanadium doping on the behavior of YBa_2Cu_3O_7-y

YBa2Cu3-xVxO7-y(x=0, 0.1, 0.2, 0.3, 0.4, 0.5 and 0.6) superconductors have been prepared. X-ray diffraction shows that the system remains orthorhombic for all compositions studied, but for x > 0.4 V2O5 was detected as an impurity phase. Substitution of V5+ for Cu2+ occurs in the Cu(2) sites on the Cu(2)-O planes. The introduction of the high valence element, vanadium, produces the extra free-electrons. These electrons recombine with the positive carrier of the system. It makes depression of the mobility and the Hall number of YBa2Cu3-xVxO7-v and also results in a depression of TC.     

Interactions of water and methanol with a mixture of copper and zinc metals: a theoretical <Emphasis Type="Italic">ab initio</Emphasis> study

Ab initio cluster quantum chemical calculations at the Hartree–Fock and second-order Møller–Plesset perturbation theory levels were carried out to mimic the interactions of water and methanol with a mixture of Cu and Zn metals. It was shown that both molecular and dissociative adsorption of methanol on a mixture of Cu and Zn metal catalyst are preferred over the corresponding adsorptions of water. Estimated transition-state structures for dissociation of methanol into CH·₃ and OH· lie about 9.0 and 22.0 kcal/mol higher compared to the dissociated (forward reaction) and molecular adsorption (reverse reaction) complexes, respectively. Based on distinct radicals' bond energies with the active sites of the catalyst considered, it is suggested that hydrogen molecules could be formed through a chain of homogeneous reactions of methyl radicals released into the gas phase with the water and/or methanol molecules.     

碳纳米管添加剂对质子交换膜燃料电池低铂载量膜电极性能的影响研究

以碳纳米管（CNT）作为低铂载量膜电极（CCM）催化层（0.1 mg_Pt·cm^-2）添加剂，研究了CNT的添加方式对催化层微观结构以及膜电极性能的影响.结果表明，与常规低铂载量催化层相比，在其表面喷涂一层CNT或将CNT均匀分散到Pt/C催化层中均有利于提升低铂载量膜电极的输出性能，在70℃和100%相对湿度条件下最高输出功率比常规低铂载量膜电极的0.522 W·cm^-2分别提升了22.4%和60.0%，并且均匀分散添加方式优于分层添加方式.其原因在于分层添加CNT后改善了低铂催化层和气体扩散层之间的接触界面，降低了催化层与扩散层间的接触电阻，而均匀分散添加方式除了可降低界面接触电阻外，还显著改善了低铂催化层中的气体传输，大幅提升了Pt催化剂的利用效率，使得膜电极电化学反应电阻明显降低.进一步对均匀分散添加方式中CNT的载量进行优化，表明CNT添加量为37.5 μg·cm^-2时电池输出性能最佳，70℃和100%相对湿度条件下的最大输出功率达到0.91 W·cm^-2.本研究工作表明，将CNT均匀分散添加到催化层中是一种有效提升低铂载量膜电极性能的方法.     

Tetranuclear Pt<Subscript>2</Subscript>Cu<Subscript>2</Subscript> Complex with a Staircase-Shaped Chain Aggregate in the Solid State

The reaction of the tetranuclear cyanide aquo complex [{Pt(CN)₄Cu(bipy)(H₂O)}₂]· 2H₂O with aqueous ammonia produces the new tetranuclear ammino-containing product [{Pt(CN)₄Cu(bipy)(NH₃)}₂] (1), with terminal cyanide groups and with NH₃ coordinated to the Cu atom. The distorted trigonal bipyramidal coordination about copper in 1 differs from the square-pyramidal coordination present in the starting material. The bipyridine ligand in 1 is nearly perpendicular to the tetranuclear core of the molecule, as opposed to its coplanar disposition in the aquo complex. The two platinum atoms of the tetranuclear core in 1 form Pt···Pt interactions of 3. 2390(8) Å with platinum atoms of neighboring molecules, producing an echelon-shaped supramolecular chain held together by staggered (CN)₄Pt···Pt(CN)₄ linkages, an aggregate structure which does not have a precedent in chemistry derived from the Pt(CN)₄ building block.     

Study of reactive ion etching of Si and SiO2 for CFxCl4−x gases

A parametric study of the etching of Si and SiO₂ by reactive ion etching (RIE) was carried out to gain a better understanding of the etching mechanisms. The following fluorocarbons (FCs) were used in order to study the effect of the F-to-Cl atom ratio in the parent molecule to the plasma and the etching properties: CF₄, CF₃Cl, CF₂Cl₂, and CFCl₃ (FC-14, FC-13, FC-12, and FC-11 respectively). The Si etch rate uniformity across the wafer as a function of the temperature of the wafer and the Si load, the optical emission as a function of the temperature of the load, the etch rate of SiO₂ as a function of the sheath voltage, and the mass spectra for each of the FCs were measured. The temperature of the wafer and that of the surrounding Si load strongly influence the etch rate of Si, the uniformity of etching, and the optical emission of F, Cl, and CF₂. The activation energy for the etching reaction of Si during CF₄ RIE was measured. The etch rate of Si depends more strongly on the gas composition than on the sheath voltage; it seems to be dominated by ion-assisted chemical etching. The etching of photoresist shifted from chemical etching to ion-assisted chemical etching as a function of the F-to-Cl ratio and the sheath voltage. The etch rate of SiO₂ depended more strongly on the sheath voltage than on the F-to-Cl ratio.     

