Application of the microwave acid digestion method to the decomposition of rock samples

The microwave acid digestion method was applied to the decomposition of rock samples and optimum conditions were investigated. Samples of 10–100 mg were decomposed by changing the amount and composition of acid, heating time and number of reheating steps and then the concentrations of Si, Fe, Mn, Na, K and Mg in these samples were measured. The concentrations agreed with reported values when 10 mg of sample were decomposed by heating for 60 s with 0.3 ml of concentrated HNO₃ and 0.1 ml of concentrated HF. Similarly, 100 mg of sample were also decomposed successfully by heating for 45–110 s with 0.3–1.0 ml of concentrated HNO₃ and 0.4–0.7 ml of concentrated HF. It is concluded that the microwave acid digestion method decomposes rock samples with a very short heating time and with small amount of reagents compared with methods using conventional sealed PTFE vessels, which require several hours for the heating step and several millilitres of reagents.     

Optimization of selenium determination in plant samples by hydride generation and axial view inductively coupled plasma atomic emission spectrometry

The use of hydride generation coupled with axial view inductively couple plasma atomic emission spectrometry was presented for the determination of selenium in plant samples. The chemical factors affecting potentially the hydride generation efficiency (hydrochloric acid, sodium borohydride and sodium hydroxide concentrations) were assessed through investigation of chemical interference, accuracy and repeatability. The accuracy of measurements was not affected by elements present in high concentration in the plant matrix (K, Ca, Mg, and P). No interference was also observed with transition metals. Using a real sample (maize) with standard additions, decreases of recoveries were sometimes observed for 0.1% (m/v) NaOH, and attained 13.8% in the most unfavourable case. The final accuracy of the method was verified by using two certified reference materials: CRM 402 (white clover) and CRM 279 (sea lettuce). No statistically significant differences were obtained between the measured concentrations and the certified values. The optimized method was found sensitive (detection limit 0.15 μg l⁻¹), reliable and repeatable (R.S.D. between 1.3% and 4.0%).     

Trace analysis of volatile polar organics by direct aqueous injection gas chromatography

Summary Procedures for the quantitative analysis of industrial effluents which involve concentration by solvent extraction or the purge-and-trap method are time-consuming, labor-intensive, and prone to error. Direct aqueous injection gas chromatography using an electron-capture detector for the analysis of volatile halocarbons at the ppb level is in routine use in many laboratories. We now discuss the development of a similar protocol for the analysis of volatile polar organics such as acetone, methyl ethyl ketone, methyl isobutyl ketone, and tretrahydrofuran using a flame-ionization detector.     

Determination of Polyvinyl Alcohol Using Gel Filtration Liquid Chromatography

Gel filtration chromatography using a TSKgel G2000 SW column coupled with differential refractive index detection was used to analyse five grades of polyvinyl alcohol. Limits of detection and quantification for the assay were 0.14 mg mL^–1, 0.47 mg mL^–1 respectively. The inter and intra-day co-efficient of variance were both <7%. There was a significant difference (p<0.05, n=5) between the calibration curves across the five grades of PVA due to a refractive index range of 13.0790 –1.3181 (n=3). The assay accuracy was 98.99% ± 8.97% (n=5) and 90.60% ± 7.87% (n=5) of a spiked PVA sample was recovered from a commercial formulation.     

