PREPARATION OF PERFLUOROOCTANOYL-MODIFIED POLY(VINYL-ALCOHOL)S AND THEIR ADSORPTION AT AN AIR-WATER INTERFACE

Perfluorooctanoyl modified poly(vinyl alcohol)s (FPVA) were prepared by means of substituting a small amountof hydroxyl groups on the backbone of poly(vinyl alcohol), for which the initial degree of polymerization is equal to 1750.The substitution extent, defined by the number of substituting units in a chain, for the four FPVA samples was in the range of0.5-5 perfluorooctanoyl groups per chain. The FPVA samples with the highest substitution extent still had good solubility inwater. It was shown by experimental measurement at 30.0±0.1℃ that the surface tension of the aqueous solution of thehighest substituted FPVA decreased to 16.6 mN/In at a higher concentration, e.g about 0.1 g/mL. Obviously,macromolecules of FPVA exhibit a very strong tendency to adsorb at the air-water interface, because the hydrophobicperfluorooctanoyl groups in FPVA have a very high surface activity as they are in small molecular fluorinated surfactants.The chain conformation of such a model polymer adsorbed on the air-water interface was also discussed.     

Conformation of poly(L-glutamic acid) in aqueous solutions of linear amphiphiles with a cationic group at both ends

The conformations of poly(l-glutamic acid) [P(Glu)] in solutions of the bipolar amphiphile 1,20-icosanediylbis(alkylammonium chloride) [C20(RA)₂], where RA includes trimethylammonium (TMA), dimethylammonium (DMA), or methylammonium (MA), were investigated with measurements of the circular dichroism spectra at 10–35 °C. All C20(RA)₂ induced an α-helix of P(Glu) in the aqueous solutions. The residue molar ellipticity at 222 nm showed a similar dependence on the amphiphile concentration (C _s) below 0.5 of the ratio of 2C _s to the residue concentration (C _p) of P(Glu), but it separated into three directions at 2C _s/C _p>0.5. C20(MA)₂ induced an α-helix of P(Glu) at 2C _s/C _p<0.5 followed by a helix aggregate at 2C _s/C _p>0.5. C20(DMA)₂ and C20(TMA)₂ also induced an α-helix, but a helix aggregate. C20(TMA)₂ indicated a strong temperature dependence and did not induce a complete α-helix at 35 °C. Received: 20 June 2001 Accepted: 6 September 2001     

Synthesis,characterization, and application of griseofulvin surface molecularly imprinted polymers as the selective solid phase extraction sorbent in rat plasma samples

In present study, an investigation was carried out to develop and validate an analytical method for the selective extraction and determination of griseofulvin (GSF) from plasma samples. For this purpose, a rational approach was made to synthesize and characterize the surface molecularly imprinted polymers (SMIPs). The SMIPs were utilized as solid phase extraction (SPE) sorbents. The SMIPs were prepared by using GSF as template molecule on the surface of modified silica particles through a non-covalent technique. The particles demonstrated high adsorption capacity (119.1 µg/mL), fast adsorption equilibrium time (30 min) and good recognition selectivity for the template drug. The scanning electron microscopy and infrared spectroscopy were used to explain the structural and morphological characteristics of the SMIPs and surface non-imprinted polymers. The SPE method was combined with HPLC for plasma analysis. The method validation results demonstrated that the established method possessed good linearity for GSF ranging from 0.1 to 50 µg/mL (R² = 0.997). The limit of detection for this method was 0.02 µg/mL for rat plasma samples. The recoveries of GSF from spiked plasma samples were (90.7–97.7%) and relative standard deviations were (0.9–4.5%). Moreover, the SMIPs as selective SPE sorbent can be reused more than 8 times which is a clear advantage over commercial SPE sorbents. Finally, the usefulness of the proposed strategy was assessed by extraction and detection of GSF in real rat plasma samples.     

掺溴聚-4-甲基-1-戊烯的合成研究

 液溴与聚-4-甲基-1-戊烯（PMP）的四氯化碳溶液反应，在光照条件下得到溴代PMP，通过红外与元素分析确证了其结构。并通过热重分析对其性能进行了初步的研究。研究发现，在光照条件下溴原子很容易与PMP中叔丁基上的氢原子发生取代反应，得到化学掺杂溴原子的聚合物。该聚合物在150℃以下比较稳定，在150℃以上就会失去HBr。采用此种方法，可得到掺杂均匀的低密度材料。     

