一种漂移室定位子性能反常现象的研究

研究了一种漂移室定位子性能的反常现象,它关系到定位子的使用寿命．着重测量了暗电流和随机噪声与时间、高压及温度的关系.     

用Josephson结电子模拟器测量磁通量子2e/h

介绍用Josephson结电子模拟器在政党温度下，模拟测量磁通量子2e/h，用模拟器来研究Josephosn结的特性。该实验可作为普通物理实验中课题设计实验的一个内容。     

电流并联负反馈放大器实验的研究

用实验的方法，研究电流并联负反馈对放大器性能的改善，提出电流型、并联型负反馈放大器性能参数的测量方法。     

等腰三角形Mindlin板的自由振动分析

提出了一种新方法来对基于 Mindlin剪切变形理论的等腰三角形板进行自由振动分析 .此方法采用了一种新的基函数并利用 pb-2 Rayleigh-Ritz边界函数得到了一种新型的 Ritz方法 .这种方法的有效性通过收敛性和对比性分析得到了证实 .数值结果表明此方法相当精确有效 .     

Tokamak中自举电流的剖面准直性

利用Harris模型,通过求解等离子体平衡方程,计算俘获粒子份额,分别对常规剪切和中心负剪切下tokamak中的自举电流的大小和剖面准直性进行了计算和分析.自举电流分布与等离子体平衡电流分布之间的剖面准直性可以通过调整等离子体的密度、温度和电流分布参数,以及描述等离子体形状的拉长度k和三角变形因子d来获得.中心负剪切位形有利于自举电流产生,并有好的剖面准直性.通过计算比较,分别在常规剪切位形下和中心负剪切位形下获得了一组优化的等离子体参数,在这组参数下,自举电流有较大的份额和好的剖面准直性 关键词： tokamak 自举电流 剖面准直性     

新疆野生黑加仑与马林果实的营养成分分析

通过对新疆野生黑加仑和野生马林的脂肪油，8种微量元素，17种氨基酸以及维生素C的含量进行测定得出：黑加仑脂肪油含量为17．9％，马林的脂肪油含量为22．3％，其中，黑加仑脂肪油中，r－亚麻酸的含量为19．02％，而马林中，其含量为9．40％，黑加仑中K，Na,Ca,Cu,Zn,Fe的含量比马林中的含量高，而Mn,Mg元素的含量却比马林含量低；马林的维生素C含量为16．22mg/g，黑加仑的含量为108mg/g，黑加仑的氨基酸的总量为1．63％，马林为1．14％。     

Tesla变压器型电子束加速器初步实验

 介绍了一种Tesla变压器型的强流电子束加速器。当变压器初级输入20kV左右的电压时，加速器二极管输出电压500kV，电流9kA，信号脉宽大约50ns，该装置具有结构简单，安装方便，运行可靠等特点。     

Magnetic hysteresis of the magnetoresistance and the critical current density in polycrystalline YBa2Cu3O7−δ–Ag superconductors

A systematic study of the magnetic hysteresis in transport properties of polycrystalline YBa₂Cu₃O_7−δ–Ag compounds has been made based on two kinds of measurements at 77 K and under applied magnetic fields up to 30 mT: critical current density J_c(B_a) and magnetoresistance R(B_a). The R(B_a) curves show a minimum in their decreasing branch occurring at B=B_min which was found to be both the excitation current I_ex and the maximum applied magnetic field B_am dependent. In addition, for a certain value of B_am>5 mT, we have observed that B_min increases with increasing I_ex and reaches a saturation value. The J_c(B_a) curves show a maximum in decreasing applied magnetic fields occurring at B=B_max. We have also found that B_max increases with increasing B_am and reaches a saturation value. The minimum in the R(B_a) and the maximum in J_c(B_a) curves were found to be related to the trapped flux within the grains. All the experimental results are discussed within the context of the flux dynamics and transport mechanisms in these high-T_c materials.     

Unusual current‐voltage characteristics of single crystalline and bicrystalline La0.7Ca0.3MnO3 films

The current‐voltage characteristics of single crystalline and bicrystalline La_0.7Ca_0.3MnO₃ films were measured and analyzed. Several epitaxial films, as well as 45° [001]‐tilt grain boundaries, display current‐voltage characteristics which are asymmetric with respect to polarity reversal of the bias current. One epitaxial film has a polarity dependent resistance of ～340kΩ and of ～670kΩ in forward and in reverse direction, respectively.     

The effect of construction material, contents and room geometry on the sound field in dwellings at low frequencies

An experimentally validated finite element method is used to model the sound level in rooms at low frequencies. It is demonstrated that the dimensions of rectangular rooms strongly influence the sound pressure level difference. Additional factors were investigated which are not normally considered in the frequency range where diffuse sound field conditions can be assumed. Three effects were investigated: room damping due to wall vibrations, furniture, the effect of small deviations from simple rectangular shapes. It is confirmed by field measurements that the vibrations of masonry walls and floors introduce less damping than surfaces of lightweight construction. Assigning to the FE model a damping equivalent to a surface absorption of 0.02 reproduces the effect of walls of heavyweight construction. Damping equivalent to a surface absorption of 0.15 reproduces the effects of plastered timber-frame walls, floors and ceilings. The work was briefly extended to a room pair built with heavyweight and lightweight material of construction. The modification of the shape of the room frequency response highlights well the effect of material of construction. In-situ and laboratory measurements show that furniture has little effect on steady-state room response below 100 Hz. Modelling a wall recess smaller than 0.5 m improved the agreement between prediction and measurements but the assumption of a simple rectangular room remains appropriate.