活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

A New Neutral Carrier for Silver Ions Based on a Bis(Thiothiazole) Derivative and its Evaluation in Membrane Electrodes

Membrane electrodes based on 2,2-dithiobis(benzothiazole), DTBBT, as a neutral carrier for silver ions are described. Silver-selective membrane electrodes formulated with 2wt% DTBBT ionophore and 50mol% TFPB in an FPNPE plasticized poly (vinyl chloride) exhibited near-Nernstian responses towards silver ions (60.3±0.5mVdecade^–1) over a wide silver ion activity range of 0.83µM to 94mM. Increasing the amount of anionic sites, TFPB, to 100 or 150mol% (relative to the DTBBT weight) resulted in super-Nernstian responses toward silver ions. Membrane electrodes prepared using a low dielectric constant plasticizer, however, exhibited sub-Nernstian responses. Polymer membrane electrodes with optimal composition (i.e., 2wt% DTBBT, 50mol% TFPB in FPNPE plasticized poly(vinyl chloride)) exhibited high potentiometric selectivity towards silver ions over alkali, alkaline earth, transition metal ions, as well as heavy metal ions such as Hg²⁺ and Pb²⁺. A good correlation was found between the potentiometric selectivity coefficients and the change in the UV-visible spectra of the ionophore upon exposure to different metal ions. The overall performance of the silver-selective membrane electrodes based on DTBBT ionophore, which is available at low cost, was found to be comparable to the performance of silver electrodes prepared with Fluka silver ionophore-IV. A DTBBT-based silver electrode was used as an indicator electrode for titrations of silver ions using standard sodium chloride solutions. Sharp inflections occur at the end point, and the data obtained showed 99.4% recovery with a standard deviation of 0.7% (n=3). In addition, the applicability of the DTBBT-based silver-selective electrode is illustrated by measuring the silver concentrations in natural water spiked with silver nitrate and by analyzing the silver in electroplating wastewater samples. The results obtained utilizing a DTBBT-based silver electrode showed very good agreement with the standard methods of analysis.     

Pretreatment of swine wastewater using anaerobic filter

Efforts were made to assess the efficiency of an anaerobic filter packed with porous floating ceramic media and to identify the optimum operational condition of anaerobic filter as a pretreatment of swine wastewater for the subsequent biological removal of nitrogen and phosphorus. A stepwise decrease in hydraulic retention time (HRT) and an increase in organic loading rate (OLR) were utilized in an anaerobic filter reactor at mesophilic temperature (35°C). The optimum operating condition of the anaerobic filter was found to be at an HRT of 1 d. A soluble chemical oxygen demand (COD) removal efficiency of 62% and a total suspended solids removal efficiency of 39% at an HRT of 1 d were achieved with an OLR of 16.0 kg total COD/(m³·d), respectively. The maximum methane production rate approached 1.70 vol of biogas produced per volume of reactor per day at an HRT of 1 d. It was likely that the effluent COD/total Kjeldahl nitrogen ratio, of 22, the COD/total phosphorous ratio of 47, and the high effluent alkalinity >2500 mg/L as CaCO₃ of the anaerobic filter operated at an HRT of 1 d was adequate for the subsequent biological removal of nitrogen and phosphorus.     

Treatment of dairy wastewater using a selected bacterial isolate, Alcaligenes sp. MMRR7

Physicochemical and biologic analysis of dairy wastewater showed that the effluent had a high organic load (chemical oxygen demand [COD]: 5095 mg/L), an acidic pH (6.4), and a high probability of coliforms (most probable number [MPN]>1100). The various bacterial strains isolated and purified were identified as Sporolactobacillus sp., Citrobacter sp., Pseudomonas sp., Alcaligenes sp., Bacillus sp., Staphylococcus sp., and Proteus sp., as per the Bergey’s manual of systematic bacteriology. Among the five selected bacterial strains, the strain designated as MMRR₇ and identified as Alcaligenes sp. was found to give a maximum reduction in COD (62%) in 5 d of incubation. Chemical coagulation using alum at a concentration of 0.5 g/100 mL was found to be effective in the primary treatment of the effluent. Studies on free-cell treatment of the coagulated effluent with the selected bacterial strain Alcaligenes sp. MMRR₇ gave a maximum COD reduction of 91% in 120 h. This study clearly indicates the possibility of using Alcaligenes sp. MMRR₇ for the effective treatment of dairy wastewater.     

