Probing buried carbon nanotubes within polymer-nanotube composite matrices by atomic force microscopy

Multi-walled carbon nanotubes (MW-CNT) inside a polyamide-6 (PA6)-MW-CNT composite were visualized by atomic force microscopy (i) in a field-assisted intermittent contact and (ii) in the tunneling (TUNA) mode. Individual buried MW-CNTs were clearly discerned within the PA6 matrix. An average diameter of 33 ± 5 nm of the MW-CNTs was determined based on field-assisted intermittent contact mode AFM images, which is consistent with the expected size of PA6-coated MW-CNTs. Single well dispersed MW-CNTs that are located in the sub-surface region of the composite were also observed in the TUNA mode. These new AFM approaches circumvent the tedious sample preparation based on ultramicrotoming required for high resolution electron microscopy studies to obtain “in-depth” morphological information and hence are expected to facilitate the analysis of CNT-based and other nanocomposites in the future.     

AOPAN/PA-66复合纳米纤维膜的制备及对金属离子的吸附性能

采用双喷头电纺丝技术,将尼龙(PA-66)纤维增强的聚丙烯腈(PAN)纳米纤维膜(PAN/PA-66)与盐酸羟胺进行偕胺肟化反应,制备了一种偕胺肟化聚丙烯腈/尼龙复合纳米纤维膜(AOPAN/PA-66).通过红外光谱及扫描电子显微镜等方法研究了偕胺肟化前后纳米纤维膜的组成、形貌和力学性能;并考察了AOPAN/PA-66复合纳米纤维膜对铜离子和铅离子的吸附性能.结果表明,AOPAN/PA-66复合纳米纤维膜的抗拉伸强度及断裂伸长率分别为4.73 MPa和30.76%,对Cu(Ⅱ)及Pb(Ⅱ)的吸附量分别为67.5和75.4 mg/g.     

导电聚合物与锂二次电池

本文对聚合物的锂二次电池原理，发展、应用前景及今后的展望做了评述．     

FREE STANDING FILM OF POLYANILINE

A free standing film of polyaniline as large as 18 cm×18cm×0.002 cm can be obtained by evaporation of a solution of the chemically synthesized base in NMP. Its structure was examined by the elemental analysis, IR, U.V.-visible spectra, XPS, DSC, SEM and X-ray scattering and its conducting behavior as well as electrochemical properties were studied. Results show that the composition, structure of main chain, physical properties of the free standing film of polyanilme is similar to that of the powder. However, some differences in its electronic structure, conductivity at room temperature and potential of redox couple between the flee standing film and powder are observed, which may be due to cross-linking of the film of polyaniline.     

聚（3—丁基噻吩）电导的热稳定性

研究了导电聚合物聚（３－丁基噻吩）（ＰＢＴ）在大气环境下的导电热稳定性。在室温至２２０℃范围内，测试电导率随时间及温度的变化。ＴＧＡ分析以及化学分析的结果表明：掺杂态的ＰＢＴ大约在１４０℃附近有一转化温度，低于或高于这一转化温度，电导率下降的决定因素各不相同。高于转化温度时，电导率下降的主要原因是反离子和高分子主链的解离，进而发生化学反应，影响了高分子主链的结构。ＸＰＳ测试结果表明：经热处理后的Ｐ     

静电纺丝法制备La0.67Ba0.33MnO3微纳米纤维及其红外发射率研究

采用静电纺丝法结合溶胶-凝胶技术制备了钙钛矿型La_0.67Ba_0.33MnO₃微纳米纤维, 并利用差示扫描量热-热失重分析(DSC-TGA)、 X射线衍射(XRD)、 傅里叶变换红外光谱(FTIR)和扫描电子显微镜(SEM)等技术对产物进行了表征, 利用IR-2红外发射率测试仪测试了La_0.67Ba_0.33MnO₃在280~370 K范围内的红外发射率. 结果表明, La_0.67Ba_0.33MnO₃在600 ℃时已形成钙钛矿结构. 随着煅烧温度的升高, La_0.67Ba_0.33MnO₃的形貌由纤维状向三维网络状转变, 并最终失去纤维形态. 在280~370 K范围内, La_0.67Ba_0.33MnO₃微纳米纤维的红外发射率随温度升高而升高, 由0.564增加至0.689. 利用钙钛矿材料双交换理论解释了这一现象, 并进一步探讨了其在红外发射率可变材料中的应用前景.     

二次锂电池聚合物正极材料研究进展

近几十年,二次锂电池作为重要的储能装置得到迅猛发展,而开发高性能的锂电池电极材料一直是电化学能源领域的研究热点之一。与传统无机正极材料相比,聚合物正极材料具有比容量高、柔软性好、廉价易得、环境友好、加工方便、可设计性强等诸多优点。本文综述了导电聚合物、共轭羰基聚合物以及含硫聚合物正极材料的结构特点、电极反应机理、电化学性能和近五年来的重大研究进展,总结了这三类聚合物电极材料的优缺点,并重点介绍了含硫聚合物电极材料中存在的问题及改进手段,最后提出了综合这三类聚合物优点的含硫共轭导电聚合物将会是该领域的研究方向。     

Nanofibers prepared by electrospinning from solutions of biobased polyamide 4

A successful preparation of polyamide 4 nanofibers via electrostatic spinning with diameters close to 100 nm is described. Polyamide 4 was prepared by the anionic ring‐opening polymerization of 2‐pyrrolidone and characterized. The effect of the system parameters (i.e., molar mass of the polymer, the solvent system) and the process parameters (i.e., the electrode‐to‐collector distance) during the electrostatic spinning have been studied. The morphology of the polyamide 4 fiber layers is given except molar mass of the polymer and the concentration of its solution primarily by the conformation of polyamide chains due to polyelectrolyte effect which was confirmed by viscosity measurements. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2017 , 55, 2203–2210     

高分散钴氮共掺杂碳纳米纤维氧还原催化剂

过渡金属氮掺杂碳基催化剂已成为替代铂基氧还原反应(ORR)电催化剂的理想选择。本文通过静电纺丝技术制备了高比表面、高度分散的钴原子配位氮掺杂的碳纳米纤维催化剂(Co-N/C)。X射线衍射(XRD)和高分辨率透射电镜(HRTEM)结果证实Co元素高度分散于制备的Co-N/C催化剂中。X射线光电子能谱结果表明N元素主要以吡啶N和石墨N形式存在。该Co-N/C催化剂对ORR反应呈现出较高的电催化活性,其氧还原起始和半波电位分别为0.92 V和0.80 V(相对于标准氢电极),接近于商业化Pt/C催化剂的性能。以制备的Co-N/C催化剂作为阴极,25℃下锌空气燃料电池的开路电位1.54 V、最大功率密度达到了190 m V·cm~(-2)表明该催化剂具有良好的应用前景。     

掺杂态聚苯胺的共振拉曼光谱研究

观测了聚苯胺(PAn)在不同状态(掺杂、反掺杂、碱式、氧化、还原)下的拉曼光谱.根据其光谱特性,结合其它实验结果,提出了掺杂态PAn分子链包含电荷分布不等的三种苦环和二种氮原子的四单元苯醌变体模型,指出质子酸掺杂系分子内氧化还原反应,讨论了PAn氧化程度对掺杂效率的影响.