液态结构与性质关系Ⅱ——Mg-9Al熔体的运动黏度及与熔体微观结构的关系

采用坩埚扭摆振动法测量Mg-9Al熔体的运动黏度,得到890—1190 K温区内高精度的黏度-温度关系曲线ν(T),发现升温过程中黏度随温度升高发生异常变化,当温度升高至1000—1075 K时,黏度由快速增大转变为逐渐减小,即发生转折变化;在随后的降温和第二次升温过程中,黏度随温度变化呈指数规律单调递增(减),符合Arrhenius方程式.在实验研究基础上,采用剩余键结构模型和"平均原子集团"演变行为的计算模型讨论Mg-9Al熔体的黏度与微观结构之间的相关性,结果表明:类关键词： 合金熔体 结构与黏度相关性 剩余键结构 平均原子集团模型     

Electronic structure and magnetism in full-Heusler compound Mn2ZnGe

The first-principle calculations within density functional theory are used to investigate the electronic structure and magnetism of the Mn₂ZnGe Heusler alloy with CuHg₂Ti-type structure. The half-metallic ferrimagnets (HMFs) in Mn₂ZnGe are predicted. The energy gap lies in the minority-spin band for the Mn₂ZnGe alloy. The calculated total spin magnetic moment is −2μ_B per unit cell for Mn₂ZnGe alloy, the magnetic moments of Zn and Mn(B) are antiparallel to that of Mn(A), and we also found that the half-metallic properties of Mn₂ZnGe are insensitive to the dependence of lattice within the wide range of 5.69 and 5.80 Å where exhibiting perfect 100% spin polarization at the Fermi energy.     

Ti-Zr-Ni单相准晶合金的室温力学性能研究

以Ti40₄₀Zr40₄₀Ni20₂₀合金为研究对象，用铜 模吸铸法制备出直径为3mm的致密单相准晶棒，通过维氏显微硬度测定和单向压缩实验方 法研究了该合金的室温力学性能 .结果表明：Ti40₄₀Zr40₄₀Ni20₂₀准晶具有良好 的弹性变形能力，室温弹性应 变可达125%.同时，它具有相对高的室温硬度（约55GPa），是普通Ti合金的15倍.T i40_{40 关键词： 准晶 Ti-Zr-Ni合金 解理断裂}     

Electrochemical behaviors of the magnesium alloy substrates in various pretreatment solutions

Interface reactions and film features of AZ91D magnesium alloy in pickling, activation and zinc immersion solutions have been investigated. The surface morphologies of the specimens were observed with scanning electron microscope (SEM). Electrochemical behaviors of AZ91D magnesium alloy in the baths of pickling, activation and zinc immersion were analyzed based on the open circuit potential (OCP) - time curves in various solutions. The results show that the corrosive rate in HNO₃ + CrO₃ or HNO₃ + H₃PO₄ pickling solution was more rapid than in KMnO₄ pickling-activation solution. Both α phase and β phase of the substrates were uniformly corroded in HNO₃ + CrO₃ or HNO₃ + H₃PO₄ pickling solution, the coarse surface can augment the mechanical occlusive force between the subsequent coatings and the substrates, so coatings with good adhesion can be obtained. In HF activation solution, the chromic compound formed via HNO₃ + CrO₃ pickling was removed and a compact MgF₂ film was formed on the substrate surface. In K₄P₂O₇ activation solution, the corrosion products formed via HNO₃ + H₃PO₄ pickling were removed, a new thin film of oxides and hydroxides was formed on the substrate surface. In KMnO₄ pickling-activation solution, a film of manganic oxides and phosphates was adhered on the substrate surface. Zinc film was symmetrically produced via K₄P₂O₇ activation or KMnO₄ pickling-activation, so it was good interlayer for Ni or Cu electroplating. Asymmetrical zinc film was produced because the MgF₂ film obtained in the HF activation solution had strong adhesive attraction and it was not suitable for interlayer for electroplating. However, the substrate containing compact MgF₂ film without zinc immersion was fit for direct electroless Ni-P plating.     