Long-term study of an intermittent air sparged MBR for synthetic wastewater treatment

Membrane bioreactors (MBR) combine biological processes with membrane filtration. Advantages of MBR in municipal wastewater treatment include high effluent quality and reduced space requirements. Steady operation of membrane plants requires careful management of membrane fouling. Even though it might be impossible to prevent, fouling can be limited by techniques such as gas sparging. The injection of gas bubbles increases the shear stress and removes fouling material from the membrane surface. Most cited literature on air sparging refers to short-term experiments, often times in bench scale. The aim of this study was therefore long-term investigations in pilot plant scale of a 70 L reactor fed with glucose-based synthetic wastewater. The main focus was on enhancing permeate flux by air sparging. The results showed that using air sparging significantly increased the permeate flux was doubled even over several weeks. The findings were interpreted using the dimensionless fouling and shear stress number. The fouling resistance was found to decrease significantly with air injection ratios between 0.4 and 0.5. When air sparging was applied after a period without air sparging, the shear stress number doubled. This increase in shear led to a reduction of the fouling number by approximately 30%. During several weeks air sparging only a slow fouling number increase was. In contrast to that after air sparging was ceased, an exponential increase of the fouling number was observed.     

Bi2O3-WO3光催化臭氧氧化降解糖蜜酒精废水的研究

采用固相合成法制备了Bi2O3-WO3光催化剂,研究了Bi2O3-WO3光催化与臭氧氧化协同降解糖蜜酒精废水的多相催化降解过程,并采用X射线衍射光谱(XRD)、紫外漫反射光谱(DRS)、热重-差热扫描(TG-DSC)等手段对Bi2O3-WO3催化剂进行了表征.研究发现:Bi2O3-WO3是一性能良好的光催化剂,臭氧强化了Bi2O3-WO3光催化氧化过程,反应2 h后,糖蜜酒精废水的脱色率可达90.2%.Bi2O3-WO3光催化剂的禁带宽度为2.92 eV,其中γ-Bi2WO6和Bi2W2O9是其活性中心.焙烧温度对Bi2O3-WO3光催化剂的活性有较大的影响,其中1 073 K为适宜的焙烧温度.     

Chitosan as a biosorbent for adsorption of iron (II) from fracking wastewater

In this work, porous chitosan (CS) was investigated as a biosorbent for the removal of iron (II) from the synthetic fracking wastewater. The underlying problem with the production water from fracking industries is that it contains iron (II) up to 55 mg/L, which needs to be eliminated. Porous CS had a specific surface area of 1.05 m²/g with the average pore diameter of 319 A, as determined by using Brunauer‐Emmett‐Teller surface area analysis. The kinetics, isotherms, and thermodynamic analysis confirm that the porous CS can be a potential candidate for iron (II) removal. Both the pseudo‐first‐order model and pseudo‐second‐order model have good fit on iron (II) adsorption with the porous CS. Kinetic studies revealed that the CS‐iron (II) adsorption system was controlled by intraparticle diffusion. The monolayer adsorption capacity of the porous CS from Langmuir model was found to be 51.81 mg/g. The experimental data were fitted against common adsorption isotherms and yielded excellent fits in the following order: Langmuir > Temkin > Freundlich > Dubinin‐Radushkevich isotherms. Thermodynamic studies revealed that the adsorption of iron (II) onto porous CS was feasible and spontaneous. The adsorption process is endothermic, and the entropy is the driving force.     

Prediction of intracellular storage polymers using quantitative image analysis in enhanced biological phosphorus removal systems

The present study focuses on predicting the concentration of intracellular storage polymers in enhanced biological phosphorus removal (EBPR) systems. For that purpose, quantitative image analysis techniques were developed for determining the intracellular concentrations of PHA (PHB and PHV) with Nile blue and glycogen with aniline blue staining. Partial least squares (PLS) were used to predict the standard analytical values of these polymers by the proposed methodology. Identification of the aerobic and anaerobic stages proved to be crucial for improving the assessment of PHA, PHB and PHV intracellular concentrations. Current Nile blue based methodology can be seen as a feasible starting point for further enhancement. Glycogen detection based on the developed aniline blue staining methodology combined with the image analysis data proved to be a promising technique, toward the elimination of the need for analytical off-line measurements.     

不同碱基物质对燃煤烟气脱氯的影响

实验探究NaOH、Na₂CO₃、NaHCO₃这三种常见的碱基物质在模拟燃煤烟气中的实际表现，发现三种碱基物质均具有一定的脱氯性能，NaOH、Na₂CO₃、NaHCO₃的脱氯性能依次下降，以脱氯效率70%为目标，使用三种碱基物质Na/Cl比分别需要达到5.8、7.1、8.7。高浓度SO₂的存在对烟气脱氯有竞争作用，随着SO₂浓度的提高，脱氯效率线性下降，不同碱基物质下，SO₂浓度对脱氯效率的影响规律基本一致，SO₂浓度每增加100 mg/m³，脱氯效率下降约1.4%。由于三种碱基物质达到相同脱氯效率时的Na/Cl比不同，综合考虑成本和溶解性，NaOH最具工业应用价值。     

Rapid and easy quantification of elemental sulphur in aqueous samples from biological reactors: the turbidimetric method revisited

Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R² = 0.99994) in the studied range (5 to 100 mg S° L^?1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.