Thermal transitions and fat droplet stability in ice-cream mixmodel systems

We studied thermal transitions and physical stability of oil-in-water emulsions containing different milk fat compositions, arising from anhydrous milk fat alone (AMF) or in mixture (2:1 mass ratio) with a high melting temperature (AMF–HMT) or a low melting temperature (AMF–LMT) fraction. Changes in thermal transitions in bulk fat and emulsion samples were monitored by differential scanning calorimetry (DSC) under controlled cooling and reheating cycles performed between 50 and –45°C (5°C min^–1). Comparison between bulk fat samples and emulsions indicated similar values of melting completion temperature, whereas initial temperature of fat crystallization (T_onset) seemed to be differently affected by storage temperature depending on triacylglycerols (TAG) composition. After storage at 4°C, T_onset values were very similar for emulsified and non-emulsified AMF–HMT blend, whereas they were lower (by approx. 6°C) for emulsions containing AMF or mixture of AMF–LMT fraction. After storage at –30°C, T_onset values of re-crystallization were higher in emulsion samples than in bulk fat blends, whatever the TAG fat composition. Light scattering measurements and fluorescence microscopic observations indicated differences in fat droplet aggregation-coalescence under freeze-thaw procedure, depending on emulsion fat composition. It appeared that under quiescent freezing, emulsion containing AMF–LMT fraction was much less resistant to fat droplet aggregation-coalescence than emulsions containing AMF or AMF–HMT fraction. Our results indicated the role of fat droplet liquid-solid content on emulsion stability.     

Presence of nonylphenol, octyphenol and bisphenol a in two aquifers close to agricultural, industrial and urban areas

Active endocrine disruptors (nonylphenol, octylphenol and bisphenol A) were analysed in 2 aquifers and the corresponding surface waters. They are compounds widely used in industrial processes. The objective of this study was to determine the leaching potential of these compounds in groundwaters and to eventually correlate these levels with surface water samples. The areas sampled were agricultural, close to large cities and with an important industrial activity in the surrounding area. Samples (200 mL) were extracted using off-line SPE with polymeric OASIS 60 mg cartridges. Analyses were performed by gas chromatography-mass spectrometry (GC-MS) using selected ion monitoring (SIM) and full scan for quantification and unequivocal identification, respectively. This paper reports the detection limit for the compounds studied (from 0.001 to 0.030 μg L⁻¹), and method performance as regards to linearity (0.01–1.3 μg L⁻¹), reproducibility (less than 9%) and recovery (84 to 95%). The results from a monitoring program revealed the presence of the target compounds in all samples analysed, at levels of 0.07 and 1.9 μg L⁻¹. The presence of these compounds in groundwater was attributed basically to degradation of inert ingredients present in the formulation of many pesticides or to the increasing application of sludge in agricultural practice, although the infiltration of industrial run-off and wastewater disposal cannot be disregarded.     

Solid phase extraction and preconcentration of uranium(VI) and thorium(IV) on Duolite XAD761 prior to their inductively coupled plasma mass spectrometric determination

A simple and effective method is presented for the separation and preconcentration of thorium(IV) and uranium(VI) by solid phase extraction on Duolite XAD761 adsorption resin. Thorium(IV) and uranium(VI) 9-phenyl-3-fluorone chelates are formed and adsorbed onto the Duolite XAD761. Thorium(IV) and uranium(VI) are quantitatively eluted with 2 mol L⁻¹ HCl and determined by inductively coupled plasma-mass spectrometry (ICP-MS). The influences of analytical parameters including pH, amount of reagents, amount of Duolite XAD761 and sample volume, etc. were investigated on the recovery of analyte ions. The interference of a large number of anions and cations has been studied and the optimized conditions developed have been utilized for the trace determination of uranium and thorium. A preconcentration factor of 30 for uranium and thorium was achieved. The relative standard deviation (N = 10) was 2.3% for uranium and 4.5% for thorium ions for 10 replicate determinations in the solution containing 0.5 μg of uranium and thorium. The three sigma detection limits (N = 15) for thorium(IV) and uranium(VI) ions were found to be 4.5 and 6.3 ng L⁻¹, respectively. The developed solid phase extraction method was successively utilized for the determination of traces thorium(IV) and uranium(VI) in environmental samples by ICP-MS.     