Fourfold in-plane magnetic anisotropy in epitaxial Fe(1 1 0)/Cu(0 0 1) and Fe(1 1 0)/Ni(0 0 1) bilayers

Epitaxial Fe(1 1 0) films with thicknesses of 100-800 nm on Cu(0 0 1) and Ni(0 0 1) buffer layers grown on MgO(0 0 1) substrates have been fabricated. These films contain Fe(1 1 0) crystallites which are in the Pitsch orientation relationship. Magnetization and the fourfold in-plane magnetic anisotropy constants of these films have been determined by torque measurements. All the samples under study are characterized by a fourfold magnetic anisotropy with easy axes parallel to the [1 0 0] and [0 1 0] directions of Cu(0 0 1) and Ni(0 0 1) layers. The measured values of the constant for Fe(1 1 0)/Cu(0 0 1) are found to depend on deposition temperature; a maximum value of (2.5±0.1)×10⁵ erg/cm³ is reached after annealing at 600 °С. The in-plane torque measurements on Fe(1 1 0)/Ni(0 0 1) bilayers obtained at 300 °С, on the other hand, exhibit a constant value of (2.7±0.1)×10⁵ erg/cm³. Assuming an exchange interaction between the Fe(1 1 0) crystallites, which are in the Pitsch orientation relationship, the fourfold in-plane magnetic anisotropy has been calculated as 2.8×10⁵ erg/cm³. The deviations of the experimental values from the predicted one may be explained by the formation of a polycrystalline phase within the Fe(1 1 0) layer and a partial disorientation of the epitaxial crystallites.     

Influence of structural defects on the magnetization process in high-magnetic fields in the Fe61Co10Y8Nb1B20 alloy in the form of ribbons and plates

Amorphous samples of the Fe₆₁Co₁₀Y₈Nb₁B₂₀ alloy in the form of a ribbon with thickness of approximately 30 μm and in the form of a plate with thickness of 0.5 mm have been investigated. Plates were obtained by a suction-casting method, and ribbons by a single roller melt-spinning method. Microstructural studies, using X-ray spectroscopy, confirmed that samples in the as-quenched state were fully amorphous. Measurements carried out using a vibrating sample magnetometer allowed values of coercivity and saturation magnetization to be obtained; it also facilitated the estimation of size and nature of structural defects in the investigated samples. All of the investigated samples of this alloy in the as-quenched state have high values of saturation magnetization of greater than 1.25 T.     

微尺度型腔内液态金属流动规律模拟研究

修正了传统的Navier-Stoke方程,并利用修正后的方程与Fluent软件对微尺度型腔内Zn-Al合金微流动规律进行了数值模拟.模拟结果表明：液态金属在微尺度管道内的流动规律在管径为0.5mm时出现临界状态,管径越细,速度附面层相对厚度就越大.同时,微管流动存在着宏观流动中没有的“凸进效应”,且随着入口压力增大,流动前沿自由液面的凸进效应减弱.在流动前沿区域和上游区域之间出现负压力梯度区,且管径越细越明显. 关键词： 微管道 微流动 Zn-Al合金     

二元合金多晶粒的枝晶生长的等温相场模型

基于Ginzburg-Landau理论和单晶粒的枝晶生长模型，发展了一个单相场控制的多个晶粒的枝晶生长模型. 采用相场和溶质场耦合的方法，以Al-2%Cu合金为例模拟了二元合金等温凝固过程中多个晶粒的生长过程. 结果表明，这个模型的计算结果展现了多个晶粒枝晶的竞争生长，能较真实的再现凝固过程中的枝晶的生长过程.     

Zn-Mg合金的长程Finnis-Sinclair势

通过拟合Mg的晶格能、晶格常数、弹性常数,并将其与前人的结果相比较后获得了描述Mg的最优长程Finnis-Sinclair(F-S)势函数参数,使用同样方法并引入修正因子后得到了Zn的长程F-S势参数.基于单质Zn,Mg的F-S势参数,进一步拟合合金Mg₂₁Zn₂₅,MgZn₂,Mg₂Zn₁₁的晶格常数、晶格能获得Zn-Mg原子对的F-S势参数,构建了整套描述Zn-Mg合金的长程F-S势参数.在此 关键词： 长程Finnis-Sinclair势 Zn-Mg合金 分子动力学模拟     

Fe-Co-Ni衬底上准定向ZnO亚微米杆的制备及其光学性质

以Fe-Co-Ni合金为衬底,硝酸锌(Zn(NO_3)_2·6H_2O)和氨水(NH_2·H_2O)为原料,采用水热法生长出准定向的ZnO亚微米杆阵列.运用X射线衍射(XRD)、高分辨透射电镜(TEM)、扫描电子显微镜(SEM)及室温光致发光谱(PL)研究了ZnO样品的结构、形貌和光学性质.在合适温度(85℃)下长出的ZnO亚微米杆直径较均匀,定向性较好,具有良好的紫外发光特性;在较高的生长温度(100℃)下得到的ZnO样品是分叉杆簇团.Ni衬底上的生长实验获得了类似于Fe-Co-Ni衬底上的准定向ZnO亚微米阵列.