小分子硫原子团簇正离子的结构稳定性

用分子图形软件设计出 4 9种硫原子团簇Sn+ (n =3～ 13)的结构 ,使用B3LYP密度泛函进行几何构型优化和振动频率计算 ,根据分子的总能量得出最稳定的同分异构体 .在硫原子团簇正离子中 ,大部分原子为二配位成键 .带有一、三配位的原子结构的总能量较高 .部分最稳定硫原子团簇正离子的构型与最稳定的中性硫原子团簇的构型完全不同 .     

DIELECTRIC EFFECT ON THE RADIO-FREQUENCY CHARACTERISTICS OF A RECTANGULAR WAVEGUIDE GRATING TRAVELING WAVE TUBE

A new type of partial-dielectric-loaded rectangular waveguide grating slow-wave structure (SWS) for millimeter wave traveling wave tube (TWT) is presented in this paper. The radio-frequency characteristics including the dispersion properties, the longitudinal electric field distribution and the beam-wave coupling impedance of this structure are analyzed. The results show that the dispersion of the rectangular waveguide grating circuit is weakened, the phase velocity is reduced and the position of the maximum E _z is basically invariant after partially filling the dielectric materials in the rectangular waveguide grating SWS. Although the coupling impedance decreases a little, it still keeps above 40 Ω.     

Comparative Study on Large and Small Signal Theory for Intensity Modulation Response of Semiconductor Lasers Including Higher-Order Dispersion Terms

In this article, the comparison of large signal theory and small signal theory has been done with dispersive propagation of optical signal with IMDD (Intensity Modulation Direct Detection) systems for semiconductor lasers with higher-order dispersion terms. The expressions for an exact large signal theory and small signal theory including higher-order dispersion terms for propagation of an optical wave with sinusoidal amplitude and frequency modulation in a dispersive fiber have been derived. It is observed that small signal theory is more sensitive compared to large signal theory in terms of intensity modulation/direct detection systems. Also, it is reported that for large signal analysis the higher-order effects of dispersion can be ignored, whereas for small signal theory, the higher-order effects can be ignored for lower modulation frequencies only. The variation in the transfer function for various values of modulation indices are greater for small signal analysis than for large signal analysis. Also, as the intensity modulation index is increased, there is a decrease in the value of transfer function. The large signal model approximates the small signal model for lower values of the intensity modulation index.     

双包层椭圆光波导解析解

解析求解了双包层椭圆光纤中的波动方程，得到了模式精确解有模式特征方程。对基模的特征方程进行了数值计算，给出了不同椭圆比下的归一化双折射和模间色散随归一化频率的变化关系曲线，并与高斯近似解的结果进行了比较。     

Spherical dye-doped silica particles

Organic dyes such as water soluble porphyrins were incorporated into monodispersed SiO₂ particles using the sol-gel technique (the Stober synthesis) and their monomeric and dimeric properties were investigated by aiming at the microcavity effect. Doping efficiencies of dyes into SiO₂ particles depended on dye's hydrophilic properties. The doping efficiency of a porphyrin, TTMAPP, decreased with increasing the nominal content in the starting solution and the doping content showed the maximum value of 1.6×10^–5 mol/g SiO₂. With increasing the TTMAPP content, spectra of doped particles were changed from dimeric to monomeric nature; the absorption peak due to dimers disappeared and halfwidth of absorption at Soret band decreased. This unusual change was caused by the decrease of particle sizes by dye doping. The TTMAPP-doped sample having monomeric spectrum showed the fluorescence life time of 8.5 nsec and photochemical hole burning at about 5 K.     

