基团的电子效应与单取代苯对位^1H,^13C的化学位移

基团的电子效应与单取代苯对位１Ｈ、１３Ｃ的化学位移＊韩长日冯娇杨钟照平（海南师范学院化学系海口５７１１５８）关键词１Ｈ的化学位移１３Ｃ的化学位移基团电负性共轭效应引言在１Ｈ、１３Ｃ核磁共振谱中，化学位移值的大小主要取决于屏蔽作用的大小，而屏蔽作用的大...     

球壳烯类的化学修饰

自从Kratschmer和Huffman发表了较为简便的制备和分离碳-60,碳-70的方法以来,对于球壳烯类,特别是碳-60的表征和物化性质已进行了较为翔实的研究。关于球壳烯类的化学修饰,尽管起步较晚,对其兴趣也日益高涨。本文综述了球壳烯类的化学修饰,特别在球壳烯外壳的化学反应方面。     

Composition and spectral studies of polyaniline salts

Five different polyaniline salts have been prepared by chemical polymerization of aniline in aqueous solution of different acids. The polyaniline base was obtained from the corresponding polyaniline salt by dedoping using aqueous ammonium hydroxide solution. Electron paramagnetic, electronic absorption, infrared spectral and conductivity measurements have been performed on the polyaniline salts and polyaniline bases. This composition and the extent of dopant in polyaniline salt systems have been determined. There is no definite correlation between the conductivity and the stoichiometric ratio between the polyaniline base and the acid, and also the spin concentration.     

Biomimetic piezoelectric quartz sensor for caffeine based on a molecularly imprinted polymer

A piezoelectric quartz sensor coated with molecularly imprinted polymer (MIP) for caffeine was developed. The MIP was prepared by co-polymerizing methacrylic acid (MAA) and ethylene glycol dimethacrylate (EDMA) in the presence of azobis(isobutyronitrile) as initiator, caffeine as template molecule, and chloroform as solvent. The MIP suspension in polyvinyl chloride/tetrahydrofuran (6:2:1 w/w/v) solution was spin coated onto the surface of the electrode of a 10 MHz AT-cut quartz crystal. The sensor exhibited a linear relationship between the frequency shift and caffeine concentration in the range of 1×10^–7 mg mL^–1 up to 1x10^–3 mg mL^–1 [correlation coefficient (r)=0.9935] in a stopped flow measurement mode. It has a sensitivity of about 24 Hz/ln(concentration, mg mL^–1). A steady-state response was achieved in less than 10 min. The performance characteristic of the sensor shows a promising and inexpensive alternative method of detecting caffeine. Surface studies were carried out for the reagent phase of the sensor using SEM, AFM, and XPS analysis in order to elucidate the imprinting of the caffeine molecule. The SEM micrograph, AFM image, and XPS spectra confirmed the removal of caffeine by Soxhlet extraction in the imprinting process and the rebinding of caffeine to the MIP sensing layer during measurement.     

Probing the hydride transfer process in the lumiflavine-1-methylnicotinamide model system using group softness

The hydride transfer process between the isoalloxazine moiety of flavins and the nicotinamide moiety of NAD(P)H has been explored by using density functional theory based reactivity index in the 1-methylnicotinamide-lumiflavine model system. Based on crystallographic data available, we have found that the group softness index helps to locate and orientate reactive regions in these interacting molecules while the electrophilicity index successfully describes the reactivity pattern of this system.     