Liquid chromatographic/electrospray mass spectrometric determination (LC/ESI-MS) of chelerythrine and dihydrochelerythrine in near-critical CO2 extracts from real and spiked plasma samples

Two polar benzo[c]phenanthridine alkaloids, chelerythrine (CHE) and dihydrochelerythrine (DHCHE), were extracted at 35 °C and 10 MPa (15 MPa for real samples) from real and spiked plasma samples with acceptable recoveries (95.1% and 81.0%, respectively) using near-critical CO₂ modified with aqueous (1:1, v/v) methanol. The alkaloids were quantified by a liquid chromatographic/electrospray mass spectrometric (LC/ESI-MS) method on a Zorbax SB-CN column (75 mm × 4.6 mm, 3.5 μm particle size) using methanol (organic phase) and 50 mM ammonium formiate (aqueous phase) as a mobile phase. A linear gradient 0-1 min, isocratic at 60% organic phase (v/v); from 1.0 to 7.0 min, 60-71% organic phase (v/v); from 7.0 to 18.0 min, 71-60% organic phase (v/v) was applied. The limit of detection was 1.22 ng (3.50 pmol) for CHE and 0.95 ng (2.72 pmol) for DHCHE per 1 ml of the sample. The linearity of the calibration curves was satisfactory as indicated by coefficients of determination 0.9979 and 0.9995 for CHE and DHCHE, respectively. Repeatability and intermediate precision (average R.S.D.s) were 1.0-1.5%, accuracy was in the range 99.7-100.3%. Average recovery was 100.1% for both, standard solutions and spiked plasma extracts. Three samples of real rat plasma were extracted and analysed to test the method.     

Determination of selenium in human milk by electrothermal atomic absorption spectrometry and chemical modification

A method was developed for the determination of selenium in human milk using electrothermal atomic absorption spectrometry. The use of chemical modifiers as well as their implications during the pyrolysis step was examined. The chemical modifiers that were studied were Zr, Ir as well as the mixed modifier Zr-Ir. The Ir modifier stabilized selenium at 1000 °C, Zr at 800 °C, while the mixed modifier at 1200 °C. The effect of modifier mass was studied and was found that better results are achieved with addition of 2 μg Zr and 2 μg Ir. The characteristic masses of selenium in the presence of Zr, Ir and the mixed modifier were found to be 73.3, 18.0 and 14.7 pg, respectively, while the corresponding limits of detection were found 2.0, 0.50 and 0.41 μg l⁻¹. Consequently better results were obtained with the mixed modifier. The developed method was applied for the determination of selenium in human milk, which was digested with a HNO₃ + H₂O₂ mixture in a microwave oven. The limit of detection of the method was 1.37 μg l⁻¹, the characteristic mass, m₀, was 48.8 pg and the repeatability was less than 5% as R.S.D.(%). Matrix matched calibration was used. Recoveries were estimated to be 93-105%. The method was applied to breast milk of Greek women (n = 9) and the Se content was found to be in the range 16.7-42.6 μg l⁻¹ with mean value 27.4 ± 5.5 μg l⁻¹.     

Nanometer-sized zirconium dioxide microcolumn separation/preconcentration of trace metals and their determination by ICP-OES in environmental and biological samples

A new method is proposed using a microcolumn (20 mm × 2.0 mm) packed with nanometer-sized zirconia as solid-phase extractor for the separation/preconcentration of Mn, Cu, Cr, Zn, Ni and Co prior to their determination by inductively coupled plasma optical emission spectrometer (ICP-OES) in environmental samples. The factors affecting the separation and preconcentration of analytes such as pH, sample flow rate and volume, eluent concentration and volume were determined, interfering ions were studied, and the optimal experimental conditions were established. The adsorption capacity of nanometer-sized ZrO₂ for Mn, Cu, Cr, Zn, Ni and Co was found to be 1.3, 1.3, 1.7, 2.0, 3.9 and 1.5 mg g⁻¹, respectively. The detection limits of the method were 12, 58, 24, 2, 7 and 36 ng L⁻¹, respectively, with a preconcentration factor of 25. The precision of this method was 1.7% (Mn), 2.9% (Cu), 5.9% (Mn), 3.8% (Mn), 6.2% (Mn) and 4.3% (Mn) with 9 determinations of 10 ng mL⁻¹ of target analytes, respectively. The method was successfully applied to the determination of trace metals in lake water, dried fish samples, certified reference materials of human hair and milk, and provided satisfactory results.