Highly sensitive determination of haloperidol in human serum by capillary gas chromatography using a surface ionization detector

A method has been developed for highly sensitive determination of haloperidol in human serum involving a simple extraction procedure followed by gas chromatographic separation. Target components were separated from the extracting solvents with a Van den Berg type solventless sample injector before introduction Into a DB-1 capillary separation column. A surface ionization detector (SID), which has highly selective sensitivity for Substituted amines, was employed for quantitation using bromperidol as an internal standard. Chloroform proved to be the best extracting solvent, yielding a quantitative detection limit of 5 ng/ml (S/N = 2). Comparison of the response to target compounds obtained by the SID, FTD (flame thermionic detector), and FID (flame ionization detector) showed the SID to be superior.     

Light-emitting diode-induced fluorescence detection of native proteins in capillary electrophoresis

A continuous-wave 280 nm light-emitting diode (LED) was used as the excitation source for native fluorescence detection of proteins in CE. The operating current and temperature of the LED were optimized in order to achieve high luminescence power. It was found that a forward current of 30 mA and a temperature of approximately 5 degrees C gave the best S/N. By using a set of two ball lenses to focus light from the LED, we achieved a spot of approximately 200 mum with a power of 0.1-0.2 mW on the detection window. Fluorescence was collected with a ball lens at 90 degrees angle through a bandpass filter onto a photomultiplier tube. In CZE an LOD of 20 nM for conalbumin was reached. In capillary gel electrophoresis all eight proteins from a commercial standard kit were detected with high S/N. For a 10 microg/mL total protein mixture, S/N was better than 3 for all proteins in solution. Further improvement in LOD should be possible on utilization of an LED with higher luminescence power.     

Contactless Conductivity Detection in Capillary Electrophoresis: A Review

The popularity of contactless conductivity detection in capillary electrophoresis has been growing steadily over the last few years. Improvements have been made in the design of the detector in order to facilitate its handling, to allow easy incorporation into available instruments or to achieve higher sensitivity. The understanding of its fundamental working principles has been advanced and the detection approach has also been transferred to lab‐on‐chip devices. The range of applications has been extended greatly from the initial work on small inorganic ions to include organic species and biomolecules. Concurrent determination of cations and anions by dual injection from opposite ends has been demonstrated as well as sample introduction by using flow‐injection systems for easy automation of the process.     

Capillary electrophoresis: An integrated system with a unique split-flow sample introduction mechanism

The performance of an integrated capillary electrophoresis system with a novel split-flow sample injection mechanism and special high sensitivity UV absorbance detector is described. Sample introduction into the capillary is accomplished with a standard HPLC-type microliter syringe. The injected sample is divided proportionally between the separation capillary and an adjustable splitvent. The volume of sample introduced into the capillary can be manipulated by varying the length or the i.d. of the splitvent tubing; or the volume of sample injected. Data are presented showing reproducibility of retention time, peak height, and peak area; minimum detectability; and operation at short UV wavelengths.     

Effect of film thickness and supercooling on the performance of cholesteryl cinnamate liquid crystal capillary columns

Improved separations of the isomers of olefinic aliphatic insect pheromones were obtained on cholesteryl cinnamate glass capillary columns by operating in the supercooled temperature range of the liquid crystal. Capillary columns were prepared with varying film thickness of the stationary phase; choice of the correct film thickness ensured optimum retention for a wide range of compounds within the most effective temperature range of the liquid crystal. The deactivation procedures described made the liquid crystal columns suitable for separation of the geometric isomers of polar and nonpolar compounds.     

Capillary electrophoresis with end-column amperometric detection of urinary 8-hydroxy-2'-deoxyguanosine

Urinary 8-hydroxy-2'-deoxyguanosine (8OHdG) is an excellent marker of oxidative DNA damage. Until now, urinary 8OHdG has been measured by high-performance liquid chromatography with electrochemical detection. A simple and sensitive method for the analysis of urinary 8OHdG by capillary electrophoresis with end-column amperometric detection has been developed in our laboratory. A single-step solid-phase extraction procedure was optimized and used for extracting 8OHdG from human urine. To improve the sensitivity of this method, a new focusing technique based on a dynamic pH junction was used. The limit of detection was 20 nM (signal-to-noise ratio S/N = 3), the linear range was 50 nM-10 microM, and the correlation coefficient was better than 0.999. The relative standard deviation (RSD) was found to be 0.57% for migration time, and 4.79% for peak current. To show the usefulness of the method, the urinary concentration of 8OHdG in nine healthy persons and ten cancer patients was determined. The urinary concentration of 8OHdG in cancer patients was significantly higher than that in healthy persons.     

Quantitative measurement of collagen methylation by capillary electrophoresis

Collagen methylation has been exploited in various applications involving living cells. We have observed correlation between the collagen methylation with the rate of cell proliferation in three-dimensional (3-D) microenvironment. To quantify the degree of collagen methylation, we have developed a capillary zone electrophoresis method. Using a polyvinyl alcohol-coated fused-silica capillary and UV detection at 200 nm, we have optimized pH and separated the native collagen into three major bands in phosphate buffer (50 mM, pH 2.5) with 0.05% hydroxypropylmethylcellulose. Under these conditions, the methylated collagens were separated into four major bands, which changed with different methylation reaction conditions. We propose an index to quantify the degree of collagen methylation that also correlates with their effects on cell proliferation.     

Application of an integrated microchip system with capillary array electrophoresis to optimization of enzymatic reactions

In this work, a combination of complementary metal-oxide semiconductor (CMOS) microchip system with capillary array electrophoresis (CAE) is demonstrated as a system for optimizing conditions for enzymatic reaction. Dimethylacridinone (DDAO)-phosphate substrate and alkaline phosphatase conjugate were selected for the enzymatic reaction, which was applicable to the enzyme-linked immunosorbent assay (ELISA) technique. Laser-induced fluorometry with a miniature semiconductor laser was used to detect the enzymatic products. The speed of the enzymatic reaction between the DDAO-phosphate and the alkaline phosphatase conjugate was investigated as a function of reaction time. The microchip-CAE detection system could determine the pH condition and the concentration of enzyme that are suitable for rapid and low-cost analysis. This result shows the feasibility of using the microchip-CAE system for application to miniaturized screening systems.     

使用二元环糊精体系毛细管电泳法分离手性药物

采用高效毛细管区带电泳法，分别以羟丙基-β-环糊精（HP-β-CD）和高磺化-β-环糊精（HS-β-CD）及二者混合物为手性选择剂，研究了5种药物的对映体分离，并取得很好的对映体分离结果。比较了HP-β-CD和HS-β-CD手性识别能力，分析了二元环糊精体系的“协同效应”。     

不依赖于统计模型的手性毛细管电泳分离多指标同时优化

考虑到手性毛细管电泳分离机理的复杂性，提出了不依赖于统计模型的二进制编码遗传算法多目标优化策略。根据实验参数的多少及其重要性，采用均匀设计安排完成初步实验。并用Derringer功效函数作为多指标同时优化的评价指标，以取得较高的分离度和较快分离速度；通过对实验参数给予编码，转化为二进制字符串，根据得到的总功效函数值大小进行遗传算法操作，产生新的一组实验条件。重复上述过程直到得到最佳分离条件为止。此方法成功地应用于华法令对映体的毛细管电泳分离条件优化。