Development of a capillary electrophoretic method for the separation of diastereoisomers of a new human immunodeficiency virus protease inhibitor

A capillary electrophoretic (CE) method was developed for the separation of diastereoisomers of a new human immunodeficiency virus (HIV) protease inhibitor TMC114. In total 16 isomers of this drug have been synthesized (eight pairs of enantiomers). We succeeded in the separation of the eight diastereoisomers, but no enantiomers could be separated. Because of the high similarity and water-insolubility of these isomers, the separation is a real challenge. Different CE modes were tried out: capillary zone electrophoresis (CZE), nonaqueous capillary electrophoresis (NACE), micellar electrokinetic capillary chromatography (MEKC), and microemulsion electrokinetic capillary chromatography (MEEKC). Only MEEKC offered resolution of these compounds.     

Dynamically coating the capillary with 1-alkyl-3-methylimidazolium-based ionic liquids for separation of basic proteins by capillary electrophoresis

Ionic substances with melting points close to room temperature are referred to as ionic liquids. Because ionic liquids are environmentally benign and are good solvents for a wide range of both organic and inorganic materials, interest for their potential uses in different chemical processes is increasing. In this paper, a capillary electrophoretic method for the analysis of basic proteins including lysozyme, cytochrome c, trypsinoge, and α-chymotyypsinogen A is reported. The method, in which 1-alkyl-3-methylimidazolium-based ionic liquids are used as the running electrolytes, leads to a surface charge reversal on the capillary wall. The effects of the alkyl group, imidazolium counterion, and the concentration of the ionic liquids were discussed. The optimum buffer system was a 90 mM 1-ethyl-3-methylimidazolium tetrafluoroborate (1E-3MI-TFB) solution. The applied voltage was −15 kV and detection was performed by monitoring absorbance at 240 nm. Baseline separation, high efficiencies, and symmetrical peaks of four proteins were obtained. The R.S.D. values of migration times and peak areas were <0.68 and <3.0%, respectively. The separation mechanism seems to involve association between the imidazolium cations and the proteins.     

Capillary Electrophoresis for the Simultaneous Determination of Metals by Using Ethylenediamine Tetraacetic Acid as Complexing Agent and Vancomycin as Complex Selector

A new separation system of capillary electrophoresis for the simultaneous determination of metals by using ethylenediamine tetraacetic acid （EDTA） as complexing agent and employing vancomycin as complex selector was described. The Z-shape cell capillary electrophoresis was used to enhance the sensitivity for the determination of the complexes of Cu（Ⅱ）, Ni（Ⅱ）, Co（Ⅱ） and Fe（Ⅲ） with EDTA. The partial filling method （co-current mode） was used in order to increase the selectivity of the electrophoretic method, meanwhile vancomycin was not present at the detector path during the detection of metal-EDTA complexes. The vancomycin concentration, phosphate concentration and pH of the buffer strongly influenced mobility, resolution and selectivity of the studied analytes. Under the optimal condition, the relative standard deviations （n=5） of the migration time and the peak area were less than 3.14% and 7.35%, respectively. Application of the Z-shape cell capillary electrophoresis method with UV detection and vancomycin loading led to the reliable determination of these metal ions in tap water and the recoveries were 97%-101%. The detection limits based on a signal to noise ratio of 3 ： 1 were found in the range of 2-10 μg·L^-1.     

Behavior of Humic Acid as a Micellar Phase in Micellar Electrokinetic Chromatography (MEKC)

The possibility of humic acids acting as micellar phase in micellar electrokinetic chromatography was evaluated. We investigated the separation of naphthalene in capillary electrophoresis using various samples of humic acids as micellar phase under different pH conditions, concentrations of humic acid, and temperature. The humic acid samples studied were from different origins including peat, vermicompost and a commercial sample acquired from Aldrich. Methanol was used as a marker for the electroosmotic flow. The results indicate that the formation of micelle depends on the number and nature of the hydrophobic association sites in an aqueous humic acid solution and on the origin and concentration of the humic acid at a defined pH. At lower pH values, the possibility of the humic acid molecule forming pseudomicelles increases due to a combination of neutralized and dissociated charged sites.     