Synthesis of non-agglomerated Ba<Subscript>0.77</Subscript>Ca<Subscript>0.23</Subscript>TiO<Subscript>3</Subscript> nanopowders by a modified polymeric precursor method

In this work, we have studied the influence of the pH on the synthesis and structural properties of the Ba_0.77Ca_0.23TiO₃ nanopowders synthesized by a modified polymeric precursor method, in order to achieve non-agglomerated powders. Synthesis, morphology, thermal reactions, crystallite and average particle size of the synthesized powders were investigated through thermal analysis (DTA/TG), X-ray diffraction (XRD), field emission scanning electron microscope (FE-SEM) and Infrared spectroscopy. In summary, Ba_0.77Ca_0.23TiO₃ nanopowders were synthesized for the first time at a relative low temperature (500 °C). It was also found that the alkalinity and acidity of the solution presented a great influence on the powder properties. The best results were obtained from solutions with pH = 8.5 and 11 whose nanopowders presented weakly agglomerate, with homogeneous particle size and a narrow size distribution (30–40 nm). This behavior could be explained based on the FT-IR results in which it was possible to see the increased of the chelation in higher pHs.     

Synthesis, structure and magnetic properties of the S=1/2, one-dimensional antiferromagnet, Y5Re2O12

Single crystals of Y₅Re₂O₁₂ have been grown, and the crystal structure has been determined by X-ray diffraction. This compound crystallizes in space group C2/m with cell dimensions of a=12.4081(10) Å b=5.6604(5)Å, c=7.4951(6) Å, β=107.837(3)°, Z=2. The final refinement led to R1=0.0238, WR2=0.0459 for 1053 observed reflections with F>4σ(F₀). Edge-sharing ReO₆ octahedra form infinite linear [ReO₂O_4/2]_n chains along the b direction with alternating short and long Re-Re distances. Three crystallographically independent yttrium atoms surround O2 to form OY₄ tetrahedra, which share edges and corners in the ab plane to form a two-dimensional Y₅O₄ network which separates the [ReO₂O_4/2]_n magnetic chains. This compound is therefore isostructural with the series Ln₅Re₂O₁₂Ln=Gd-Lu, which have been known since 1969. The average Re oxidation state is +4.5 in the chains and a reasonable, if qualitative MO scheme results in one unpaired electron per Re dimer. Consistent with this, magnetic susceptibility data can be fitted to the one-dimensional antiferromagnetic Heisenberg model with S=1/2 and parameters J^intra/k=−89(1)K, g=2.15(4) and χ(TIP)=5(1)×10⁻⁴ emu/mol. There is no sign of long-range magnetic order down to 2 K. These results are contrasted with those for the isostructural Y₅Mo₂O₁₂.     

DMF-甲醇体系粘度与核磁共振化学位移的同时关联

提出了一个基于局部组成概念上的核磁共振模型. 利用该模型和以前别人提出的局部组成型粘度方程, 成功地同时关联属于传递性质的粘度数据和属于波谱性质的核磁共振化学位移数据，关联所得到化学位移的平均绝对偏差小于0.0072，粘度的平均绝对偏差小于0.0006 mPa•s，结果表明提出的局部组成模型是合理的.     

Classical Valence Similarity in Fullerene Derivatives

Summary.  The generalized Pauling bond order was enumerated in the C₆₀ fullerene cage molecule (truncated icosahedral symmetry). This index measures chemical similarity in fullerene derivatives such as dihydrofullerene (C₆₀H₂), anionized monohydrofullerene (C₆₀H⁻), N-substituted monohydrofullerene (C₅₉NH), the fullerene dimer ((C₆₀)₂), and the dianionic fullerene dimer ((C₆₀)₂ ²⁻). It is also useful in judging the chemical stability of isomers. Received October 9, 2001. Accepted November 9, 2001     

Nafion-PAN optical chemical sensor: optimization by FIA

A copper-sensitive optical chemical sensor (optrode) is described. The optrode is based on a Nafion membrane and an immobilized organic ligand coupled with a flow injection (FI) system. The FI system includes a flow-through removable measuring cell and a simple spectrophotometer. Owing to the miniature size of the system and the efficient use of optical fibers, this optrode is well suited for monitoring environmental water samples. The success of the described optrode system depends on the effectiveness of the FI reagent delivery system. Optimum contact time with the membrane (as determined by the reagent flow rates) and the injected sample volume are critical. Environmental water samples were analyzed for copper content using the optimized optrode system. To validate the optrode's performance, the same water samples were analyzed using the atomic absorption spectrophotometer.