Carbon deposition on a Ni/α-Al2O3 catalyst

The kinetics of carbon deposition over a Ni/α-Al₂O₃ commercial catalyst, has been studied using CH₄−H₂ gas mixtures in the range of 748–873 K. A Hougen-Watson type model gives good agreement with the experimental rates.     

取向聚对苯二甲酸乙二酯纤维的非等温结晶动力学

取向聚对苯二甲酸乙二酯纤维的非等温结晶动力学张志英，赵家森（天津纺织工学院材料科学系天津３００１６０）关键词取向高聚物，聚对苯二甲酸乙二酯，非等温结晶，结晶动力学研究高聚物结晶动力学常用的等温方法有光透射法、密度法、显微镜法、Ｘ－射线衍射法、差示扫描...     

MgO•3B2O3-18%MgSO4-H2O过饱和溶液析出固相组成和机理研究

针对青藏高原盐湖卤水析盐过程的特点, 模拟合成MgO•3B₂O_3-18%MgSO_4-H₂O过饱和溶液, 在150 ℃水热条件下对析出固相进行研究. 用化学分析方法、X射线衍射、红外光谱进行物相鉴定. 提出了可能的结晶反应机理, 分析了水热温度对析出物相的影响及MgSO₄对硼酸镁盐的盐溶效应随水热温度的变化.     

多组分单体接枝聚丙烯/尼龙6反应共混物结晶行为研究

用多组分熔融接枝的方法将甲基丙烯酸缩水甘油酯 (GMA)和苯乙烯 (St)共同接枝到聚丙烯 (PP)上 ,制得具有较高GMA接枝率的多单体接枝聚丙烯 ,PP g (GMA co St) .将PP g (GMA co St)与尼龙 6 (PA6 )进行共混 ,利用扫描电镜 (SEM) ,差示扫描量热计 (DSC)和广角X射线衍射 (WAXD)对共混物的形态和结晶进行了研究 .在共混过程中 ,PP g (GMA co St)与PA6反应原位生成了PP g PA6 ,有效改善了共混物的相容性 ,分散相尺寸明显减小 .在PP g (GMA co St) PA6为 3 7的体系中 ,PP g (GMA co St)出现分级结晶现象 ,其在较低温度下的结晶属于均相成核结晶 .在PP g (GMA co St) PA6为 7 3的体系中 ,由于PA6相分散细微 ,在通常结晶温度下不结晶 ,而是在低温下均相成核与PP g (GMA co St)同时结晶 .WAXD证实体系中接枝PP ,PA6为分别结晶 ,无共晶或新的晶型产生     

ZnO超微粒子光催化氧化降解n-C7H16的研究

利用ZnO光催化氧化技术对气相n-C7H16进行了降解研究，考察了氧气、水燕气体积分数等因素对n-C7H16光催化氧化的影响，利用气相色谱－质谱联用仪和气相色谱仪对气相光催化反应过程中的气体组成进行了定性分析，并对主要中间产物丙醛进行了定量分析，结果发现，ZnO超微粒子光催化氧化n-C7H16的降解率较高，n-C7H16绝大部分被完全氧化成CO2，探讨了n-C7H16光催化氧化反尖的动力学行为及机理。     

草酸锰分解过程的机理函数判别和动力学研究

用等温热重和线性升温热重分析法研究了草酸锰热分解过程,提出了判断其机理函数的3步判别法。经实验和理论分析证明,该反应受随机成核和晶核随后生长的过程(A_3a机理)支配,其活化能E=103.95 kJ/mol,频率因子A=4.448×10~8min~(-1).动力学补偿效应为IgA=0.09661E-1.2856     

Memory effects in isothermal crystallization II. Isotactic polypropylene

The effects of temperature and duration of melting on the rate of isothermal crystallization of isotactic polypropylene were investigated by differential scanning calorimetry (DSC). Crystallization rates were found to decrease with increasing melt temperature and melting time. The results were discussed in the framework of the theoretical model of transient isothermal crystallization developed by the present authors [1]. The results suggest gradual destruction of predetermined nuclei with activation energyE _a=89±7 kJ/mole as a main mechanism of the observed effects.This work and Part I of this research [1] have been supported in part by Research Grant Number PB 1291/52/93/04 from State Committee for Scientific Research (KBN), Poland, and by 40% MURST founds, Italy.     

The crystallization characteristics of polypropylene and low ethylene content polypropylene copolymer with copolyesters

The crystallization characteristics of polypropylene (PP) and low ethylene content PP copolymers with and without nucleating agents were studied by differential scanning calorimetry (DSC). PP and PP copolymers was blended with three different kinds of co[poly(butylene terephthalate-p-oxybenzoate)] copolyesters, designated B28, B46, and B64, with the copolyester level varying from 5 to 15 wt.%. All samples were prepared by solution blending in hot xylene solvent at 50 °C. The crystallization behavior of samples was then studied by DSC. The results indicate that these three copolyesters accelerate the crystallization rate of PP and PP copolymers in a manner similar to that of a nucleating agent. The acceleration of crystallization rate was most pronounced in these blend systems with a maximum level at 5 wt.% of B28. The observed changes in crystallization behavior are explained by the effect of the composition and the amount of copolyester in the blends.     

Thermoanalytical characterization of carbon/carbon hybrid material, Apple Woodceramics

Woodceramics, a carbon/carbon composite of plant-originated carbon reinforced by glassy carbon from phenolic resin, was prepared from apple pomace at carbonizing temperatures of 1073 K (AWC800) and 1473 K (AWC1200), and characterized by thermoanalytical methods and X-ray diffraction (XRD). Simultaneous differential scanning calorimetry (DSC) and thermogravimetric (TG) showed complicated overlapping reactions similar to those of coal. The initial temperature of pyrolysis was obtained by fitting logistic functions to observed TG data. The results suggested that AWC1200 contained more volatile matter than AWC800. In an inert atmosphere, complicated devolatilization takes place. In an oxidizing atmosphere, thermal change occurs roughly in four steps: desorption of physically adsorbed matter; pyrolysis into aliphatic and aromatic fragments; ignition; combustion of char. The oxidation resistance of AWC1200 was superior to AWC800.