Capillary zone electrophoresis of cationic and anionic drugs in methanol

The actual mobilities and dissociation constants of acidic and basic pharmaceuticals were determined in methanol. Actual mobilities were derived from the dependence of the effective mobilities of the analytes on the pH of the methanolic background electrolyte solution (pH(MeOH)). The pKa values of the pharmaceuticals in methanol (pK(a,MeOH)) were calculated by non-linear curve fitting to the measured mobility values. It was found that the shift in pKa value (when compounds were transferred from water to methanol) increased with the acidity of the analyte. The average pKa shift for compounds exhibiting acidic properties in water was ca. 5.5 units, and the shift for basic compounds about 2 units. As was shown for a mixture of beta-blockers, the calculated actual mobilities and pKa values can be utilised in the optimisation of pH conditions for separation. The practical value of the method was illustrated by the analysis of urine samples.     

Capillary electrophoretic determination of lignin degradation products obtained by permanganate oxidation

A new capillary electrophoretic (CE) technique was developed for the separation of lignin degradation products after permanganate oxidation, yielding information about quality and quantity of various linkages in the lignin molecule. This CE method is a promising alternative to existing gas chromatographic (GC) methods. An advantage in comparison with GC is the short separation time and the fact that the oxidation products (aromatic acids) can be analyzed without derivatization. The selectivity and sensitivity of CE combined with UV detection is adequate and makes it suited for fast routine characterization of lignins. If necessary, the CE method can be coupled with electrospray ionization mass spectrometry in order to make a clear assignment of the peaks.     

CZE separations of basic proteins at low pH in fused silica capillaries with surfaces modified by silane derivatization and/or adsorption of polar polymers

Mixtures of several basic proteins have been used to test CZE capillaries with surfaces modified by new pretreatment procedures; the performance obtained has been compared with that achieved using capillaries treated by procedures described in the literature. It has been shown that addition of non-ionic polyvinylalcohols (PVA) to CZE buffer solutions deactivates even bare, i.e. untreated, fused silica surfaces and renders them suitable for separations of basic proteins. The performance obtained from such surfaces was comparable with that of capillaries modified by the more elaborate procedures of etching, silanol derivatization, and/or adsorptive coating (again with polymers). A home-made device is described which enables derivatization and coating reactions to be performed on fused silica capillaries under an inert atmosphere, i.e. one free from oxygen and water.     

安培检测芯片毛细管电泳及其初步应用

An end-channel amperometric detector with a guide tube for working electrode was designed and integrated on a home-made glass microchip. The guide tube was directly patterned and fabricated at the end of the detection reservoir, which made the fixation and alignment of working electrode relatively easy. The fabrication was carried out in a two-step etching process. A 30 μm carbon fiber microdisk electrode and Pt cathode were also integrated onto the amperometric detector. The baseline separation of dopamine (DA), catechol (CA) and epinephrine (EP) was achieved within 80 s. Relative standard deviations of not more than 5.2% were obtained for both peak currents and migration times of DA and CA (n=5). Using standard adding method, DA in tLrine and plasma samples was detected. The recoveries were in the range of 83%—103%.     

Non-radioactive determination of PTH and dabsyl phosphoamino acids by capillary electrophoresis

Summary Capillary electrophoresis is a novel technique in the non-radioactive determination of phosphoamino acids. The main advantage of the method presented is the high selectivity and the ability to separate all phosphoamino acid derivatives. Non-radioactive determination of PTH or dabsyl phosphoamino acids by capillary electrophoresis provides a fast and simple screening procedure for all O-phosphorylated amino acids in protein and peptides in the low picomolar range.     

Background-free,fast protein staining in sodium dodecyl sulfate polyacrylamide gel using counterion dyes,zincon and ethyl violet

A background-free, fast protein staining method in polyacrylamide gel electrophoresis using an acidic dye, zincon (ZC) and a basic dye, ethyl violet (EV) is described. It is based on the counterion dye staining technique that employs two oppositely charged dyes to form an ion-pair complex in staining solution. The selective binding of free dye molecules to proteins in acidic solution produces bluish violet-colored bands. It is a rapid and end-point staining procedure, involving only fixing and staining steps that are completed in 1-1.5 h. The detection limit of this method is 8-15 ng of protein that is comparable to the sensitivity of the colloidal Coomassie Brilliant Blue G (CBBG) stain. Due to its sensitivity and speed, this stain may be more practical than any other dye-based stains for routine laboratory purposes.