两个含5-溴水杨酸钠(Ⅰ)/镉(Ⅱ)配合物的合成、晶体结构、Hirshfeld表面分析与抑菌活性

由 5-溴水杨酸(H₂BB A)合成了钠(Ⅰ)/镉(Ⅱ)配合物[Na(HBBA)]_n (1)和[Cd(HBBA)₂(4,4′-Bipy)]_n (2)(H₂BB A=5-溴水杨酸,4,4′-Bipy=4,4′-联吡啶)。通过元素分析、红外光谱、热重、粉末X射线衍射和单晶X射线衍射表征了其结构。配合物1的不对称单元中有1个钠离子和1个HBBA^-。钠离子是六配位的三棱柱构型,HBBA^-配体的3个氧原子分别与2个钠离子配位,连接相邻的钠离子形成了3条一维链结构,HBBA^-配体连接相邻的3条一维链形成了二维网络结构。分子间氢键连接相邻的二维网络结构形成了三维氢键网络结构。配合物2中有1个镉离子、2个HBBA^-和1个4,4′-Bipy。镉离子是六配位的扭曲八面体构型,4,4′-Bipy配体连接相邻的2个镉离子形成了一维链结构。分子间氢键连接相邻的一维链结构形成了三维氢键网络结构。通过Hirshfeld表面和指纹图分析了配合物晶体中的弱分子间作用力。详细研究了配合物1和2的热稳定性和抑菌活性。     

3-乙氧基-4-羟基苯乙醇酸在聚邻甲苯胺-Cu2+膜电极上的电氧化

采用循环伏安法制备了聚邻甲苯胺(POT)膜电极,再以浸泡吸附法在此膜中嵌入Cu2+,制成POT-Cu2+膜电极.研究了POT-Cu2+膜电极对3-乙氧基-4-羟基苯乙醇酸的电氧化行为,并讨论了影响电氧化活性的主要因素.结果表明,50℃下,在含有0.5mol.L-13-乙氧基-4-羟基苯乙醇酸的1.5mol.L-1氢氧化钠溶液中,POT-Cu2+膜电极具有高的电氧化活性和良好的稳定性.将该电极用于3-乙氧基-4-羟基苯乙醇酸电解氧化脱羧制备乙基香兰素,在0.55V(vsSCE)下恒电位电解1h,乙基香兰素的产率可达89%以上,电流效率达97%以上.     

含氨基酸单元Schiff碱的合成与表征

以谷氨酸为原料合成了四个新型的含糠醛或苯甲醛Schiff碱的氨基酸衍生物,并通过红外光谱、质谱和核磁共振氢谱对化合物的组成及结构进行了表征．     

阻抑动力学光度法测定蔬菜中的抗坏血酸

抗坏血酸(Vc)是人体内不可缺少的一种重要营养物质,参与机体内一系列代谢和反应。当摄入量不足时,会导致毛细血管脆性增加,引起代谢失调。由于该物质人体不能自身合成,只能从食物中摄取,因此研究食物中抗坏血酸的含量对人体健康有重要实际意义。测定抗坏血酸的方法主要有碘量法     

基于钴离子介导信号转换的抗坏血酸比色分析

抗坏血酸是许多生化过程所必需的一种生物小分子。借助于羟基氧化钴纳米片的氧化性和钴离子与硫氰酸根离子之间强的螯合作用,本文报道了一种基于钴离子介导信号转换的新方法用于抗坏血酸的比色分析。在抗坏血酸存在时,羟基氧化钴纳米片被还原降解产生二价钴离子,钴离子与硫氰酸根离子之间通过螯合作用生成蓝色的阴离子络合物[Co(NCS)₄]^2-,在625nm处产生可见吸收信号。在优化条件下,体系625nm处的吸收值与抗坏血酸浓度在0.03～0.45 mmol/L范围内呈良好的线性关系,线性方程为A₆₂₅=0.638c(mmol/L)+0.042,相关系数R=0.993,检测限(3S/N)为1.5μmol/L。     

绿色单体二氧化碳参与的新型聚合反应

二氧化碳(CO₂)是一种丰富、廉价、无毒以及可再生的一碳资源,也是一种可用于聚合的绿色单体.基于CO₂的聚合是近年来的研究热点之一.目前广泛报道的是CO₂和环氧单体的聚合反应,经过几十年的发展已经成功实现工业化生产.最近几年,一些CO₂参与的新型聚合反应被陆续报道,这些工作大都通过两种途径实现从CO₂到高分子材料的转变.第一个途径是先将CO₂转化为可以聚合的单体,例如:内酯、环状碳酸酯和2,5-二呋喃甲酸等,再利用开环或者逐步聚合将单体转化为聚合物;另一个途径是直接以CO₂为单体和其他类型单体共聚得到聚合物.这两种途径对于发展CO₂参与的新型聚合反应,拓展CO₂基聚合物种类都具有重要意义.本综述按照CO₂直接还是间接参与聚合反应分类总结了近年来在CO₂制备高分子材料方面的进展,并对未来发展方向进行了简单阐述.