Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

SPS法研究ZnTPP对TiO_2的光谱敏化

本文利用表面光电压谱(Surface Photovohage spectroscopy,简称SPS)研究了ZnTPP对TiO_2粉末的光谱敏化,发现用ZnTPP修饰后的TiO_2(金红石和锐钛矿)粉末在可见区420、550和590nm附近有三个光伏响应带,它们分别对应于ZnTPP的Soret、Q(1,0)和Q(0,0)带。经过严格的实验和分析,证明这三个带是由ZnTPP对TiO_2的敏化光电压引起的,而不是ZnTPP自身的光伏响应。在敏化效果上,亚稳的锐钛矿优于金红石。同时,我们对这种光敏表面的光诱导电荷转移机制和SPS作为一种研究光谱敏化方法的可行性进行了讨论。     

钯II催化CO/乙烯共聚加压原位红外光谱研究

聚酿以其优良的物理、化学性能及原料（CO乙烯）简单易得的优点，在世界范围内已引起人们的普遍关注．为寻找价廉的催化剂或改良高效或（11）一双磷催化剂以推动聚酮的工业化进程，必须对共聚机理进行深入的研究．S；，n［’，’1、DrentP］等人根据对产品主链和端基的分析首先     

炭黑填充聚乙烯材料电阻—温度特性研究

研究了炭黑／聚乙烯导电复合材料的ＰＴＣ特性及在不同条件下的电阻变化。发现ＰＴＣ特性与体积膨胀及聚乙烯晶相的熔融有许多一致性。认为材料的体积膨胀及聚乙烯晶相熔融时炭黑颗粒均匀化扩散导致了电阻随温度上升。在较高温度下，炭黑颗粒在分子链段热运动的推动下会发生相对聚集使电阻不断减小，这是材料出现ＮＴＣ现象的原因。材料总的电阻温度特性是体积膨胀、炭黑向聚乙烯熔融区扩散及相互聚集三个因素共同作用的结果。     

Immobilization of thiabendazole-specific monoclonal antibodies to silicon substrates via aqueous silanization

Monoclonal antibodies specific for thiabendazole were immobilized to silicon, silicon dioxide, stoichiometric silicon nitride, and silicon-rich silicon nitride surfaces. This work provides the foundation for the development of a homogeneous sensor system for rapid detection and quantification of thiabendazole residues in produce and animal tissue. Immobilization was performed via aqueous silanization of the substrate followed sequentially by treatment with glutaraldehyde and contact with antibody solution in the presence of detergent. Surfaces were challenged with thiabendazole-horseradish peroxidase conjugate in an ELISA format to estimate immobilized antibody load. A stable and reproducible surface loading of 2 x 10¹¹ antibodies/cm² was obtained only after surfaces received postimmobilization treatments to remove nonspecifically adsorbed antibody. No difference in surface loading was noted when using 30% hydrogen peroxide rather than nitric acid for silanol activation. Little difference was noted among the antibody loadings achieved on the various silicon substrates. Bound antigen-enzyme conjugate was eluted with 0.1N acetic acid and reproducible surface activity was measured for up to four consecutive antigen challenges. Immobilized antibody surfaces were stabilized with 2% sucrose, dehydrated at 37‡C and stored in vacuum or stored at 4‡C in phosphate buffered saline containing 0.01% sodium azide without significant loss of activity.     

石英晶体微天平技术研究纳米TiO_2表面Cu(Ⅱ)吸附与光化学还原过程

环境中排放的重金属离子Cu!对水生和陆生生物有强的毒害性。饮用水中Cu!的浓度高于1.0mg·L-1时,将会导致人畜得血色沉着病和胃肠粘膜病[1]。Cu!无法进行生物降解,除去废水中Cu!的常见方法有离子交换、置换、化学沉淀等[2],然而这些方法需要消耗大量的化学试剂,成本高。近来,研     

二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

二氧化碳多相催化加氢的新进展

就近年来关于ＣＯ２活化、几个重要的ＣＯ２多相催化加氢反应及廉价氢的供给的研究进展进行综述。参考文献３４篇。