镀金和碳纳米管修饰金电极上吸附态葡萄糖氧化酶比活性的EQCM研究

采用石英晶体微天平(EQCM)技术监测了裸金电极、镀金和碳纳米管修饰金电极上葡萄糖氧化酶(GOD)的吸附过程. 通过EQCM测量吸附固定的GOD质量, 并实时检测酶反应产物H2O2的氧化电量, 求算了各表面上吸附态GOD的比活性(ESAi). 结果表明, 各表面上均可吸附一定的GOD, 且吸附态GOD均有一定的酶活性; 修饰CNTs可增大酶吸附量和酶电极对葡萄糖的响应电流, 但ESAi随CNTs修饰量的增大而降低; Au电极上电镀金后, 酶吸附量和酶电极对葡萄糖的响应电流亦增大, 但ESAi与裸金电极上的基本一致.     

Modification of carbon ceramic electrode prepared with sol-gel technique by a thin film of chlorogenic acid: application to amperometric detection of NADH

The carbon ceramic electrode prepared with sol-gel technique is modified by a thin film of chlorogenic acid (CGA). By immersing the carbon ceramic electrode in aqueous solution of chlorogenic acid at less than 2 s a thin film of chlorogenic acid adsorbed strongly and irreversibly on the surface of electrode. The cyclic voltammetry of the resulting modified CCE prepared at optimum conditions shows a well-defined stable reversible redox couple due to hydroquinone/quinone system in both acidic and basic solutions. The modified electrode showed excellent electrocatalytic activity toward NADH oxidation and it also showed a high analytical performance for amperometric detection of NADH. The catalytic rate constant of the modified carbon ceramic electrode for the oxidation of NADH is determined by cyclic voltammetry measurement. Under the optimised conditions the calibration curve is linear in the concentration range 1-120 μm. The detection limit (S/N = 3) and sensitivity are 0.2 μM and 25 nA μM⁻¹.The results of six successive measurement-regeneration cycles show relative standard deviations of 2.5% for electrolyte solution containing 1 mM NADH, indicating that the electrode renewal gives a good reproducible and antifouling surface. The advantages of this amperometric detector are: high sensitivity, excellent catalytic activity, short response time t < 2 s, remarkable long-term stability, simplicity of preparation at short time and good reproducibility.     

Influence of acid treatments of carbon nanotube precursors on Ni/CNT in the synthesis of carbon nanotubes

The Ni/CNT catalyst was fabricated by directly dipping carbon nanotube precursors refluxed in 4 M of nitric acid into Ni electroless plating bath, and used to synthesize new carbon nanotubes. The experimental results indicate that the duration of acid-treatment of carbon nanotubes precursors exerts a great influence on the catalysis of Ni/CNT in the synthesis of carbon nanotubes and hence the structures of the new carbon nanotubes. When the carbon nanotubes precursors were refluxed for 0.5 h in 4 M of nitric acid, bamboo-shaped carbon nanotubes (BSCNT) or Y junction carbon nanotubes in the carbon products were obtained. As the duration of acid-treatment of carbon nanotubes precursors increased to 6 h, the as-prepared Ni/CNT displayed higher activity, and the carbon nanotube products were high pure without any Y junction structure or any separation layers in hollow.     

Electrosorption of hydrogen into palladium-gold alloys

Hydrogen electrosorption into Pd-Au alloys has been studied in acidic solutions (1 M H₂SO₄) using cyclic voltammetry. Pd-Au electrodes with limited volume were prepared by electrochemical co-deposition. It was found that the maximum H/(Pd+Au) ratios decrease monotonically with increasing gold content and reach zero at ca. 70 at% Au. Similarly to the case of Pd limited volume electrodes, two peaks in the hydrogen region, corresponding to two types of sorbed hydrogen, are observed on voltammograms for Pd-rich alloys. The hydrogen capacity, H/(Pd+Au), measured electrochemically, depends on the sweep rate in the cyclic voltammetry experiments, which suggests that two different mechanisms for hydrogen desorption from the Pd-Au alloy are possible. After a strong decrease of Pd concentration at the electrode surface, caused by long cyclic polarization to sufficiently anodic potentials, the amount of absorbed hydrogen is still significant for alloys initially rich in Pd. The results obtained from CO adsorption experiments suggest that only Pd atoms are active in the hydrogen absorption/desorption process. Electronic Publication     