含氰基的酚醛树脂及其碳纤维复合材料

含氰基的酚醛树脂，具有优异的耐高温性能和高温下的机械强度，在３１５℃下性能变化甚小；不着火，发烟量低，有良好的加工成型性能。热固化过程中氰基成三嗪环而交联，没有小分子脱出，是一类具有广泛发展前景的新型热固性树脂。     

Carbon–epoxy composites based on fibers coated with nylon 6,6: hygrothermal ageing versus interlaminar shear strength

Carbon fibers were coated in situ with a thin film of polyhexamethylene adipamide by an interfacial polycondensation technique. The modified fibers were used for the preparation of epoxy-based unidirectional composites. Specimens of these materials were immersed in water until equilibrium conditions were attained. The weight gain at equilibrium was determined as a function of the immersion temperature, the fiber volume fraction and the polyamide content deposited on the fibers. Water penetration in specimens made with uncoated carbon fibers increases when the volume fraction decreases. Introduction of the polyamide interlayer initially increases the water absorption, but reduces it at higher immersion temperatures and/or higher polyamide contents. The treated specimens were subjected to the short beam test to determine the interlaminar shear strength (ILSS). The data show that the ILSS decreases with water penetration but increases when the immersion temperature increases from 40 to 70°C. The overall performance encountered is discussed in terms of the possible roles of the polyamide interphase while taking into account mechanisms concerned with matrix plasticization, interphase degradation and residual stress relaxation.     

Effect of structural variation within cationic azo-surfactant upon photoresponsive function in aqueous solution

The cationic azo-surfactants possessing different spacers and tail alkyl chain lengths have been synthesized by azocoupling ofp-alkylaniline orop-ethoxyaniline with phenol, followed by alkylation and quaternalization with dibromoalkane and trimethylamine, respectively. These surfactants showed a good solubility in water. A reversibletrans-cis isomerization of the azosurfactants by photoirradiation was assessed by UV-Vis absorption spectra. Due to a difference in HLB between thetrans- andcis-surfactants, the observed critical micelle concentration (CMC) values and the electric conductivity of the surfactant solution at above the CMC were significantly affected by the photoinducedtrans-cis isomerization. The azo-surfactants bearing moderate alkyl chain lengths such as surfactants 6 (R₂=C₂H₄, R₃=C₄H₉) and 9 (R₂=C₄H₈, R₃=C₂H₅) were found to be effective to achieve large CMC changes (3.6 mmol/L for 6 and 5.9 mmol/L for 9) by UV-light irradiation. The replacement of the tail chain species also affected the photoresponsive function. The surfactant 12, possessingp-ethoxy group as the tail chain, was found to form a stable micelle aggregation as compared with the structurally related surfactant 10 having ethyl unit as its tail group, but it exhibited a large CMC change (5.3 mmol/L) by UV-light irradiation.     

Influence of Particle Morphology and Flow Conditions on the Dispersion Behavior of Fumed Silica in Silicone Polymers

The dispersion behavior of agglomerates of several grades of fumed silica in poly(dimethyl siloxane) liquids has been studied as a function of particle morphology and applied flow conditions. The effects of primary particle size and aggregate density and structure on cohesivity were probed through tensile and shear strength tests on particle compacts. These cohesivity tests indicated that the shear strength of particle compacts was two orders of magnitude higher than the tensile strength at the same overall packing density. Experiments carried out in both steady and time‐varying simple‐shear flows indicate that dispersion occurs through tensile failure. In the steady‐shear experiments,enhanced dispersion was obtained at higher levels of applied stress and, at comparable levels of applied stress, dispersion was found to proceed faster at higher shear rates. Experiments conducted in time‐varying flows further corroborated the results obtained in tensile cohesivity tests. Experiments in which the mean and maximum stresses in the time‐varying flows were matched to the stresses produced in steady shear flows highlight the influence of flow dynamics on dispersion behavior.     

Dynamic mechanical analysis

Using dynamic mechanical analysis (DMA) we have studied thermal degradation for a system containing a diglycidyl ether of bisphenol A (DGEBA) and 1,3-bisaminomethylcylohexane (1,3-BAC). The changes of dynamic mechanical properties during thermal degradation indicated a shift of the glass transition temperature (T _g) to higher temperatures and a decrease in the peak value of the dynamic loss factor (tan δ) with an increasing of aging time. The value of dynamic storage modulus (E′) at the rubbery state showed an increase with aging time, whiteE′ at the glassy state only underwent a moderate change with increased thermal degradation. From these results it can be argued that thermal degradation during the stage prior to the onset of the severe degradation involves structural changes in the epoxy system, as further crosslinking and loss of dangling chains in the crosslinked network.