阳离子交换膜催化合成乙酸丁酯动力学研究

研究了以阳离子交换膜为催化剂合成乙酸丁酯的动力学,回归得出催化剂的影响函数f(w),动力学方程中指前因子k0=2284024.48L/mol·min,活化能Ea=52102.95J/mol,建立动力学模型,得到实验范围内的动力学方程并对动力学方程的正确性进行了验证。     

3,3'-双叠氮甲基环氧丁烷-3-叠氮甲基-3'-甲基环氧丁烷无规共聚物的合成与结构表征

以1,4-丁二醇/三氟化硼乙醚为引发体系, 利用阳离子开环共聚合方法合成了3,3'-双叠氮甲基环氧丁烷(BAMO)与3-叠氮甲基-3'-甲基环氧丁烷(AMMO)的无规共聚物, 探讨了以Lewis酸为催化剂时活性链端与活性单体相互竞争的聚合反应机理. 同时根据GPC结果分析了聚合反应温度对产物分子量和分子量分布的影响. 结果表明, 在15 ℃时产物分子量可控且分布较窄. 通过1H NMR和13C NMR对无规共聚物的共聚组成及微观序列结构进行了表征, 结果表明, 共聚组成中两单体的摩尔比接近于1:1, 与投料比一致; 交替度接近50%, BAMO与AMMO链段的平均序列长度为2, 其结构单元呈随机分布的状态.     

高效发光材料[(C^N)2IrL]+阳离子配合物的结构和光谱特征

从理论上研究了一系列Ir(Ⅲ)[(C^N)2IrL]+[C^N=ppy, L=pzpy(1); C^N=dfppy, L=pzpy(2); C^N=ppy, L=pybi(3); C^N=tpy, L=acac(4); 其中ppy=2-苯基吡啶, dfppy=2-(2,4-双氟苯基)吡啶, pzpy=2-吡唑基吡啶, pybi=1-苯基-2-(吡啶基)-1H-苯并咪唑, tpy=2-(4-甲苯基)-吡啶, acac=乙酰丙酮]配合物的结构和光谱特征. 分别在B3LYP/LanL2DZ和CIS/LanL2DZ计算水平下优化了它们的基态和激发态结构. 计算得到的Ir-N, Ir-C和Ir-O基态键长和相应实验值符合较好. 在激发态下, Ir-N和Ir-C键长增加了约0.0003~0.003 nm, 而Ir-O键长则缩短了约0.0012 nm. 在含时密度泛函理论(TD-DFT)计算水平下, 结合极化连续介质模型(PCM), 得到配合物1~4的最低能的吸收和发射分别出现在398 nm(1), 370 nm(2), 419 nm(3)和437 nm(4)以及511 nm(1), 457 nm(2), 602 nm(3)和479 nm(4). 配合物1, 2, 4的跃迁属于d(Ir)+π(C^N)→π*(C^N)的电荷转移跃迁, 而化合物3的跃迁则归因于d(Ir)+π(C^N)→π*(pybi)的电荷转移跃迁. 这表明此类配合物的吸收和发射主要受前线分子轨道的金属成分控制, 同时也受辅助配体L的影响.     

Rheological Behavior of Aqueous Solutions of Cationic Guar in Presence of Oppositely Charged Surfactant

The cationic guar (CG) is synthesized and the rheological behavior of aqueous solutions of CG in the presence of sodium dodecyl sulfate (SDS) is studied in detail. The steady viscosity measurements show that the zero shear viscosity enhancement can be almost 3 orders of magnitude as the concentration of SDS increases from 0 to 0.043%. The gel-like formation is observed as the concentration of SDS is greater than 0.016%. The oscillatory rheological measurements of CG solutions in the presence of SDS show that the crossover modulus is almost independent of the concentration of SDS whereas the apparent relaxation time increases swiftly upon increasing the concentration of SDS. The experimental results indicate that the strength rather than the number of the cross-links is greatly affected bySDS molecules. The mechanism concerning the effect of SDS upon the rheology of CG solutions can be coined by the two-stage model. Before the formation of cross-links at the critical concentration, the electrostatic interaction between SDS and cationic site of CG chains plays a key role and the SDS molecules bind to CG chains through the electrostatic interaction. After the formation of cross-links at the concentration greater than the critical concentration, the cooperative hydrophobic interaction become dominant and SDS molecules bind to the cross-links through the hydrophobic interaction. The rheological behavior of aqueous solutions of CG in the presence of SDS is chiefly determined by the micelle-like cross-links between CG chains. In fact, the flow activation energy of CG solution, obtained from the temperature dependence of the apparent relaxation time, falls in the range of transferring a hydrophobic tail of SDS from the micelle to an aqueous environment.     

