Temperature Development of Homo- and Hetero-Clustering in Saturated Vapors

Computational findings of temperature increase of clustering degree in saturated vapors are analyzed. A thermodynamic proof is presented and a simple criterion derived. Illustrations are based on saturated steam, magnesium and carbon vapor. The results are applicable to synthesis of fullerenes, metallofullerenes, and heterofullerenes, chemical vapor deposition technique, or atmospheric chemistry.     

关于meso—四苯基卟啉在冰醋酸中的存在形式

前言卟啉在生物化学、分析化学、药物化学等领域有着广泛研究和重要应用［１～３］。近年来虽然对卟啉类化合物的研究报道很多［４～６］，但对卟啉在酸性介质中的研究很少。较早期的研究工作认为卟啉类化合物在酸性介质中仅以其二酸形式存在［７］。本文实验结果显示ｍｅ...     

Structural and magnetic investigations of the mixed-valence Fe(II,III) two-dimensional layer complex, [Fe2(II) Fe2(III)(HCOO)10(C6H7N)6]n.

The structure of the complex, [Fe2(II)Fe2(III)(HCOO)10(C6H7N6)n, (1) exhibits a neutral two-dimensional layer network of alternating iron(II) and iron(III) ions, bridged equatorially by formate groups. All iron atoms are octahedrally coordinated, with iron(III) coordinating axially to one gamma-picoline and one formate group, while the iron(II) centers interact axially with two gamma-picoline groups, above and below the layer plane. The complex crystallizes in the triclinic space group P1 at all studied temperatures [at 120 K, the cell dimensions are: a = 10.228(1), b = 12.071(1), c = 12.072(1) A, alpha = 89.801(2), beta = 71.149(2), gamma = 73.371(2) degrees]. An intralayer antiferromagnetic exchange interaction of J = -2.8 cm(-1) between iron(II) and iron(III) was observed in the magnetic studies. Decreasing the temperature to close to 20 K causes a magnetic-ordering phenomenon to occur and a low-temperature phase with a long-range antiferromagnetic spin orientation appears. The magnetic phase transition was confirmed by M?ssbauer spectroscopic studies at temperatures above and below the critical temperature. Structural information of 1 from synchrotron X-ray diffraction data collected at room temperature and 16 K suggests that the antiferromagnetic ordering is caused by an enhanced pi-pi interaction between chi-picoline groups from adjacent layers.     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Hydride generation atomic fluorescence spectrometric determination of ultratraces of selenium and tellurium in cow milk

A sensitive procedure has been developed for selenium and tellurium determination in milk by hydride generation atomic fluorescence spectrometry (HG-AFS) after microwave-assisted sample digestion. The method provides sensitivity values of 1591 and 997 fluorescence units ng⁻¹ ml⁻¹ with detection limits of 0.005 and 0.015 ng ml⁻¹ for Se and Te, respectively. The application of the developed methodology to the analysis of cow milk samples of the Spanish market evidenced the presence of concentration ranges from 11.1 to 26.0 ng ml⁻¹ for Se, and from 1.04 to 9.7 ng ml⁻¹ for Te having found a good comparability with data obtained after dry-ashing of samples.     

Tetra- and hexaatomic cyclic clusters of main-group elements (XY)2 and (XY)3: an ab initio and density functional study

The electronic and molecular structure of planar (cyclic and linear) tetra- and hexaatomic clusters (XY) _n (XY = CC, BN, BeO, LiF; n = 2, 3) was studied using the ab initio CCD(full)/6-311+G** method and density functional approach (B3LYP/6-311+G**). The stability of cyclic clusters C₆, B₃N₃, and Be₃O₃ with D_3h symmetry is mainly determined by the aromaticity of their -electron systems.     

Direct analysis of fly ash materials by inductively coupled plasma atomic emission spectrometry using slurry nebulization

Fly ash samples of cement works were analysed using slurry nebulization inductively coupled plasma atomic emission spectrometric (ICP-AES). Because of the influence of the experimental factors on the signal intensity, the optimal conditions of the analysis circumstances were determined. Control analyses (wet digestion followed by ICP-AES, and XRF of dry powders (pressed pellets)) were also carried out to compare the results. Based on the result, it was concluded that the slurry nebulization method using slurry standard of same type reference material for calibration can be applied for rapid but less precise (RSD 5–10%) determination of the elements in fly ash.     

毛细管电泳-电感耦合等离子体原子发射光谱法对田七提取液中Fe、Cu和Mg存在状态的研究

提出了以水作溶剂微波萃取提取,并以毛细管电泳电感耦合等离子体原子发射光谱(CE-ICP-AES)法测定田七提取液中Mg、Cu和Fe的形态的分析方法。实验结果表明:Mg仅以游离态存在;而Cu和Fe除了游离态以外,还存在其它三种未知的形态。此外,还测定了田七中20个微量元素的总含量,并得到了上述待测元素在水提取液中的提取率。     

5,9,14,18,23,27,32,36-八烷氧基2,3-萘酞菁镍(Ⅱ)的结构与光谱性质关系的研究

测定了一组八烷氧基萘酞菁镍（Ⅱ）配合物Ni（Ⅱ）（RO）8NPC（R＝C4H9，C8H17，C12H25，NPC＝C48H16N8）在5种有机溶剂（Py、DMSO、DMF、CH2Cl2、C6H12）中的电子吸收光谱和荧光光谱，研究了这些配合物的结构与光谱的关系。结果表明该系列RO取代萘酞菁镍（Ⅱ）配合物的Q带吸收光谱比无取代的红移75nm左右，荧光光谱屯相应红移50～80nm，而溶剂对其影响不大。