Lewis acid mediated SN2-type nucleophilic ring opening followed by [4+2] cycloaddition of N-tosylazetidines with aldehydes and ketones: synthesis of chiral 1,3-oxazinanes and 1,3-amino alcohols

A highly efficient strategy for Cu(OTf)₂ mediated S_N2-type nucleophilic ring opening followed by [4+2] cycloaddition reactions of enantiopure 2-phenyl-N-tosylazetidines with various aldehydes and ketones afforded a variety of substituted 1,3-oxazinanes and 1,3-amino alcohols in excellent yields, excellent de and good to excellent ee. The proposed S_N2-type mechanism of the cycloaddition reaction is supported by experimental evidence.     

Ternary complexes in solution. Comparison of the coordination tendency of some polybasic oxygen acids toward the binary complexes of Cu(II) andAMP,ADP orATP

Summary Potentiometric equilibrium measurements have been made at 25±0.1°C (=0.1 mol dm^–3 KNO₃) for the interaction of adenosine-5-mono-, -di- and -triphosphate (AMP,ADP andATP) and Cu(II) with biologically important secondary ligand acids (malic, maleic, succinic, tartaric, citric and oxalic acids) in a 1:1:1 ratio and the formation of various 1:1:1 mixed ligand complex species inferred from the potentiometricpH titration curves. Initial estimates of the formation constants of the resulting species and the acid dissociation constants ofAMP,ADP,ATP, and secondary ligand acid, have been refined with the SUPERQUAD computer program. In some systems logK values are positive, i.e. the ternary complexes are found to be more stable than the corresponding binary complexes. In some Cu(II) ternary systems the interligand interactions between the coordinate ligands, possibly H bond formation, have been found to be most effective in deciding the stability of the ternary complexes formed in solution. Stabilities of mixed ligand complexes increase in the orderAMP <ADP <ATP. With respect to the secondary ligands, the formation constants of the mixed ligand complexes decrease in the order succinic > maleic > tartaric > malic > citric > oxalic acid.

---

Ternäre Komplexe in Lösung. Vergleich der Koordinationstendenz einiger polybasischer Sauerstoffsäuren gegenüber binären Komplexen von Cu(II) mitAMP,ADP oderATP

Zusammenfassung Es wurden potentiometrische Gleichgewichtsmessungen bei 25±0.1°C bei =0.1 mol dm^–1 KNO₃ durchgeführt, um die Wechselwirkung von Adenosin-5-mono-, -di- und triphosphat mit Cu(II) und biologisch relevanten Sekundärliganden wie Äpfel-, Malein-, Bernstein-, Wein-, Zitronen- und Oxalsäure im Verhältnis 1:1:1 festzustellen. Aus den potentiometrischenpH-Titrationskurven ergaben sich verschiedene 1:1:1 gemischte Ligandenkomplexe. Anfänglich abgeschätzte Komplexbildungskonstanten der Komplexe und Säuredissoziationskonstanten vonAMP,ADP undATP und den Sauerstoffsäuren wurden mittels des Computerprogramms SUPERQUAD verfeinert. In einigen Systemen ist logK positiv, demzufolge sind die ternären Komplexe stabiler als die korrespondierenden binären. In einigen ternären Cu(II)-Komplexen bestehen zwischen den Liganden Wechselwirkungen, vermutlich auf der Basis von stabilitätsfördernden Wasserstoffbrückenbindungen. Die Stabilitäten der gemischten Komplexe steigen in der ReihenfolgeAMP <ADP <ATP. Bezüglich der Sekundärliganden ergibt sich für die Bildungskonstanten der ternären Komplexe die Reihung Bersteinsäure > Maleinsäure > Weinsäure > Äpfelsäure > Zitronensäure > Oxalsaure.

     

A New Dinuclear Cu(Ⅱ) Complex of a Ligand with Benzimidazole Group─Synthesis and Crystal Structure

A new dinuclear copper complex, [Cu(C9H11N3)Cl2]2 (C18H22Cl4Cu2N6), has been synthe- sized and characterized by X-ray structure determination. It crystallizes in the triclinic P1 space group with a = 7.526(3), b = 9.473(4), c = 9.535(3) , α = 117.214(10), β = 108.251(9), γ = 91.560(6)o, V = 562.3(4) 3, Z = 1, Mr = 591.30, F(000) = 298, Dc = 1.746 g/cm3, μ(MoKα) = 2.385 mm-1, the final R = 0.0577 and wR = 0.1248 for 2188 unique reflections with 1629 observed ones (I > 2σ(I)). In the title complex, each copper(II) atom is located at the center of a distorted trigonal bipyramid of five coordination atoms (two nitrogen and three chlorine atoms). Two copper(II) atoms were bridged by two chlorine anions (Cl(2) and Cl(2a)) to form a Cu(II)-Cu(II) binuclear entity with the distance between two copper(II) atoms of 3.398 .     

A highly selective fluorescent sensor for Cu based on 2-(2′-hydroxyphenyl)benzoxazole in a poly(vinyl chloride) matrix

This paper describes a copper selective optical chemical sensor based on static quenching of the fluorescence of 2-(2′-hydroxyphenyl)benzoxazole entrapped in a poly(vinyl chloride) (PVC) membrane. The effect of the composition of the sensing membrane was studied, and experimental conditions were optimized. The sensors exhibit stable response over the concentration range from 4.0 × 10⁻⁸ M to 5.0 × 10⁻⁵ M Cu²⁺ at pH 4.0-6.5, and a high selectivity. The response time for Cu²⁺ with concentration ≤5 × 10⁻⁶ M is less than 7 min. The optode can be regenerated using 0.1 M HCl and acetate buffer solution. The sensor has been used for direct measurement of copper content in river water samples with a relative error less than 4% with reference to that obtained by atomic absorption spectrometry.