Liquid chromatography of carbon clusters

Summary A comparison of three binary mobile phases in LC separation of C₆₀ and C₇₀ fullerences on chemically bonded 2,4-dinitroanilinopropyl (DNAP) stationary phase was carried out, n-Hexane-benzene has been found to be the best mobile phase for efficient separation of the all-carbon molecules permitting high loads in preparative LC.     

碳纳米管/ZnO纳米复合体的制备和表征

通过将不同直径的ZnO纳米颗粒与碳纳米管连接制备了碳纳米管/ZnO纳米复合体. 将团聚的ZnO纳米颗粒分散并用表面活性剂CTAB使纳米颗粒带正电. 化学氧化碳纳米管使其带负电. ZnO/CTAB微团通过碳管表面羧基与CTAB的静电作用与碳纳米管连接形成纳米复合体. 研究了复合体形成的不同实验条件, 表征了碳纳米管/ZnO纳米复合体的结构并研究了纳米复合体的光学特性. 研究表明, 与碳纳米管连接的ZnO纳米颗粒是互不连接的并保持量子点的特性. 光致发光研究表明ZnO纳米颗粒的激发在纳米复合体中有淬灭.     

Production ofL-glutamate oxidase andin situ monitoring of oxygen uptake in solid state fermentation ofstreptomyces sp. Nl

Effects of water content and carbon and nitrogen sources on the production ofL-glutamate oxidase (GOD) by solid state fermentation (SSF) ofStreptomyces sp. N₁ were investigated in a 250-mL shake flask. The results show that in the solid medium containing wheat bran 98% (w/w), KCl 0.2% (w/w), and MgCl₂ 0.2% (w/w), addition of 2.0-mL water per gram solid medium and 0.4% (w/w) (NH₄)₂SO₄ was the best for GOD production. In this work, we also developed a simple technique forin situ measuring oxygen uptake rate (OUR) and carbon dioxide evolution rate (CER) in SSF in a shake flask based on the principle of Warburg manometer. The method was successfully applied to determine OUR and CER values in SSF ofStreptomyces sp. N₁. The results indicate that the largest OUR value was detected about one or two days ahead of the highest GOD activity reached depending on the fermentation conditions, and the OUR may be used as anin situ indicator of GOD production in the SSF process.     

Effect of surface treatment on the Hamaker constant of intermediate modulus carbon fibers

The Hamaker constant of unsized intermediate modulus carbon fibers was evaluated by contact angle measurement following the Fowkes theory of interfacial energetics. The effects of a surface treatment (performed by the manufacturer) and an oxygen plasma treatment (performed by us), both of oxidizing nature, proved to slightly increase the value of the Hamaker constant to a level that enhanced by about 9% the Lifshitz-van der Waals contribution to the theoretical adhesion force between the fiber and an epoxy matrix. A possible explanation of the observed increase of the Hamaker constant is the higher contribution to the overall Lifshitz-van der Waals interaction of Keesom (orientation) and Debye (induction) forces.     

载氧化钌碳纳米管超级电容器电极

研究了一种采用溶胶-凝胶方法制备超细氧化钌粉末的新方法，该方法制备的氧化钌电极材料在250 ℃热处理后具有570 F•g－1的比电容量并具有典型的多孔特征.通过在碳纳米管表面化学沉积氧化钌的方法制备了不同成分的氧化钌/碳纳米管复合电极,并探讨了其电化学伏安特性和直流充放电特性.该复合电极具有高能量密度特性，同时还具有良好的高功率放电特性.     

二氧化碳在高分子合成中的应用

综述了ＣＯ２在高分子合成中的研究现状，介绍了以ＣＯ２为原料合成高分子的经典方法和新型等离子体聚合法，在此基础上对ＣＯ２在高分子材料领域中的应用作了展望。