芳茂铁阳离子聚合光引发剂引发活性研究

研究了7种不同芳烃结构的芳茂铁四氟硼酸盐作为阳离子紫外光聚合和光固化引发剂在环氧体系中的光引发活性,其中[C₅H₅Fe₂,5-(CH₃)₂CO^-C₆H₃]BF₄(Ⅵ)和[CH₃CO^-C₅H₄Fe₂,4-(CH₃)₂-C₆H₄]BF₄(Ⅶ)为新物质.研究发现,这7个芳茂铁四氟硼酸盐在370和450nm附近均有较强吸收;芳环上引入共轭CC和共轭CO使吸收峰发生红移,且使摩尔消光系数和感光速度均有所提高,更适合于以高压汞灯为辐射光源的长波紫外固化;芳茂铁四氟硼酸盐可以引发环氧树脂、脂环族和脂肪族缩水甘油基环氧单分子,通过加热或使用有机过氧化物[如过氧化苯甲酰(BPO)]可明显提高环氧化合物的聚合速度.     

Physicochemical Properties and Composition of Lipids from Capsicum annuum Seeds

The mass of 1000Capsicum annuum(Solanaceae) seeds and their moisture, oil and ash contents were determined. The lipid composition and acid components were studied. Low-molecular-weight fatty acids, concentrated in the ester fraction, were detected     

Lipids of Helianthus tuberosus

The content and composition of lipids, pigments, and fatty acids in leaves, stems, and tubers ofHelianthus tuberosuswere established. The studied organs of this plant have identical qualitative compositions of lipids but differ in content of some components     

TMPTA红外激光光聚合的实时动力学研究

采用实时FTIR研究了在红外激光照射下,阳离子菁染料-有机硼络合物1,3,3,1',3',3'-六甲基-11-氯-10,12-亚丙基吲哚三碳菁-正丁基三苯基硼引发的三羟甲基丙烷三丙烯酸酯(TMPTA)的光聚合反应动力学.研究发现,随激光功率的提高,单体的聚合速度与双键转化率均有显著提高.在临界浓度以下,引发剂的含量增加可以加快光聚合反应速率.样品厚度的增加明显降低双键转化率与聚合速度.计算结果表明,该体系的量子聚合效率为41.8mol/einstein.在17.0mW/cm²激光照射下TMPTA最高双键转化率可以达到80%.     

Miscibility of an acylated hepatitis A synthetic antigen derivative [palmitoyl VP3(110-121)] with lipids: a monolayer study

Mixed monolayers of an acylated derivative of hepatitis A synthetic peptide VP3(110-121) with neutral, cationic or anionic lipids were spread at the air/water interface. Deviations from ideality as well as thermodynamic values were calculated at different surface pressures using the free-excess energy, the interaction parameter and the enthalpy. The miscibility at the collapse point was also checked. Maximum deviations from ideality were found for mixtures containing the anionic lipid phosphatidylglycerol (PG), and it seems that the monolayer composition is not stable through compression, as the peptide is ejected from the film. Films containing neutral [dipalmitoylphosphatidylcholine (DPPC)] or cationic [stearylamine (SA)] lipids showed more regular behaviour. As the peptide has a net negative charge it is probable that electrostatic interactions are in part responsible of the good miscibility of palmitoyl VP3(110-121) with SA. In order to prepare liposomes containing palmitoyl VP3(110–121), lipids such as SA or DPPC/SA will be a more suitable choice than anionic lipids such as PG. Received: 26 May 2000 Accepted: 22 September 2000     

Adsorption of polymeric additives and their effect on the deposition of wood materials in paper production

The objective of this study is to understand how adsorbed synthetic polymers affect deposition kinetics of dissolved and colloidal wood materials. The synthetic polymers were characterised by means of static and dynamic light scattering, and their adsorption on silica was studied by means of optical reflectometry. Deposition kinetics of colloidal wood resin, compounds in model process water, as well as adsorption of anionic carbohydrates was then studied on the surface layers formed by synthetic polymers. It was found that neither wood resin nor anionic carbohydrates have affinity for adsorbed polyethylene oxide. However, wood resin deposited readily on adsorbed cationic polyacryl amides. Both polyethylene oxide and cationic polyacryl amides formed multilayers with compounds in the model process water.