Simultaneous determination of cloramphenicol, salicylic acid and resorcinol by capillary zone electrophoresis and its application to pharmaceutical dosage forms

This study demonstrates the separation of active ingredients in acne formulations (salicylic acid, cloramphenicol and resorcinol in presence of azulene) by capillary zone electrophoresis. Factors affecting their separations were the buffer pH and concentration, applied voltage, sample preparation, and presence of additives. Optimun results were obtained with a 50 mM sodium tetraborate-50 mM sodium phosphate, pH 9.0. The carrier electrolyte gave baseline separation with good resolution, short migration times (<6 min), great reproducibility and accuracy. Calibration plots were linear over at least three orders of magnitude of analyte concentrations, the lower limits of detection being within the range 0.39-1.25 μg ml⁻¹. The procedure was fast and reliable and commercial pharmaceuticals could be analysed without prior sample clean-up procedure.     

Cyclo[(6-amino-6-deoxy-d-galactonic acid)4]: a new class of carbopeptoid-cyclodextrin

The formation of the 28-membered ring cyclo[(6-amino-6-deoxy-d-galactonic acid)₄] by cyclisation of a protected open chain fully hydroxylated nylon 6 linear tetramer in modest yield provides the first example of a new class of carbopeptoid-cyclodextrin.     

Inhibitors of biotin biosynthesis as potential herbicides

Isosteric derivatives and analogues of the 7-keto-8-aminopelargonic acid (KAPA), 7,8-diaminopelargonic acid (DAPA) and desthiobiotin (DTB) vitamer intermediates involved in the biosynthetic pathway of biotin were prepared and evaluated as potential herbicides. The most active compound was desmethyl-KAPA which displayed a GR₅₀ (concentration of the active compound that causes a 50% growth inhibition) value of 8 ppm, where values <50 ppm are considered herbicidal. Other KAPA analogs where the terminal Me group was replaced by bulkier substituents such as Et, i-Pr and HOCH₂ showed moderate activity.     

Alkylation and acylation of basic salts of anthranilic acid

The O-nucleophilicity of basic anthranilic acid salts was documented, analyzed, and utilized in synthesis. Specifically substitutions leading to esters instead of secondary amines, and formation of anthranilic acid anhydrides were studied.     

Effect of External Acidity of Mordenite-Supported Catalysts on the 2,2-Dimethylbutane Content in Hydroisomerization Products of n-Hexane

We have used potentiometric titration with tetrabutylammonium hydroxide to determine the acid center content on the outer surface of dealuminated natural and synthetic mordenites. We have established a symbatic relationship between the 2,2-dimethylbutane content in the hydroisomerization products of n-hexane on dealuminated palladium-containing mordenites and the number of their external acid centers. We have studied the possibility of partial deactivation of such centers during ion-exchange deposition of palladium on the catalysts, using a tetraammine palladium solution.     

固定化单宁对酒类营养成分的吸附性能研究

采用固定化单宁对酒中可能存在的营养成分蛋白质、氨基酸、糖类、有机酸、乙醇和铁离子等进行吸咐试验。结果表明：固定化单宁对不同营养成分的吸附率差别明显，它通过氢键和疏水作用对蛋白质有较大的吸附率，通过多个酚羟基与中心铁离子形成螯合物而对其有较大的吸附率，对氨基酸、糖、有机酸和乙醇等营养成分或风味物质吸附率不大，固定化单宁可以作为一种较为理想的酒类处理剂。     

Structural characterization of nanopatterned surfaces

In this work, chemically and topographically nanopatterned surfaces were produced by a top-down processing approach for biosensing devices. The nanopatterning was the result of the combination of plasma polymerisation (pp) of biofunctional materials and colloidal lithography techniques. The morphological and chemical properties induced by the plasma deposition-etching treatment were characterised by optical method combining ellipsometry and Fourier Transform Infrared spectroscopy studies. This method supported by atomic force microscopy measurements, allowed the full optical characterization of each step of the top-down process. The optical characterization of the end-up nanopatterned samples demonstrated that the chosen process is able to produce well-defined nanostructured surfaces with controlled chemical and morphological properties.     

五种氨基酸钆络合物的ESR波谱

迄今未见任何稀土氨基酸络合物的ESR波谱报道,本文在合成Gd³⁺分别与甘氨酸、β-丙氨酸、谷氨酸、天冬氨酸和天冬酰胺五种氨基酸络合物的基础上,测定了不同温度下,水溶液、粉末及分子筛吸附样品的ESR谱,讨论了络合物中晶体场强,对称性及成键特性。     

In vitro screening of the action of non-steroidal anti-inflammatory drugs on hypochlorous acid-induced hyaluronan degradation

The antioxidative effect of two non-steroidal anti-inflammatory drugs was studied in vitro by measuring the kinetics of degradation of high-molecular weight hyaluronan (HA) in a system comprising hypochlorous acid + CuCl₂ + ascorbic acid using a Brookfield rotational viscometer equipped with a Teflon cup and spindle of coaxial cylindrical geometry. The changes in HA chemical structure were investigated by chemiluminometry. When sodium naproxen was added to the system during a running degradative process its inhibitory effect was clearly shown. The inhibition was dependent on the drug concentration. However, when this drug was added to the system before the initiation of HA degradation, no inhibition was seen even at the highest drug concentration tested. The inhibitory effect of acetylsalicylic acid was achieved with a relatively low concentration of the drug and was independent of the experimental model used.     

Synthesis of aromatic poly(thioether ketone)

Aromatic poly(thioether ketone)s were prepared by the direct polycondensation of aromatic dicarboxylic acids with aryl compounds containing ether or sulfide structures using phosphorus pentoxide/methanesulfonic acid (PPMA) as a condensing agent and solvent. Polycondensation proceeded smoothly and produced aromatic poly(thioether ketone)s with inherent viscosities up to 0.73 dL/g. The synthesis of substituted aryl ketones by the reaction of substituted benzoic acids with aryl compounds in PMMA was studied in detail to demonstrate the feasibility of the reaction for polymer formation. The thermogravimetry of the aromatic poly(thioether ketone)s showed a 10% weight loss in air and nitrogen at around 450 and 460°C, respectively. © 1992 John Wiley & Sons, Inc.